Manuel d’utilisation Lochinvar EGS-I&S-01

12 pages 0.15 mb
Télécharger

Aller à la page of 12

Summary
  • Lochinvar EGS-I&S-01 - page 1

    EGS-I&S-01 1 SINGLE-W ALL INDIRECT WA TER HEA TER For your family’s comfort, safety, and convenience, we recommend this water heater be installed and serviced by a plumbing professional. T ABLE OF CONTENTS IMPORTANT INFORMATION .................................. 1 GENERAL INFORMATION ....................................... 3 PRE-INSTALLATION ...

  • Lochinvar EGS-I&S-01 - page 2

    EGS-I&S-01 2 W ARNING Installation is not complete unless a pressure and temperature relief valve is installed into the side of the water heater. See the Water Connections section of this manual for details. This water heater contains very hot water under high pressure. Do not unscrew any pipe fittings or attempt to disconnect any components of ...

  • Lochinvar EGS-I&S-01 - page 3

    EGS-I&S-01 3 TEMPERA TURE AND PRESSURE RELIEF V AL VE GENERAL INFORMA TION FEA TURES This water heater contains the following features: HEAT EXCHANGER — The heat exchanger (coil) has 1" NPT female fittings. These water heaters with single-wall heat exchangers meets the Uniform Plumbing Code for installation in all potable water systems p ...

  • Lochinvar EGS-I&S-01 - page 4

    EGS-I&S-01 4 NOTE: Any claims for damage or shortage in shipment must be filed immediately against the carrier by the consignee. IMPORT ANT DECISIONS REQUIRED BEFORE INST ALLA TION SIZING 1. Boiler DOE Heating Capacity – The Single-wall Indirect water heater will provide the rated performance only if used in conjunction with a boiler with a D ...

  • Lochinvar EGS-I&S-01 - page 5

    EGS-I&S-01 5 2. Non-Priority – Boiler output is divided between space heating and domestic hot water heating. Delivery of domestic hot water can be reduced during simultaneous space and domestic hot water heating operations, depending on such factors as boiler output, boiler over-sizing, number of space heating zones calling for heat, and the ...

  • Lochinvar EGS-I&S-01 - page 6

    EGS-I&S-01 6 INSTRUCTIONS FOR POT ABLE CONNECTIONS 1 . BEFORE PROCEEDING WITH THE INSTALLATION, CLOSE THE MAIN WATER SUPPLY VALVE. After shutting off the main water supply, open a faucet to relieve the water line pressure to prevent any water from leaking out of the pipes while making the water connections to the water heater. After the pressur ...

  • Lochinvar EGS-I&S-01 - page 7

    EGS-I&S-01 7 4. NEVER OPERATE THE WATER HEATER WITHOUT FIRST BEING CERTAIN THAT IT IS FILLED WITH WATER. INSTRUCTIONS FOR BOILER CONNECTIONS The Single-wall Indirect connection labeled “To Boiler Return” should be piped to the boiler return piping as close to the boiler as possible and especially after any flow control or check valves in th ...

  • Lochinvar EGS-I&S-01 - page 8

    EGS-I&S-01 8 FILL BOILER SYSTEM 1. On new boiler installations, do not purge the boiler or space heating system through the water heater. During any boiler or space heating system flushing, cleaning, or purging, the water heater should be isolated to avoid possible attack on the carbon steel coil by chemical additives. 2. Purge air from boiler/ ...

  • Lochinvar EGS-I&S-01 - page 9

    EGS-I&S-01 9 W ARNING SCALDING This water heater can deliver scalding temperature water at any faucet in the system. Be careful whenever using hot water to avoid scalding injury. By setting the aquastat on this water heater to obtain an increased water temperature, you may create the potential for scald injury. To protect against injury, you sh ...

  • Lochinvar EGS-I&S-01 - page 10

    EGS-I&S-01 10 CAUTION Before manually operating the valve, make sure that a drain line has been attached to the valve to direct the discharge to an open drain. Failure to take this precaution could mean contact with extremely hot water discharging from the valve during this checking operation. 3. After the water heater completes a heat-up cycle ...

  • Lochinvar EGS-I&S-01 - page 11

    EGS-I&S-01 11 b. Open the drain valve to flush any sediment out of the bottom to the heater. c. Shut off the cold water supply. Make sure all hot water fixtures and circulating pumps are turned off. d. Wait for water flow from the hose to stop. Remove the anode using a socket of the appropriate size. Do not use an impact wrench. e. Inspect and ...

  • Lochinvar EGS-I&S-01 - page 12

    EGS-I&S-01 12 TROUBLE SHOOTING GUIDE PROBLEM CAUSE SOLUTION Boiler does not operate Refer to boiler installation instructions Check main service switch Check fused disconnect Circulator does not operate Check power supply Replace as necessary Improper aquastat setting calibration Turn tank aquastat to appropriate or setting Zone valve does not ...

Fabricant Lochinvar Catégorie Water Heater

Les documents que nous recevons du fabricant de l'appareilLochinvar EGS-I&S-01 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Lochinvar
- manuels d’utilisations EGS-I&S-01
- fiches produit Lochinvar
- dépliants
- ou étiquettes-énergie Lochinvar EGS-I&S-01
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Lochinvar EGS-I&S-01.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Lochinvar EGS-I&S-01, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Lochinvar EGS-I&S-01. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Lochinvar EGS-I&S-01.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Lochinvar EGS-I&S-01, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Lochinvar EGS-I&S-01 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Lochinvar EGS-I&S-01.

Le manuel d’utilisation complet Lochinvar, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Lochinvar EGS-I&S-01 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Lochinvar EGS-I&S-01, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lLochinvar EGS-I&S-01 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Lochinvar EGS-I&S-01 - qui devraient nous aider dans les premières étapes lors de l'utilisation Lochinvar EGS-I&S-01
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Lochinvar EGS-I&S-01
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Lochinvar EGS-I&S-01 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Lochinvar EGS-I&S-01?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Lochinvar EGS-I&S-01, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Lochinvar EGS-I&S-01 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)