-
Smeg WMF147 - page 1
WASHING MACHINE INSTRUCTION MANUAL EN ...
-
Smeg WMF147 - page 2
1 EN Contents 1. Precautions for safety and use 2 2. Installation instructions 5 3. Description of controls 8 4. Using the appliance for washing 9 5. Cleaning and maintenance 17 6. Troubleshooting 19 This appliance is tag ged in accordance with E uropean Directive 2002/96/EC on Waste Electrical and E- lectronic Equipm ent - W EEE. This directive co ...
-
Smeg WMF147 - page 3
EN 2 READ THE INSTRUCTIONS Attention! You are advised to read all the instructions in this manual carefully; it will inform you about the right conditions for the proper, safe use of your washing machine. It is very important to keep this instruction manual w ith the appliance for futu re ref- erence. In the event of sale or transfer, en sure that ...
-
Smeg WMF147 - page 4
EN 3 same as the values mark ed on the nameplate. The use of adapters or junctions is not rec om- mended. Never disc onnect the plug b y pulling on the po we r suppl y lead. • The appliance is on ly disconnected from t he electricit y s upply if th e plug has been removed from the so cket o r the electric al s ystem ma ster s witch has been turn ...
-
Smeg WMF147 - page 5
EN 4 For Great Britain onl y Warning : this appl iance must be earthed. Fuse replacem ent If the mains lead of this a ppliance is f itted with a BS 1 363A 13amp fus ed plug, to change a fuse in this type of plug use an A.S.T.A . appro ved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse co ver ( A ) and fuse ( B ) 2. Fit replacem ent ...
-
Smeg WMF147 - page 6
EN 5 2. INSTA LLAT ION INSTRUCTIONS Important! The appliance must be installed by a qualified en gineer in compliance with the relevant regulations. The washing machine is heavy. Take care when lifting it. 2.1 UNPA CKING The u nit on flexible mounts is fixed in place for transport using the scre w s ( A) on the rear of the washing machine with the ...
-
Smeg WMF147 - page 7
EN 6 2.2 POSITION ING AN D LEVELL ING 1. Place the appliance in the chosen position. 2. Level the app liance carefully in all directions with the a id o f a spirit level, adjusting the height of the feet if necessary. Once do ne, f ix the f eet in place with t he locknuts p ro- vided. 3. On a ppliances with adjustable rear feet , note th at the rea ...
-
Smeg WMF147 - page 8
EN 7 2.3 CONNEC TING TO T HE WAT ER SUPP LY 1. Check that the water s upp ly pressure is in the follow ing range: 0,05-0,9MPa . W ith higher pressures, use a pressure reducer. 2. Connect the c old water supply hose ( blue scre w collar) to the c old water tap with ¾ gas t hreaded connector, taking care to tighten firmly to p revent leaks. The wate ...
-
Smeg WMF147 - page 9
EN 8 • If the power supply l ead is d amaged, it must onl y be replaced with an original spare, avail able from the After- Sales Service. • Do not connection/disconnect the power supply plug from the socket with wet hands • Only disconne ct the power supply plug from the sock et b y taking hold of the plug itself, never b y pulling on the lea ...
-
Smeg WMF147 - page 10
EN 9 4. USING THE A PPLIANCE FOR WASHING 4.1 PREPA RING THE ITEMS FOR WA SHING 1. Subdivide the items for washing by fabric type and colour fastness. 2. Wash white and c oloured items separately. New coloured items should be washed separately the first time. Normally, items carry labels with washi ng instructions. The following is a short d escript ...
-
Smeg WMF147 - page 11
EN 10 4.3 LOAD S OF WAS HING As far as p ossible, to save electricity, it is more ec onomical to w ash complete loads of the various t ypes of fabric . Sh ake out the washing before loading, and alternate large and small items. It i s best to weight the load the first few times, after which you will be able to rely on your experience. 4.4 LOAD ING ...
-
Smeg WMF147 - page 12
EN 11 4.6 POWDER DE TER GENT DOSE S Laundry with normal dirt 1. Choose a programme without prewash. 2. Pour the total amount o f detergent shown on the pack into the main wash co mpartment of the detergent dra- wer. Very dirty laundr y 1. Choose a programme with prewash. 2. Place ¼ of the rec ommended a mount of detergent in the prewash compartmen ...
-
Smeg WMF147 - page 13
EN 12 4.10 SWITC HING ON TH E APP LI A NCE A ND SELECTING TH E WASHING PROGRA MME To switch on the appliance and select the programme, proceed as follows: 1. Turn the programmes knob in either direction. This switches on the washing machine. 2. Select the washing programme. The ti me left to the end of the programme and the maximum recommended weig ...
-
Smeg WMF147 - page 14
EN 13 4.11 SELECT I NG A N D CONFIRM ING OPTI ONS 1. The Option Selection button can be used to select the following options in sequence (from the top down): Time to End : ke y can be pressed repeatedly t o select the time after which the washing programme will end. (See par.4.12) Prewash : adds a stage before t he main wash, lasting about 20 minut ...
-
Smeg WMF147 - page 15
EN 14 4.12 TIME T O END 1. To select options “time to end”,press the “Option selection” but ton, pressing repeatedly the “Confirm op- tion” button options you can sele ct when the wash cycle ends.. The time to en d of cycle function calcu- lates the initial dura tion of the washing/drying c ycle, the settings made (temperature, spin spe ...
-
Smeg WMF147 - page 16
EN 15 4.14 INTE RRUPT ING OR CHA NGING THE WASH ING PROGRA MME The washing programme in progress can be interrupted at any moment: 1. Press the “Start/Pause” b utton for about 3 seconds: the display sh ows the word PAUS (for 1 second) al- ternating with the time remaining until the end of the cycle (for 1 second). The Start /Pause light flashes ...
-
Smeg WMF147 - page 17
EN 16 4.17 OPENING THE A P PLIA NCE IN A N EMERGENCY In the event of a power failure, the d oor i s op ened using the mechanical release device activated by means of the lever in the bottom of the appliance: • Turn th e knob to Off and disconnect the power supply plug from the socket. • Drain off the water (see point 5.4) • Pull the lever dow ...
-
Smeg WMF147 - page 18
EN 17 5. CLEAN ING AND MA I NTE NANCE Important – Before carrying out any c leaning or maintenance procedure, the plug must be disconnected from the power supply socket. 5.1 CLEA NING THE OU TSIDE OF THE A PPLIANCE • Regular, thorough cleaning will keep your appliance looking good. • Clean the exterior of the appliance with soap and water onl ...
-
Smeg WMF147 - page 19
EN 18 3. Extract the drain hose ”A”. W ar n ing: if the hose i s hot, the water is hot or boiling hot . Place a shallow container on the floor and remove the plug “B” to drain off the water. Depending on the amount of water in the appliance, the c ontainer may have to be emptied several times. W he n no m ore water is coming out, close the ...
-
Smeg WMF147 - page 20
EN 19 6. TROUBLESH OOTING This produce complies with the relevant regulations governing the safety of el ectrical equipment. For safety rea- sons, any technical inspections or repairs must be performed by qualified staff, to prevent all hazards for the user. If the appliance does not work, before calling the After-Sales Service , to avoid unnecessa ...
-
Smeg WMF147 - page 21
EN 20 11 A p pliance does not spin Anti-imbalance sa fety devic e trip ped b ecause laundry not evenly distrib- uted in drum. If laundry is still wet at end of cycle, rearrange it in the drum by hand and repeat spin programme only. 12 Empty in g water from drum In the event of a power blackout or appliance failure, the water can be removed from the ...
-
Smeg WMF147 - page 22
PROGRAM GUIDE Programs Temp. (°C) Max. Spin (rpm) Max. washing load (kg) Prewash Wash Softner Prewash Intensive Easy Iron Extra rinse Flexi time Wash program description Cotton Delicate coloureds with light dirt / 30° Max 7 Cold wash or at 30°C, rinses and final spin at the selected speed Delicate coloureds with n ...
Avez-vous une question à propos de Smeg WMF147?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Smeg WMF147, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Smeg WMF147 il est probable qu’il a envie de partager la façon de le résoudre.