Français dropdown-ico

Manuel d’utilisation Shindaiwa 35701

20 pages 0.46 mb
Télécharger

Aller à la page of 20

Summary
  • Shindaiwa 35701 - page 1

    Always wear eye protection when operat- ing this unit. WARNING! SHINDAIW A OWNER'S/ OPERA TOR'S MANUAL 357 CHAIN SA W 3 5 7 0 1 WARNING! Minimize the risk of injury to yourself and others; read this manual and familiarize yourself with its contents! Part Number 72362-93115 Rev. 9/03 Shindaiwa Inc. 11975 S.W. Herman Rd. Tualatin, Oregon 97 ...

  • Shindaiwa 35701 - page 2

    2 39 NOTES ...

  • Shindaiwa 35701 - page 3

    3 Introduction The Shindaiwa 357 Top-Handle saw has been designed and built to deliver superior performance and reliability without compromise to quality, comfort, safety, or durability. Shindaiwa high performance engines represent the leading edge of 2-cycle engine technology, and deliver exceptionally high power at remark- ably low displacement a ...

  • Shindaiwa 35701 - page 4

    4 Read and follow the Operator’s Manual. Failure to do so could result in serious injury. Wear eye and hearing protection at all times during the operation of this unit. Do not operate this tool if you are tired, ill or under the influence of alcohol, drugs, or medication. Beware of Kickback! Kickback can occur whenever the tip of the guide bar t ...

  • Shindaiwa 35701 - page 5

    5 35702 Clutch Cover Muffler Outlet IMPORTANT! The operational procedures de- scribed in this manual are intended to help you get the most from your machine and also to protect you and others from harm. These procedures are general guidelines only, and are not intended to replace any safety rules/laws that may be in force in your area. If you have ...

  • Shindaiwa 35701 - page 6

    6 DESCRIPTION Model ....................................................................................................................... 35 7 Engine Type ................................................................ 2 cycle air cooled gas engine Displacement .............................................................................. 35.5 c ...

  • Shindaiwa 35701 - page 7

    7 DESCRIPTION 35703 Kickback Safety This saw is equipped with the following safety equipment: ■ Operator activated and Inertial type chain brake. In the event of kickback, kickback energy either forces the brake lever against the operator's hand when the saw is held as illustrated above activating the chain brake and/or inertia causes chain ...

  • Shindaiwa 35701 - page 8

    8 DESCRIPTION WARNING! Either of the following reactions could cause you to lose control of your saw while cutting, possibly resulting in serious injury! 1. Kickback can occur whenever the guide bar nose or tip contact an object while the saw is running. Tip contact may cause the guide bar to kick upward and back toward the operator, with a lightni ...

  • Shindaiwa 35701 - page 9

    9 DESCRIPTION WARNING! NOTE: These safety precautions are intended primarily for consumers or occasional users. When using this chain saw for logging purposes, refer to: CFR Section 1910. 266 (5); 2.5.1 of the American National Safety Standard; Requirements for Pulp- wood Logging ANSI 03.1-1978; and any applicable state safety codes. ■ Never oper ...

  • Shindaiwa 35701 - page 10

    10 DESCRIPTION WARNING! ■ Install the appropriate guide-bar scabbard before transporting the saw. ■ Never operate a saw that is damaged, improperly adjusted, or not completely and securely assembled. ■ Use only Shindaiwa-recommended parts when repairing or servicing this saw. ■ Do not use this saw if the saw chain continues to move after th ...

  • Shindaiwa 35701 - page 11

    11 ASSEMBLY 35707 IMPORTANT! The chain brake must be completely disengaged before removing or installing the clutch cover! 1. Use the 13 mm socket wrench to remove the clutch cover nuts. Turn the nuts counter-clockwise to remove. 2. Slide the rubber stopper downward and unhook the support arm from the brake lever (see illustration below). 1. Remove ...

  • Shindaiwa 35701 - page 12

    12 ASSEMBLY 35708 57704 Brake lever support arm 4. Remove the packing spacer. 5. Install the guide bar. 6. Install the chain loop over the drive sprocket, and then align the chain drive links within the guide bar groove. Make sure the cutters are properly oriented. WARNING! Never start the engine without the clutch cover installed! 35709 6. Install ...

  • Shindaiwa 35701 - page 13

    13 OPERATION 35710 WARNING! Inspect chain tension often during operation, especially when breaking in a new chain. A loose saw chain can unexpectedly jump the guide bar during operation, possibly causing serious personal injury! IMPORTANT! Proper chain adjustment is essential for maximum performance, chain life, and operator safety. Always inspect ...

  • Shindaiwa 35701 - page 14

    14 OPERATION Mixing Fuel/Filling With Fuel WARNING! Minimize the risk of fire burns and personal injury! IMPORTANT! Shindaiwa high-performance 2-cycle engines are designed to operate on a 50:1 mixture of unleaded gasoline and 2-cycle engine oil. Using a fuel mixture less than 50:1 ratio (such as 80:1 or 100:1) can cause cata- strophic engine failur ...

  • Shindaiwa 35701 - page 15

    15 OPERATION 35711 Fuel Cap Oil Cap 3. Refer to following chart for examples of 50:1 fuel to oil mix quantities. 4. Place the saw on a hard surface with the fuel cap up and wipe any chips or debris from around the fuel cap. Oil Requirements 䡵 When available, use Shindaiwa Premium bar & chain oil. 䡵 When Shindaiwa oil is not available, use a ...

  • Shindaiwa 35701 - page 16

    16 OPERATION 35712 Preparing to Start the Saw Throttle Lockout Lever Throttle Lock Button Throttle Trigger Ignition Switch WARNING! The saw chain will rotate when the saw is started! Clear a safe work area before starting the saw! IMPORTANT! Engine ignition is controlled by a two- position “ON-OFF” switch located below the throttle lever. This ...

  • Shindaiwa 35701 - page 17

    17 OPERATION 35714 Starting the Saw 1. Place the saw on the ground. 2. Secure the saw firmly as shown. 3. Grip the starter handle with your right hand, pull the starter cord slowly until you feel the starter engage, then… 4. Start the saw by pulling the starter cord upward rapidly. When the engine starts: 1. Push the choke control all the way in ...

  • Shindaiwa 35701 - page 18

    18 35719 Starting a Flooded Engine 1. Disconnect the spark plug lead, then use the spark plug wrench to remove the spark plug (turn counter-clockwise to remove). 2. If the spark plug is fouled or is soaked with fuel, clean or replace the plug as required. For correct spark plug size and gapping procedure, see page 26. 3. Clear excess fuel from the ...

  • Shindaiwa 35701 - page 19

    19 Carburetor Adjustments A clean and unrestricted airflow is essential to your saw engine’s perfor- mance and durability! Before attempt- ing any carburetor adjustments, inspect and clean the engine air filter as required! Procedures for maintain- ing this saw’s air cleaner are described on page 27 of this manual. Before starting the engine 1. ...

  • Shindaiwa 35701 - page 20

    20 Low and High Mixture Adjust- ments for Non Emission Compli- ance Engines. Low Speed Mixture (engine idling at operating temperature. 1. Using a small screwdriver, slowly turn the low speed mixture screw clockwise (lean mixture) and note any changes in engine rpm. 2. Next, turn the low speed mixture screw counter-clockwise (rich mixture) and note ...

Fabricant Shindaiwa Catégorie Chainsaw

Les documents que nous recevons du fabricant de l'appareilShindaiwa 35701 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Shindaiwa
- manuels d’utilisations 35701
- fiches produit Shindaiwa
- dépliants
- ou étiquettes-énergie Shindaiwa 35701
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Shindaiwa 35701.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Shindaiwa 35701, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Shindaiwa 35701. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Shindaiwa 35701.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Shindaiwa 35701, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Shindaiwa 35701 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Shindaiwa 35701.

Le manuel d’utilisation complet Shindaiwa, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Shindaiwa 35701 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Shindaiwa 35701, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lShindaiwa 35701 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Shindaiwa 35701 - qui devraient nous aider dans les premières étapes lors de l'utilisation Shindaiwa 35701
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Shindaiwa 35701
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Shindaiwa 35701 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Shindaiwa 35701?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Shindaiwa 35701, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Shindaiwa 35701 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)