Français dropdown-ico

Manuel d’utilisation Roland SA-1000

24 pages 3.03 mb
Télécharger

Aller à la page of 24

Summary
  • Roland SA-1000 - page 1

    IMPORTANT SAFETY INSTRUCTIONS ............................ 2 USING THE UNIT SAFELY ................................................ 3 IMPORTANT NOTES .......................................................... 5 Main Features .................................................................... 7 Names of Things and What They Do ..................... ...

  • Roland SA-1000 - page 2

    2 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION : RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to al ...

  • Roland SA-1000 - page 3

    3 USING THE UNIT SAFELY • Before using this unit, make sure to read the instructions below, and the Owner’s Manual. .......................................................................................................... • Connect mains plug of this model to a mains socket outlet with a protective earthing connection. ...................... ...

  • Roland SA-1000 - page 4

    4 • In households with small children, an adult should provide supervision until the child is capable of following all the rules essential for the safe operation of the unit. .......................................................................................................... • Protect the unit from strong impact. (Do not drop it!) ....... ...

  • Roland SA-1000 - page 5

    5 IMPORTANT NOTES In addition to the items listed under “IMPORTANT SAFETY INSTRUCTIONS” and “USING THE UNIT SAFELY” on pages 2 and 3, please read and observe the following: Power Supply • Do not connect this unit to same electrical outlet that is being used by an electrical appliance that is controlled by an inverter (such as a refrigerat ...

  • Roland SA-1000 - page 6

    6 IMPORTANT NOTES Maintenance • To clean the unit, use a dry, soft cloth; or one that is slightly dampened. Try to wipe the entire surface using an equal amount of strength, moving the cloth along with the grain of the wood. Rubbing too hard in the same area can damage the finish. • Never use benzine, thinners, alcohol or solvents of any kind, ...

  • Roland SA-1000 - page 7

    7 Main Features The SA-1000 is a combo amp that also functions as a 2.1-channel full stereo, lightweight, high-power stage amp. Easy setup Mixer, amp, and speakers are integrated in one unit, eliminating any need for complicated wiring. You can also connect a subwoofer unit with a single cable. Fully reproduces the powerful, low-frequency sounds of ...

  • Roland SA-1000 - page 8

    8 Names of Things and What They Do Control Panel fig.01-01 1. MIC Button When using the MIC IN input, press the MIC button. The ON indicator lights when MIC button is pressed. 2. REVERB Knob This adjusts the amount of reverb applied to the mic input. * Set the knob to "OFF" when the reverb is not being used. * The reverb scale markings ar ...

  • Roland SA-1000 - page 9

    9 Names of Things and What They Do 5. VOLUME Knob These adjust the volume of the devices connected to the KEYBOARD IN jacks. 6. VOLUME Knob This adjusts the volume of the device connected to the AUDIO IN jack. 7. ORGAN ENHANCE Button This switches the Organ Enhance effect on and off. When switched on, the organ’s low-frequency range will be empha ...

  • Roland SA-1000 - page 10

    10 Names of Things and What They Do Jack Panel fig.01-02 1. MIC IN Jack Connect a microphone here. For balanced input, you can connect to the TRS 1/4-inch phone jacks and XLR type connector. • This instrument is equipped with balanced (XLR/TRS) type jacks. Wiring diagrams for these jacks are shown below. Make connections after first checking the ...

  • Roland SA-1000 - page 11

    11 Names of Things and What They Do After connecting two SA-1000s together with one or two audio cables (1/4-inch phone type), you can easily play back high power sounds (350 W + 350 W) in stereo. 4. STEREO LINK IN Jack When using the Stereo Link function, input audio from the left channel SA-1000 here. You can also use this as an external input ja ...

  • Roland SA-1000 - page 12

    12 Making the Connections Refer to the figure shown below to connect the SA-1000 and the other equipment. fig.02-01 * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. * When connection cables with resistors are used, the volume level ...

  • Roland SA-1000 - page 13

    13 Making the Connections Switching the Power On and Off * Once the connections have been completed (p. 12), turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. 1. Make sure that all volume controls on the SA-1000 and connec ...

  • Roland SA-1000 - page 14

    14 Making the Connections About Setting the Volume To obtain the best sound from the SA-1000, set the volume level using the following procedure. fig.02-04 1. When using the MIC IN input, press the MIC button. 2. Adjust the MIC REVERB knob to achieve the desired sound. 3. Turn the VOLUME knob for each input to adjust the input volume levels. * If t ...

  • Roland SA-1000 - page 15

    15 About the Anti-Feedback Function Features of SA-1000 ANTI-FEEDBACK Many previous anti-feedback systems use methods of determining feedback that actually generate feedback in order to detect the feedback point, resulting in a system that is extremely unpleasant to use. On the other hand, the SA-1000 employs a newly developed method that does not ...

  • Roland SA-1000 - page 16

    16 About the Anti-Feedback Function How to Use Anti-Feedback Anti-feedback is enabled only for MIC input. When Using a Mic Stand Both the mic characteristics and the characteristics of the surrounding environment can be compensated for. 1. Set up and connect the SA-1000 and the mic. • Set up the SA-1000 and the mic in the positions they will be u ...

  • Roland SA-1000 - page 17

    17 About the Anti-Feedback Function When automatic measurement is not completed • If you press the AUTO button to start the calibration without a microphone connected or with the volume level turned down too low, SA-1000 outputs an error sound from the speaker and stops analysis. If this occurs, check your connections and settings. • If the sur ...

  • Roland SA-1000 - page 18

    18 About the Use of Stacks ● Stack so that the speaker side of both the top cabinet and the bottom cabinet face the same direction. fig.03-01 ● Adjust the horizontal position of the top cabinet so that the corner protectors are properly engaged and locked at all four corners between the top and bottom cabinets. Do not use the amplifiers without ...

  • Roland SA-1000 - page 19

    19 Block Diagram MASTER OUT L MASTER OUT R STEREO LINK IN STEREO LINK control volume control EQU ALIZER ORGAN ENHANCE AMBIENCE ANTI-FEEDBA CK REVERB MIC MIC KEYBO ARD 1 KEYBO ARD 2 A UDIO STEREO LINK L (MONO) L (MONO) R IN R L R SPEAKER SA-1000W R L PHONES L R OUT R MIC ON/OFF MIC V OLUME KEYBO ARD 1 V OLUME MASTER V OLUME PHONES V OLUME KEYBO ARD ...

  • Roland SA-1000 - page 20

    20 Main Specifications SA-1000 ● Rated Power Output 350 W (75 W x 2 + SUBWOOFER 200 W) ● Nominal Input Level (1 kHz) INPUT (MIC): -50 dBu INPUT (PHONE): -20 dBu INPUT (RCA): -20 dBu STEREO LINK INPUT: 0 dBu ● Nominal Output Level (1 kHz) BALANCED OUT: +4 dBu STEREO LINK OUTPUT: 0 dBu * 0 dBu = 0.775 Vrms ● Speakers 16 cm + Tweeter (Coaxial, ...

  • Roland SA-1000 - page 21

    21 Main Specifications SA-1000W (SUBWOOFER) ● Speaker 30 cm / 12 inches ● Nominal Impedance 4 ohms ● Connection INPUT Jack (1/4 " phone type) ● Dimensions 456 (W) x 325 (D) x 560 (H) mm 18 (W) x 12-13/16 (D) x 22-1/16 (H) inches ● Weight 11.5 kg / 25 lbs 6 oz ● Accessories Owner´s Manual Speaker Connection Cable Connection Manual ...

  • Roland SA-1000 - page 22

    For China For EU Countries SA-1000_r_e.book 22 ページ ２００７年１０月１日　月曜日　午後１時５２分 ...

  • Roland SA-1000 - page 23

    This product complies with the requirements of European Directives EMC 89/336/EEC and LVD 73/23/EEC. For EU Countries For Canada This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouill ...

  • Roland SA-1000 - page 24

    SD001049 3DH *S D 001049 - 03 * SA-1000_r_e.book 24 ページ ２００７年１０月１日　月曜日　午後１時５２分 ...

Fabricant Roland Catégorie Car Amplifier

Les documents que nous recevons du fabricant de l'appareilRoland SA-1000 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Roland
- manuels d’utilisations SA-1000
- fiches produit Roland
- dépliants
- ou étiquettes-énergie Roland SA-1000
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Roland SA-1000.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Roland SA-1000, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Roland SA-1000. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Roland SA-1000.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Roland SA-1000, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Roland SA-1000 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Roland SA-1000.

Le manuel d’utilisation complet Roland, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Roland SA-1000 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Roland SA-1000, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lRoland SA-1000 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Roland SA-1000 - qui devraient nous aider dans les premières étapes lors de l'utilisation Roland SA-1000
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Roland SA-1000
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Roland SA-1000 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Roland SA-1000?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Roland SA-1000, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Roland SA-1000 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)