-
Fujitsu P/N9359944058 - page 1
AIR CONDITIONER FLOOR CONSOLE/ UNDER CEILING DUAL TYPE P/N9359944058 Français Español English KEEP THIS MANUAL FOR FUTURE REFERENCE FUJITSU GENERAL LIMITED OPERA TING MANU AL MODE D’EMPLOI MANU AL DE FUNCIONAMIENT O 9359944058_OM_cover.p65 3/8/05, 10:54 1 ...
-
Fujitsu P/N9359944058 - page 2
En-1 CONTENTS SAFETY PRECAUTIONS ....................................... 1 FEA TURES AND FUNCTIONS .............................. 2 NAME OF P ARTS ................................................... 3 PREP ARA TION ....................................................... 5 OPERA TION ........................................................... 6 TIME ...
-
Fujitsu P/N9359944058 - page 3
En-2 FEA TURES AND FUNCTIONS AUTOMA TIC OPERA TION ● COOLING MODEL Merely press the ST ART/STOP button, and the unit will begin automatic operation in the Cooling or Dry mode as appropriate, in accordance with the thermostat setting and the actual temperature of the room. ● HEA T & COOL MODEL (REVERSE CYCLE) Merely press the ST ART/STOP but ...
-
Fujitsu P/N9359944058 - page 4
En-3 Fig. 6 Fig. 5 Instructions relating to heating (*) are applicable only to “ HEA T & COOL MODEL ” (Reverse Cycle). NAME OF P AR TS Fig. 4 Fig. 1 Fig. 2 Fig. 3 9359944058_OM_en.p65 3/8/05, 10:54 3 ...
-
Fujitsu P/N9359944058 - page 5
En-4 Fig. 4 Remote Control Unit C SLEEP button D MASTER CONTROL button E SET TEMP ./SET TIME buttons ( ) F Signal T ransmitter G TIMER button H F AN CONTROL button I ST ART/STOP button J AIR FLOW DIRECTION VERTICAL SET button K AIR FLOW DIRECTION VERTICAL SWING button L AIR FLOW DIRECTION HORIZONT AL SET button M AIR FLOW DIRECTION HORIZONT AL SWIN ...
-
Fujitsu P/N9359944058 - page 6
En-5 PREP ARA TION CAUTION! ● T ake care to prevent infants from accidentally swallowing batteries. ● When not using the remote control unit for an extended period, remove the batteries to avoid possible leakage and damage to the unit. ● If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- ately wash with copious ...
-
Fujitsu P/N9359944058 - page 7
En-6 Example: When set to COOL Example: When set to 88 ° F Example: When set to AUTO T o Select Mode Operation 1 Press the ST ART/STOP button. The indoor unit ’ s OPERA TION indicator lamp (red) will light. The air conditioner will start operating. 2 Press the MASTER CONTROL button to select the de- sired mode. Each time the button is pressed, t ...
-
Fujitsu P/N9359944058 - page 8
En-7 OPERA TION Instructions relating to heating (*) are applicable only to “ HEA T & COOL MODEL ” (Reverse Cycle). * During Heating mode: Set the thermostat to a temperature set- ting that is higher than the current room temperature. The Heating mode will not operate if the thermostat is set lower than the actual room temperature. During C ...
-
Fujitsu P/N9359944058 - page 9
En-8 T o Use the ON timer or OFF timer 1 Press the ST ART/STOP button (if the unit is already operating, proceed to step 2). The indoor unit ’ s OPERA TION indicator lamp (red) will light. 2 Press the TIMER button to select the OFF timer or ON timer operation. Each time the button is pressed the timer function changes in the follow- ing order: RE ...
-
Fujitsu P/N9359944058 - page 10
En-9 SLEEP TIMER OPERA TION T o Use the SLEEP timer While the air conditioner is operating or stopped, press the SLEEP button. Both the indoor unit’ s OPERA TION indicator lamp (red) and the TIMER indicator lamp (green) will light. To Change the Timer Settings Press the SLEEP button once again and set the time using the SET TIME buttons. Set the ...
-
Fujitsu P/N9359944058 - page 11
En-10 ADJUSTING THE DIRECTION OF AIR CIRCULA TION Instructions relating to heating (*) are applicable only to “ HEA T & COOL MODEL ” (Reverse Cycle). V ertical (up-down) direction of airflow is adjusted by pressing the remote control unit ’ s AIR FLOW DIRECTION VERTICAL SET button. Horizontal (right-left) direction of airflow is adjusted ...
-
Fujitsu P/N9359944058 - page 12
En-11 SWING OPERA TION Begin air conditioner operation before performing this procedure. T o select V ertical airflow SWING Operation Press the AIR FLOW DIRECTION VERTICAL SWING button. The SWING indicator lamp (VER TICAL SWING) (orange) will light. In this mode, the UP/DOWN air direction flaps will swing automatically to direct the air flow both u ...
-
Fujitsu P/N9359944058 - page 13
En-12 ● Before cleaning the air conditioner , be sure to turn it off and disconnect the power supply cord. ● Be sure the intake grille is installed securely . ● When removing and replacing the air filters, be sure not to touch the heat exchanger , as per - sonal injury may result. CLEANING AND CARE CAUTION! Cleaning the Air Filter 1. Pull out ...
-
Fujitsu P/N9359944058 - page 14
En-13 When two or more air conditioners are installed in a room and the remote control unit is operating an air conditioner other than the one you wish to set, change the signal code of the remote control unit to operate only the air conditioner you wish to set (four selections possible). When two or more air conditioners are installed in a room, p ...
-
Fujitsu P/N9359944058 - page 15
En-14 TROUBLESHOOTING Instructions relating to heating (*) are applicable only to “ HEA T & COOL MODEL ” (Reverse Cycle). In the event of a malfunction (burning smell, etc.), immediately stop operation, disconnect the power supply plug, and consult authorized service personnel. Merely turning off the unit ’ s power switch will not complet ...
-
Fujitsu P/N9359944058 - page 16
En-15 TROUBLESHOOTING Instructions relating to heating (*) are applicable only to “ HEA T & COOL MODEL ” (Reverse Cycle). Symptom Doesn ’ t operate at all: Poor Cooling (or *Heating) performance: The unit operates differ - ently from the remote con- trol unit ’ s setting: Signal is not received after replacing the batteries for the remo ...
-
Fujitsu P/N9359944058 - page 17
En-16 OPERA TING TIPS ● Should the power supply to the air conditioner be inter - rupted by a power failure, the air conditioner will restart automatically in the previously selected mode once the power is restored. ● Should a power failure occur during TIMER operation, the timer will be reset and the unit will begin (or stop) oper - ating unde ...
-
Fujitsu P/N9359944058 - page 18
En-17 Instructions relating to heating (*) are applicable only to “ HEAT & COOL MODEL ” (Reverse Cycle). * ● During use of the heating mode, the top of the indoor unit may become warm, but this is due to the fact that coolant is circulated through the indoor unit even when it is stopped; it is not a malfunction. Notice * ● During use of ...
Avez-vous une question à propos de Fujitsu P/N9359944058?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Fujitsu P/N9359944058, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Fujitsu P/N9359944058 il est probable qu’il a envie de partager la façon de le résoudre.