-
Smeg WDI147 - page 1
WASHER-DRYER INSTRUCTION MANUAL EN ...
-
Smeg WDI147 - page 2
1 EN Contents 1. Precautions for safety and use 2 2. Installation instructions 5 3. Description of controls 8 4. Using the appliance for washing 9 5. Using the appliance for drying 17 6. Cleaning and maintenance 20 7. Troubleshooting 22 This appliance is tagged in accordance with European Directive 20 02/96/EC on W aste Electrical and Electronic Eq ...
-
Smeg WDI147 - page 3
EN 2 READ THE INSTRUCTIONS Attention! You are ad vised to read all the instruct ions in this manual carefully; it w ill inform you about the right conditions for the proper, safe use of your washer-dryer It is very important to keep this instruction manual with the appliance for future reference. In the event of sale or transfe r, ensure that the m ...
-
Smeg WDI147 - page 4
EN 3 The appliance is onl y disconnected from the electricit y supply if the plug ha s been removed from the so cket o r the electrical system ma ster switch has been turned off. The pow er pl ug must be accessible after the appliance ha s been installed. The appliance m ust be installed using new sets of hoses (supplied with the appliance) ...
-
Smeg WDI147 - page 5
EN 4 Fabric sof teners, or sim ilar products, should be use d as specified by the f abric softener instru c- tions. The f inal part of a tumble dryer c ycle occurs without heat (cool down c ycle) to ensure that th e items are left at a tem perature that ensures that the item s will not be changed Never stop a tum ble drier before the en ...
-
Smeg WDI147 - page 6
EN 5 2. INSTA LLATION INSTRUC TIONS Important! The appliance must be installed by a qualified e ngineer i n compliance with the relevant regulations. The washer-dryer is heavy. Take care when lifting it. 2.1 UNPA CKING The unit on flexible mounts is fixed in plac e for transport using the screws ( A) on th e rear of the washer -dryer, with the rela ...
-
Smeg WDI147 - page 7
EN 6 2.2 POSITION ING AND LEVELLING 1. Place the appliance i n the chosen position. 2. Level the appliance carefully in all di rections with the aid o f a spirit level, adjust ing the height of the feet if necessary. Once do ne, fix the feet i n place with th e locknuts pr o- vided. 3. On appliances with adjustable rear feet , note that t he rear o ...
-
Smeg WDI147 - page 8
EN 7 2.3 CONNEC TING TO THE WATER SUP PLY 1. Check that the water supply p ressure is in the following range: 0,05-0,9MPa . W ith higher pressures, use a pressure reducer. 2. Connect the cold water su pply hos e ( blue screw collar) to the cold water tap with ¾ gas threaded connector, taking care to tighten fi rmly to prevent leaks. The water su p ...
-
Smeg WDI147 - page 9
EN 8 3. DESCRIPTION OF CONTR OLS 3.1 CONT ROL PANEL All the appliance's control and monitoring devices are placed together on the front pan el. Programme Selector For switching the was her-dr yer on and off and selecti ng pr o- gramm es. Can be turned in e i- ther direction. Does no t turn wh ile programm es are in pro- gress. Start/Pause butt ...
-
Smeg WDI147 - page 10
EN 9 4. USING THE APPLIA NCE FOR WASHING 4.1 PREPA RING THE ITEMS F OR WASH ING 1. Subdivide the items for washing by fabric type and colour fastness. 2. Wash white and col oured items separately. New c oloured i tems should be washed separately the fi rst ti me. Normally, items carry labels with washing instructions. The following is a short descr ...
-
Smeg WDI147 - page 11
EN 10 4.4 LOAD ING THE ITEMS FOR WASHING 1. Open the door an d load the laundry, distributing it e venly over the drum, with items opened out and not bundled together; if possible, large and small items should be w ell mixed. 2. The washing machine c overed by this manual c an be loaded w ith up to 7 kg of l aundry for each wash. If this weight is ...
-
Smeg WDI147 - page 12
EN 11 4.6 POWDER DE TERGENT DOSES Laundry with normal dirt 1. Choose a programme without prewash. 2. Pour the total amount of detergent shown on the pack into the mai n was h compartment of th e detergent dr awer. Very dirty la undry 1. Choose a programme with prewash. 2. Place ¼ of the recommended amount of detergent in the prewash compartment of ...
-
Smeg WDI147 - page 13
EN 12 4.10 SWITC HING ON THE A PPLIANCE A ND SELECTIN G THE WASHING PRO GRAMME To switch on the appliance and select the programme, proce ed as follows: 1. Turn the programmes knob in either direction. This sw itches on the washer -dryer. 2. Select the washing programme. The time left to the end of the programme and the maximum recommended weight f ...
-
Smeg WDI147 - page 14
EN 13 4.11 SELECT ING AND CONFIRM ING OPTIONS 1. The Option Selection button can be used to select the follow ing options in sequence (from the top down): Prewash : adds a stage before the main wash, lasting about 20 minutes at a temperature of 3 5°C. Su i t a- ble for loads of particularly dirty items. Intensive : the max. temperature is changed ...
-
Smeg WDI147 - page 15
EN 14 4.12 TIME T O END 1. The Time to End key c an be pressed repeatedly to select the time after which the w ashing programme will end. The time to end of cycle function calculates the i nitial duration of t he washing/drying cycle, the settings made (temperature, spin speed and options) which may shorten or lengthen the cycle's i nitial d u ...
-
Smeg WDI147 - page 16
EN 15 4.14 INTE RRUPTING OR CHA NGING THE WASHING PROGRA MME The washing programme in progress can be interrupted at any moment: 1. press the “Start/Pause” but ton for about 3 seconds: the display shows the word PAUS (for 1 se cond) a l- ternating with the time re maining until the end of the cycle (for 1 second ). The Start/Pause light flashes ...
-
Smeg WDI147 - page 17
EN 16 4.17 OPENING THE APPLIA NCE IN A N EMERGENCY In the event of a power failure, th e door is opened using the mechanical release device activated by means of the l ever in the bottom of the appliance: Turn th e k nob to Off and disconnect the power supply plug from the socket. Drain off the water (see point 6.4) Pull the lever down ...
-
Smeg WDI147 - page 18
EN 17 5. USING THE APPLIA NCE FOR DRYING 5.1 GENERA L During drying cycles, the water tap must be turned on and the drain hose correctly position ed. This appliance can be set to perform wash only, dry only and wash- and -dry programmes. In the wash- and -dry programme, the appliance switches from w ashing to drying automatic ally, with no need to ...
-
Smeg WDI147 - page 19
EN 18 5.2 WAS H- A ND-DRY PROGRA MME Automatic washing and drying can be carried out in the tough fabrics (cotton an d colours) an d synthetic/delicate fabrics programmes. If the wool wash programmes are selected, automatic drying after the w ash c annot be set. For automatic washing and drying, the load of laundry m ust not exceed 4 kg of cotton o ...
-
Smeg WDI147 - page 20
EN 19 5.5 CLEAN PROGRA MM E To k eep the a ppliance operating at peak e fficiency over time, it has a CLEAN programme for regular cleaning of the drying circuit to remove any fluff deposits. 1. After a given n umber of drying cycles, the C LEAN symbol lights up on the display to warn that this pr o- gramme needs to be ru n. The warning l ight remai ...
-
Smeg WDI147 - page 21
EN 20 6. CLEAN ING AND MA INTENANCE Important – Before carrying out any clea ning or maintenance procedure, the plug must be disconnected from the power supply socket. 6.1 CLEAN ING THE OUT SIDE OF THE A PPLIANCE Regular, thorough cleaning will keep your appliance looking good. Clean the exterior of the appliance with soap and water only, ...
-
Smeg WDI147 - page 22
EN 21 3. Extract the drain hose ”A”. W ar ning: if the hose is hot, the water is hot or boiling hot. Place a shallow container on the flo or and remove the plug “B” to drain off the water. Depending o n the a mount of water in the appliance, the contai ner may ha ve to be emptied several times. W hen no more water is c oming out, c lose the ...
-
Smeg WDI147 - page 23
EN 22 7. TROUBLESHO OTING This produce complies with the rele vant regulations governing the safety o f electrical equipment. Fo r s afety re a- sons, any technical inspections or repairs must be performed by qualified staff, to prevent all hazards for the user. If the appliance d oes not work, be fore calling the After -Sales Service, to avoid unn ...
-
Smeg WDI147 - page 24
EN 23 11 Appliance does not spin Anti-imbalance safety devic e tripped because laundry no t evenly distri b- uted i n drum. If laundry is still wet at end of cycle, rearrange it in the drum by hand and repeat spin programme only. 12 Emptying water from drum In the event of a power blackout or appliance failure, the water can be removed from the dru ...
-
Smeg WDI147 - page 25
PROGRAM GUIDE Programs Temp. (°C) Max. Spin (rpm) Max. washing load (kg) Max. drying load (kg) Prewash Wash Softner Prewash Intensive Easy Ir on Extra rinse Flexi time Drying after wash if selected Wash program description Cotton Delicate coloureds with l ight di rt / 30° Max 7 4 Normal Cold wash or at 30°C, ri ns ...
-
Smeg WDI147 - page 26
ISTRUZIONI DI MONTA GGIO DELLE LA VA T RICI INTEGRA BILI IT A SSEMBLY INST RUCT IONS FOR BUILT-IN WA SHING MA CHINES EN MONTA GEA NLE ITUNG FÜR EINBA UB A RE- WA SCHMA SC HINEN DE INSTRU CTIONS DE MONTA GE DES LA VE-LINGE INTÉGRA BLES FR INSTRU CCIONES DE INSTA LA CIÓ N DE LA S LA VAD ORA S INTEGRA BLES ES INSTRU ÇÕES DE MONTA GEM DA S MÁQUIN ...
-
Smeg WDI147 - page 27
4 A SSEMBLY I NST RUCTIONS FOR BUILT-IN WA SHING M A - CHINES IMPORTANT - This machine compli es with current safety regu lations govern- ing electrica l appliances an d, to ensure user safety , it must be in stalled by a qualified te chnician a s required by current l egislation Size of ca binet The m inimum di mension s of the cabinet are: height ...
-
Smeg WDI147 - page 28
5 Place the temp late of the inner side o f the p anel an d matc h the height of the base board with the lower edge of the p anel ( fig. 4 ) using the grad uated s cale. Make sure the template is horizon- tally centre d with reference to the vertical li nes mark ed at the ends. After pla cing th e template i n t he correct pos ition, trac e the pos ...
-
Smeg WDI147 - page 29
6 impossibl e to touch li ve components and a tool m ust be required to rem ove it. Our comp any declines all liabil ity for failure to observe the above safety requirem ent. Apply ing the baseboard It m ust be po ssible to remove the continu ous kitc hen bas eboard to allow the d rain pum p to be cl eaned if necess ary. In som e cas es, the baseb ...
-
Smeg WDI147 - page 30
c a . 82 kg 820mm 1 6 m m 5 6 0 m m 5 9 6 m m 1 5 0 m m 5 8 m m 820mm ! ! ! ! 1 9 A B 2 ...
-
Smeg WDI147 - page 31
2 2 3 3 12 12 1 1 11 7 7 1 0 10 8 8 9 9 2 2 1 1 3 3 4 4 6 6 5 5 4 5 4 1 1 2 3 2 3 C C 6 6 5 5 7 7 8 8 C A B - A B - C 9 D D 2 2 1 1 3 3 4 4 A B 3- A 3-B 3 ...
-
Smeg WDI147 - page 32
Ø2mm Ø2mm 13mm 13mm 16. ..21 mm Ø 35mm Ø35mm 13mm 13mm 592...595mm 16 ... 21m m 592...595mm e e e e e e e e Unterkante Lower edge C ôté inférieur Lato inferiore Lado inferior Onderkant Unterkante Loweredge C ôtéinférieur Latoinferiore Ladoinferior Onderkant 9 4 5 6 Н ижнийкрай Н ижнийкрай ...
-
Smeg WDI147 - page 33
1 1 2 2 3 3 1 1 2 2 3 3 1 1 ? 7 8 9 2 1 2 4 3 5 6 ...
-
Smeg WDI147 - page 34
9 10 1 1 ...
Avez-vous une question à propos de Smeg WDI147?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Smeg WDI147, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Smeg WDI147 il est probable qu’il a envie de partager la façon de le résoudre.