Manuel d’utilisation Planar PL2011

13 pages 0.63 mb
Télécharger

Aller à la page of 13

Summary
  • Planar PL2011 - page 1

    PL2011 LCD Monitor USER’S GUIDE www.planar.com ...

  • Planar PL2011 - page 2

    1 Table of Contents Table of Conten ts .............................................................................................................. .1 Preface ............................................................................................................................... 2 Chapter 1 Inst allation.................................... ...

  • Planar PL2011 - page 3

    2 Preface This manual is designed to assist users in setting up a nd using the PL2011M LCD Monitor. Infor mation in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this docum ent is subject to change without notice. This docum ent contains proprietary infor ...

  • Planar PL2011 - page 4

    3 Important Safety Instructions Please read the following instructions carefully. Th is m anual should be retained for future use. 1. To clean LCD Monitor screen: -- Power off LCD Monitor and unplug the AC Cor d. -- Spray a non-solvent cleaning solution onto a ra g. -- Gently clean the screen with dampened rag. 2. Do not place the LCD Monitor near ...

  • Planar PL2011 - page 5

    4 Chapter 1 Installation Unpacking Before unpacking the LCD Monitor, pr epare a suitable workspace for your Monitor and computer. You need a stable and clean surface near a wall power outlet. Ma ke sure that LCD Monitor has enough space around it for sufficient airflow. Though the LCD Monito r uses very little power, some ventilati on is needed to ...

  • Planar PL2011 - page 6

    5 Height Adjustment Stand To unlock the height adjustment f eature of the stand, locate the pin on the back of the stand column and turn the pin knob counter-clockwise. (See fig.1-1 ) Figure 1-1 Tilt, Swivel and Pivot Rotation The LCD Monitor is designed to have a tilt range of -5°to +25°, a swivel range of - 3 5°to +35° , and a 90° pivot rota ...

  • Planar PL2011 - page 7

    6 Optional Mounting Alternatives Warning: The monitor stand base may forcefully extend and cause injury. Raise the monitor to its "Full Up" position before removing the monitor stand. Detaching LCD Monitor from Its Stand Unscrew screws n the swivel base support column and pull down o the second. Figure 1-3 Interface for Arm Applications B ...

  • Planar PL2011 - page 8

    7 Chapter 2 Display Controls User Controls A brief description and the location of all LCD Monitor functions control and indicator: Figure 2-1 1 Stereo Speakers PC Audio Stereo output. 2 Speaker Volume Control Increase Volume - Turn the knob clock wise. Decrease Volume - Turn the knob counter clock wise. 3 Soft Power Sw itch Press the soft power sw ...

  • Planar PL2011 - page 9

    8 Function Description Ico n Function Function Description Brightness 101 scales of brightness are ava ilable to choose from (0 to 100). Contrast 101 scales of contrast are ava ilable to choose from (0 to 100). Horizontal Position This function adjusts the display's horizontal position Vertical Position This function adjusts the di splay' ...

  • Planar PL2011 - page 10

    9 Chapter 3 Technical Information Specifications LCD Panel PL2011M Size 20.1" Display Type Active matrix color TFT LCD Resolution 1600x1200 Display Dot 1600 x (RGB) x 1200 Display Area (mm) 408.0x306.0 (H x V) Display Color 16.7M Brightness 300 cd/m 2 (typical) / 240 cd/m 2 (minimum) Contrast Ratio 1000:1 (typical) Response Time Ta=25°C Tr+Tf ...

  • Planar PL2011 - page 11

    10 S y nc In p ut Signal Separate TTL compatible horizontal and vertical synchronization Digital TMDS Polarity Positive and negative Plug & Play Supports VESA DDC2B functions External Connection Power In p ut (AC input) Power cor d Video Cable 15- p in D-sub connecto r , 24- p in DVI-D Audio Cable Stereo Jac k Environment Operating Condition: T ...

  • Planar PL2011 - page 12

    11 Standard Timing Table If the selected timing is NOT included in table below, this LCD monitor will use the m ost suitable available timing. TIMING FH(KHZ) SYNC TOTAL ACTIVE SYNC FRONT BACK PIXEL FV(HZ) WIDTH PORCH PORCH POLARITY (DOT/ LINE) (DOT/ LINE) (DOT/LINE) (DOT/LINE) (DOT/LINE) FOREQ (MHZ) 640x350 31.469 + 800 640 96 16 48 25.175 VGA-350 ...

  • Planar PL2011 - page 13

    12 Troubleshooting This LCD Monitor has pre-adjusted usi ng factory standard VGA timings. Due to th e output tim ing differences among various VGA cards in the market, users m ay initially experience an unstable or unclear displa y whenever a new display mode or new VGA card is selected. Attention This LCD Monitor Supports Multiple VGA Modes. Refer ...

Fabricant Planar Catégorie Computer Monitor

Les documents que nous recevons du fabricant de l'appareilPlanar PL2011 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Planar
- manuels d’utilisations PL2011
- fiches produit Planar
- dépliants
- ou étiquettes-énergie Planar PL2011
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Planar PL2011.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Planar PL2011, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Planar PL2011. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Planar PL2011.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Planar PL2011, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Planar PL2011 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Planar PL2011.

Le manuel d’utilisation complet Planar, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Planar PL2011 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Planar PL2011, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lPlanar PL2011 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Planar PL2011 - qui devraient nous aider dans les premières étapes lors de l'utilisation Planar PL2011
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Planar PL2011
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Planar PL2011 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Planar PL2011?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Planar PL2011, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Planar PL2011 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)