Manuel d’utilisation Yamaha PC9500N

16 pages 0.44 mb
Télécharger

Aller à la page of 16

Summary
  • Yamaha PC9500N - page 1

    POWER AMPLIFIER Owner’s Manual E ...

  • Yamaha PC9500N - page 2

    2 WARNING: THIS APPARATUS MUST BE EARTHED IMPORTANT THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE: GREEN-AND-YELLOW : EARTH BLUE : NEUTRAL BROWN : LIVE As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as fol ...

  • Yamaha PC9500N - page 3

    3 Pr ecautions W ARNING Installation • Connect this unit’s power cord only to an AC outlet of the type stated in this Owner’s Manual or as marked on the unit. Failure to do so is a fire and electrical shock hazard. • Do not allow water to enter this unit or allow the unit to become wet. Fire or electrical shock may result. • Do not place ...

  • Yamaha PC9500N - page 4

    4 CA UTION Installation • Keep this unit away from the following locations: - Locations exposed to oil splashes or steam, such as near cooking stoves, humidifiers, etc. - Unstable surfaces, such as a wobbly table or slope. - Locations exposed to excessive heat, such as inside a car with all the windows closed, or places that receive direct sunlig ...

  • Yamaha PC9500N - page 5

    5 Introduction Thank you for purchasing a Yamaha PC9500N, or PC4800N Series Power Amplifier. The PC Series of power amplifiers was developed from Yamaha’s wealth of experience in building PA equipment and its tradition of careful attention to every detail of circuit design. These power amplifiers feature high power and superb quality together wit ...

  • Yamaha PC9500N - page 6

    6 C ontrols and F unctions ■ Fr ont P anel 1 POWER/STAND-BY switch and indicator This turns the power of the amplifier on/off. When you press the switch to turn on the power, the indica- tor will light green. If the amplifier is connected to an external control unit and the amplifier has been commanded to enter STAND-BY mode, this indicator will ...

  • Yamaha PC9500N - page 7

    7 ■ Rear P anel 1 XLR inputs These balanced XLR-3-31 type connectors are used to connect input signals. They are wired pin 1–ground, pin 2–hot (+), and pin 3–cold (–). 1 2 3 Cold Ground Hot In Bridge mode, only the XLR input of the channel A is active. 2 MODE switch • STEREO mode Channels A and B will operate independently. • PARALLEL ...

  • Yamaha PC9500N - page 8

    8 ■ Speaker connections Speakers can be connected to this amplifier in the following two ways. The speaker impedance will depend on the connection method and on the number of speakers that are connected. Refer to the following diagrams, and make sure that the speaker impedance is not less than the value prescribed for each type of connection. Con ...

  • Yamaha PC9500N - page 9

    9 C onnection ■ Using a Eur oblock connector 1. If the wire insertion ports are closed, turn the screws on top of the connector counterclockwise to open the ports. 2. Insert the wires into the appropriate ports, following the indication of the pole on the input terminal, turn the screws on top of the connector clockwise to fix the wires. 3. Attac ...

  • Yamaha PC9500N - page 10

    10 Air F lo w This unit uses a forced cooling system in which air comes in through the front opening and goes out the rear. 4-6.5 x 1 1 88 463 480 Unit : mm 248 4-C15 4-ø4.5 76.2 71.5 ± 0.1 71.5 ± 0.1 78 78 Fan kit PC9500N/ PC4800N PC9500N/ PC4800N Rack Mounting If multiple high-power amp units are mounted in a rack with poor ventilation, the he ...

  • Yamaha PC9500N - page 11

    11 Specifications ■ Gener al Specifications PC9500N PC4800N 120 V (US)/ 240 V (A) 230 V (EU) 120 V (US)/ 240 V (A) 230 V (EU) Power Output Level (Rated Power) 8 Ω /STEREO 1000 W x 2 1050 W x 2 550 W x 2 500 W x 2 1 kHz 4 Ω /STEREO 1600 W x 2 1650 W x 2 850 W x 2 800 W x 2 THD+N= 1% 8 Ω /BRIDGE 3200 W x 1 3300 W x 1 1700 W x 1 1600 W x 1 8 ? ...

  • Yamaha PC9500N - page 12

    12 ■ Block Diagr am ...

  • Yamaha PC9500N - page 13

    13 ■ Dimensions Unit: mm 480 88 456 46 4 380 26 25 30 370 30 25 ...

  • Yamaha PC9500N - page 14

    14 T roubleshooting The following table lists the main causes of abnormal operation and the corrective measures required as well as the protective circuit operation in each case. Protection Circuit Remedy Possible Cause Indicator CLIP indicator lights up PROTECTION indicator lights up There is a short at the amplifier’s speaker outputs, the speak ...

  • Yamaha PC9500N - page 15

    ...

  • Yamaha PC9500N - page 16

    YAMAHA CORPORATION V853450 R 1 1 AP 16 Pro Audio & Digital Musical Instrument Division P.O. Box 3, Hamamatsu, 430-8651, Japan NP Printed in Taiwan ...

Fabricant Yamaha Catégorie Stereo Amplifier

Les documents que nous recevons du fabricant de l'appareilYamaha PC9500N peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Yamaha
- manuels d’utilisations PC9500N
- fiches produit Yamaha
- dépliants
- ou étiquettes-énergie Yamaha PC9500N
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Yamaha PC9500N.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Yamaha PC9500N, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Yamaha PC9500N. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Yamaha PC9500N.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Yamaha PC9500N, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Yamaha PC9500N par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Yamaha PC9500N.

Le manuel d’utilisation complet Yamaha, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Yamaha PC9500N - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Yamaha PC9500N, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lYamaha PC9500N qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Yamaha PC9500N - qui devraient nous aider dans les premières étapes lors de l'utilisation Yamaha PC9500N
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Yamaha PC9500N
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Yamaha PC9500N dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Yamaha PC9500N?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Yamaha PC9500N, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Yamaha PC9500N il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)