Français dropdown-ico

Manuel d’utilisation Ei Electronics Ei 405TYC

24 pages 0.9 mb
Télécharger

Aller à la page of 24

Summary
  • Ei Electronics Ei 405TYC - page 1

    1 W ARNING DO NOT INST ALL THE ACTUAL SMOKE ALARM IN NEW OR RENOV A TED BUILDINGS UNTIL ALL WORK IS COMPLETED (INCLUDING FLOOR COVERINGS) AND BUILDING HAS BEEN FULL Y CLEANED. (Excessive dust & debris from building work can contaminate the smoke chamber and cause problems). An installed smoke alarm must be removed or covered fully (with a plast ...

  • Ei Electronics Ei 405TYC - page 2

    1. READ THIS FIRST A Smoke Alarm is an early warning device. Used correctly it can give you and your family valuable extra time to escape. ¥ Models Ei405 & Ei405C - connect battery snaps firmly (see fig 1b). Press the test button and horn should sound. ¥ Models Ei405C, Ei405TY & Ei405TYC - slide unit on to mounting plate to connect the ba ...

  • Ei Electronics Ei 405TYC - page 3

    3 ¥ If the Alarm beeps without the red light flashing at the same time then clean unit as this is the automatic test fea- ture indicating the chamber is degraded. ¥ Plan your escape route. ¥ Proper protection usually requires more than one Smoke Alarm. ¥ If you have any doubt or query about Smoke Alarms con- sult the supplier or your local Fire ...

  • Ei Electronics Ei 405TYC - page 4

    4 excellent, particularly at night, as it rapidly identifies where the fire is located. This is ideal for larger systems as the dis- turbance in the house can be kept to a minimum e.g. no need to enter all the bedrooms to check to see if the red light is flashing rapidly . 3. LOCA TING YOUR SMOKE ALARM Sufficient smoke must enter your Smoke Alarm b ...

  • Ei Electronics Ei 405TYC - page 5

    Figure 2 : Single storey dwelling Figure 3: Single storey dwelling with separate sleeping areas. In houses with more than one sleeping area, Smoke Alarms should be placed between each sleeping area and the living area (for example, see figure 3). 3.2 Multi Storey Dwellings If your home has more than one floor , at least one alarm should be fitted o ...

  • Ei Electronics Ei 405TYC - page 6

    6 3.3 Recommended Protection For recommended protection you should put individual Smoke Alarms in all the rooms where fire is most likely to break out (apart from the locations to avoid, mentioned below). The living room is the most likely place for a fire to start at night, followed by the kitchen and then the dining room. Y ou should also conside ...

  • Ei Electronics Ei 405TYC - page 7

    7 4.3 On a sloping Ceiling In areas with sloping or peaked ceilings install your Smoke Alarm 0.9m from the highest point measured horizontally (see figure 6), because dead air at the apex may prevent smoke from reaching the unit. 4.4 Locations to Avoid Don t place your Smoke Alarm in any of the following areas: ¥ Bathrooms, kitchen, shower rooms, ...

  • Ei Electronics Ei 405TYC - page 8

    8 If there are frequent nuisance/false alarms it may be neces- sary to re-locate the device away from the source of the fumes. If you installed the smoke alarms as received and did not pro- gram them, you may be receiving an alarm signal from a neighbouring system. This can be easy rectified by house coding your alarms (see section 6.3). Pressing t ...

  • Ei Electronics Ei 405TYC - page 9

    9 If the alarm fails to sound, follow this checklist: ¥ Check the age of the unit - see the replace by label on base of unit. ¥ Check the battery snaps are firmly connected on the Ei405 & Ei405C models (see fig 1b). ¥ On the Ei405TY & Ei405TYC models ensure the unit is pushed fully home on the mounting plate, as this connects the battery ...

  • Ei Electronics Ei 405TYC - page 10

    10 Program Procedure 1. Press the test button on the first installed unit three times within 1.5 seconds. The blue light will come on momentarily each time to show the button is operating. (If the horn sounds during these short button depressions, just ignore it). The blue light will now flash once every 5 seconds. The unit now sends a radio messag ...

  • Ei Electronics Ei 405TYC - page 11

    11 Clear the serial numbers learned by: - disconnecting the battery - waiting 10 seconds - holding the test button down while re-connecting the battery snaps to the Ei405 & Ei405C only . With the Ei405TY & Ei405TYC models hold the test button down while sliding it on to the mounting plate. Then put it into the program mode by pressing the t ...

  • Ei Electronics Ei 405TYC - page 12

    12 The unit can be quickly removed from the program mode by holding down the T est & Locate buttons simultaneously . (The house coding can be removed, if necessary , from the remote control by first disconnecting the battery for 10 sec- onds and then reconnecting the battery while holding down both the T est & Locate buttons). 6.5 Power Ind ...

  • Ei Electronics Ei 405TYC - page 13

    13 6.8 Automatic Self-T est The smoke chamber automatically tests itself every 40 sec- onds. If the chamber is degraded it will beep without the red light flashing at the same time. If this happens clean the unit. If the beeping persists and the beep does not coincide with an red light flash, return the unit for service (see Getting your Smoke Alar ...

  • Ei Electronics Ei 405TYC - page 14

    14 (ii) Low Battery beeps (Model Ei 405TY & Ei405TYC only) The unit is giving a short beep every 40 seconds and the red light flashes at the same time for longer than 1 hour . (If the unit beeps without the red light flashing at the same time see Cleaning your Smoke Alarm above). (iii) The unit fails to sound the horn loudly when the test but- ...

  • Ei Electronics Ei 405TYC - page 15

    15 A maximum of 250 metres (820ft) of signal cable can be used, (maximum resistance between detectors 50 ohm). The units are interconnected by wiring all the terminals marked 1 together , and all the terminals marked 2 together (as in fig 8) before screwing the mounting plate to ceiling. Draughts, through the ceiling, from wiring openings, conduit, ...

  • Ei Electronics Ei 405TYC - page 16

    16 ¥ Constant exposure to high or freezing temperatures, high humidity or a high level of nuisance alarms may reduce the life of the battery . ¥ Nuisance alarms can be quickly silenced by fanning vigor- ously with a newspaper or similar to remove the smoke or press the test / hush button. ¥ Do not attempt to remove, recharge or burn the battery ...

  • Ei Electronics Ei 405TYC - page 17

    17 ¥ Smoke Alarms may not detect every type of fire to give suf- ficient early warning. They are particularly inef fective with: fires caused by smoking in bed, escaping gas, violent explosions. poor storage of flammable rags and/or liquids, (for example petrol, paint, spirits etc), overloaded electrical circuits, arson, children playing with matc ...

  • Ei Electronics Ei 405TYC - page 18

    18 8.2 FIRE SAFETY HINTS Store petrol and other flammable materials in proper contain- ers. Discard oily or flammable rags. Always use a metal fireplace screen and have chimneys cleaned regularly . Replace worn or damaged sockets, switches, home wiring and cracked or frayed electrical cords and plugs. Do not overload electrical circuits. Keep match ...

  • Ei Electronics Ei 405TYC - page 19

    19 The Home Office states (in FB2): If your home has more than one floor , at least one alarm should be fitted on each level. In this case, a combination of Optical and Ionisation alarms, preferably interconnected, will give the best protection. 1 1. GETTING YOUR SMOKE ALARM SERVICED If your Smoke Alarm fails to work after you have read the sec- ti ...

  • Ei Electronics Ei 405TYC - page 20

    20 13. TECHNICAL SPECIFICA TION Battery: Replaceable 9 V olt Alkaline Duracell (Ei405 & 405C only) MN1604, Energizer 522 or Eveready 522. Battery Life: Battery can power unit in standby for over (Ei405 & 405C only) a year . Battery: Built-in Lithium Battery . (Ei405TY & Ei405TYC only) Battery Life: Lasts up to 10 Y ears. (Ei405TY & ...

  • Ei Electronics Ei 405TYC - page 21

    21 RF RECEPTION External Alarm RF Signal: T urns on horn without red light flashing until it fails to receive alarm confirmation for 1 1 seconds. Stops horn within 3 sec- onds, on receipt of an "Alarm "Cancel" sig- nal (from any unit). Receiver remains on "continuously" for 1 1 seconds to check for further alarm signals. Le ...

  • Ei Electronics Ei 405TYC - page 22

    22 The blue light will turn on as the button is pressed. Program Mode: Number of fast flashes every 5 seconds indicates number of units (including remote keyfob, Ei410, if used) in system Clearing House Codes: Th e s erial numbers memorised, can be deleted (i.e. the smoke alarms can be uncoded) by powering down the unit and disconnecting the batter ...

  • Ei Electronics Ei 405TYC - page 23

    23 ...

  • Ei Electronics Ei 405TYC - page 24

    24 ...

Fabricant Ei Electronics Catégorie Smoke Alarm

Les documents que nous recevons du fabricant de l'appareilEi Electronics Ei 405TYC peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Ei Electronics
- manuels d’utilisations Ei 405TYC
- fiches produit Ei Electronics
- dépliants
- ou étiquettes-énergie Ei Electronics Ei 405TYC
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Ei Electronics Ei 405TYC.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Ei Electronics Ei 405TYC, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Ei Electronics Ei 405TYC. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Ei Electronics Ei 405TYC.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Ei Electronics Ei 405TYC, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Ei Electronics Ei 405TYC par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Ei Electronics Ei 405TYC.

Le manuel d’utilisation complet Ei Electronics, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Ei Electronics Ei 405TYC - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Ei Electronics Ei 405TYC, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lEi Electronics Ei 405TYC qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Ei Electronics Ei 405TYC - qui devraient nous aider dans les premières étapes lors de l'utilisation Ei Electronics Ei 405TYC
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Ei Electronics Ei 405TYC
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Ei Electronics Ei 405TYC dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Ei Electronics Ei 405TYC?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Ei Electronics Ei 405TYC, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Ei Electronics Ei 405TYC il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)