Manuel d’utilisation Microsoft LC2000

22 pages 0.39 mb
Télécharger

Aller à la page of 22

Summary
  • Microsoft LC2000 - page 1

    Micr osoft Small Business Server 2000 Installation Guide fo r HP NetServers E60, E800, LC2000, and HP Server tc3100, and tc4100 NOT ICE: The inform ation in this document w as last update d for the HP NetServer Navigator CD-ROM ver sion M.04.05. If y ou don't hav e the M.04.05 version C D-ROM and y ou're obta ining this docum ent from the ...

  • Microsoft LC2000 - page 2

    Tip #3. Upgrading Small Business Server 2000 from Uniprocessor HAL to Multiprocessor HAL Tip #4. Small Business Serv er 2000 Driver Signat ures Tip #5. Upgrading D5013B NIC Drivers for Small Business Server 2000 Tip #6. Installation Fails to B oot after First Reboot Tip #7. Small Business Server 2000 Recover y Opt ions Tip #8. Terminal Server Servi ...

  • Microsoft LC2000 - page 3

    · One or more hard drives. · Latest system BIOS update. (http://www.hp.com) · Two or more clients for t e sting purpose. (Optional) · HP Driver's diskette if installing devices that have no drive rs included in the Small Business Server 2000 CD-ROM. Example: HP NetRA I D-4 M, HP Fiber Ch annel adapter (Optional), etc. (This driver's d ...

  • Microsoft LC2000 - page 4

    Computer Name: ______________________ Admin Password: _____________________ Date Time Zone: ______________________ Workgroup or Domain Name: ______________ Registration Key: ____________________________ Installation Methods There are s everal ways of installing Small Busi ness Server 2000. The most popular methods are listed below. Select a method ...

  • Microsoft LC2000 - page 5

    Manual Installation Creating the Driver s Diskette Before y ou be gin, use one of the followin g two methods that can be used to creat e the drivers diskette. One method is to create the drivers di skette using a system booted from the Navigator CD. The other method is to create th e drivers di skette using a system that is running Windows NT, Smal ...

  • Microsoft LC2000 - page 6

    · If you want to start the setup by booting di rectly off the Small Business Server 2000 CD (supported for all NetServers), pro ceed to th e following section "Installing Small Business Server 2000." Creat ing Setup Diskettes If you opt for starting the Small Business Server 2000 installation from Setup Diskettes, do the following: 1. Yo ...

  • Microsoft LC2000 - page 7

    NOTE: If the boot device driver is not included on the Small Business Server 2000 CD- ROM, for exampl e the "HP NetRA ID-4M", then do t he following steps aft er pressing F6 a) Press S to select additional hardware. b) Select Other and press Enter . c) When prompted to insert driver diskette , please i nsert the target ad apter driver &ap ...

  • Microsoft LC2000 - page 8

    15. Note: If you see a dialog box titled "Digital Signature Not Found". Please click "Yes" to continue the installati on and read Tip #4 in the trouble shooting section of this guide . 16. Click Next at the reg ional Settings scre en. 17. At the Personalize You r Softwa re screen, enter a name and organization . Then click Nex t ...

  • Microsoft LC2000 - page 9

    2. Click Prop e rti es . This brings up the "System Properties" panel. 3. Click the Hardw are tab. 4. Click the Device Manag er… button. 5. Verify that no devices have either a yellow ba nd (!) or question mark (? ) symbol next to it. (See followin g note for poin ter to excepti ons) Yellow ( ! ) means that there is a resourc e issue wi ...

  • Microsoft LC2000 - page 10

    1. Click Start | Programs | Administrative Tools | Computer Managemen t . 2. If necessary click the + sign next to Storage to open this folder. 3. Double click Disk Management . 4. The "Write signa ture and Upgrade" wizard will start if you ha ve new hard drives with no signatures on them. 5. Follow the instructions provided by the wiza r ...

  • Microsoft LC2000 - page 11

    10. Open a command prompt window to verif y th e TC P/IP configuration. Enter the command: ipconfig /a ll You should get a display showing the conf iguration information y ou entered above. 11. Test the link by entering the following at the comm and prompt: ping computername Where com puternam e is the server name. You should get four reply's ...

  • Microsoft LC2000 - page 12

    7. Click Next . The system will take a few minutes with the hour clock on th e display before moving to next screen. 8. Click Next at the "Net BIOS Domai n Name" dialo g box to accept d efault " Domain NetB IOS name:" 9. Click Next to accept "Database and Log Locati ons" def ault values: Database Location: C:WINNTNTD ...

  • Microsoft LC2000 - page 13

    Tip #1. Up grading f rom SBS 4.0 t o Small Busi ness Server 2 000 It is possible to upgrade from any edition of NT 4. 0 including Terminal Server to Small Business Server 2000. Please refe r to the readme.doc on th e Small Business Server 2000 CD and the Small Business Server 2000 Setup Guide for in formation on how to perform the upgrades. Tip #2. ...

  • Microsoft LC2000 - page 14

    5. Click "Display a list of known drivers for this device", and then click "Sho w all hardware of this device cl ass". 6. Click the appropr iate computer t y pe (one that matches your curr ent t ype , except for multiple CPUs), click Next , and then click Fin is h . Tip #4. Small B usiness Server 2000 Dr iver Signatures Small Bu ...

  • Microsoft LC2000 - page 15

    5. At the prompt "What do y o u want the wizard to do?", select the "Sea rch for a suitable driver for my device" radio button, and click Next . 6. Select the appropriate me dia checkbox and click nex t. 7. Select the "Install one of the othe r drivers" check box and click Nex t. 8. Select the driver on the fl oppy dri ...

  • Microsoft LC2000 - page 16

    2. Networking disab led. Includes networks services and drivers. 3. Directory se rvices restore mode. Brings system up with director y servi ces disabled with the intent of recovering activ e directory. Safe mode boot is guided by the registry key hklmCurrentControlSetControl Safe Boot w ith the use of the Minimal and Network subkeys. The IOMang ...

  • Microsoft LC2000 - page 17

    8. Type exit when done troubleshooting. Installing RC 1. Insert Small Business Server 2000 CD-ROM. If CD-ROM auto-start is enabled, click exit to close the applet. 2. Open a command prompt and type D:I386WINNT32 /CMDCONS and press Enter . (Where D: is the CD-ROM drive le tter.) 3. Follow the screen instructions to complete the RC installation. Bo ...

  • Microsoft LC2000 - page 18

    Answer: Table 6, provid ed in the appendix of this document provides a list of Disk Arra y BIOS/Firmware versions used to test with Small Business Server 2000. HP recommends that you use the version indicated in this table or a later rele ase. Question: Where do I get the driver's required to run Small Business Server 2000? Answer: The initial ...

  • Microsoft LC2000 - page 19

    E60 Yes Yes Yes E800 Yes Yes Yes LC2000 Yes Yes Yes tc3100 Yes Yes Yes tc4100 Yes Yes Yes Table #2 List of embedded SCSI chip set for each NetServ er. (Note: See "Table #6" fo r a list of tested a nd supported s y st em under Small Business Server 2000) Model SCSI Adapter Ultra SC SI/ Channel A,B E60 Adaptec 7895 (Wide)/A,B E800 Symbios 8 ...

  • Microsoft LC2000 - page 20

    * The driver is not provided b y Hewlett-Packard. Users should use the dri ver bundled with Windows NT CD-ROM. Note: Video adapters wit h 1M can be upgraded to 2M. Table #4 This table provides a list of CD -ROM type for eac h NetServer. ( Note: See "Table #6" fo r a list of tested a nd supported s y st em under Small Business Server 2000) ...

  • Microsoft LC2000 - page 21

    III (1.2- 1.4 GHz) tc4100 N/A Dual Pentium III (1.2- 1.4 GHz) 4G ATIRage XL PCI TBD Yes TBD Table #6A This table provides a list of Disk Array Adap ters tested with Sm all Business Server 2000. Adapter P/N BIOS Firmware Win 2K Support Max Boot Drive Si ze (1) NetRaid-4M D9161A V2.4-0 N/A Yes N/A NetRaid-2M P3411A G.01.02 H.01.07 Yes N/A NetRaid-1M ...

  • Microsoft LC2000 - page 22

    tc3100 No No No No Yes Yes No tc4100 No No No No Yes Yes Yes Table #6C List of NeRAID-4M, 2M and 1M adapters supported with Small Business Server 2000. Model Max 4Ms Support ed Max 2Ms Support ed Max 1Ms Support ed Slotting preferen ces E60 None 3 6 N/A E800 None 3 6 N/A LC2000 2 3 6 Slots 5-6 because 5- 6 are 64 bit slots, 1-4 are 32 bit slots, an ...

Fabricant Microsoft Catégorie Server

Les documents que nous recevons du fabricant de l'appareilMicrosoft LC2000 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Microsoft
- manuels d’utilisations LC2000
- fiches produit Microsoft
- dépliants
- ou étiquettes-énergie Microsoft LC2000
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Microsoft LC2000.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Microsoft LC2000, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Microsoft LC2000. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Microsoft LC2000.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Microsoft LC2000, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Microsoft LC2000 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Microsoft LC2000.

Le manuel d’utilisation complet Microsoft, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Microsoft LC2000 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Microsoft LC2000, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lMicrosoft LC2000 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Microsoft LC2000 - qui devraient nous aider dans les premières étapes lors de l'utilisation Microsoft LC2000
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Microsoft LC2000
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Microsoft LC2000 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Microsoft LC2000?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Microsoft LC2000, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Microsoft LC2000 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)