Manuel d’utilisation Texas Instruments SLUU477

13 pages 0.21 mb
Télécharger

Aller à la page of 13

Summary
  • Texas Instruments SLUU477 - page 1

    User's Guide SLUU477 – December 2010 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path This user's guide describes the features and operation of the bq24210EVM Evaluation Module (EVM). The EVM assists users in evaluating the bq24210 solar chager. The EVM is also called the HPA678. The manual includes the bq24 ...

  • Texas Instruments SLUU477 - page 2

    Introduction www.ti.com 1 Introduction 1.1 EVM Features • Evaluation Module for bq24210 • 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path • Resistor-programmable setting for charge current and input voltage dynamic power management • LED Indication for Status • Test Points for Key Signals Available for Testin ...

  • Texas Instruments SLUU477 - page 3

    ( ) D PM D PM _ 1 VD PM D PM VBU S_ VBUS _ R = K VBUS_ - I SE T I SET O U T K R = I www.ti.com Introduction 1.4 Control and Key Parameters Setting Table 2. Control and Key Parameters Setting Jack Description Factory Setting JP1 Programs the fast-charge current setting. 500mA when JP1 ON; external setting Jumper OFF (external setting) when JP1 OFF J ...

  • Texas Instruments SLUU477 - page 4

    Test Summary www.ti.com 2 Test Summary 2.1 Definitions This procedure details how to configure the HPA678 evaluation board. On the test procedure, the following naming conventions are followed. VXXX : External voltage supply name (VBUS, VBAT) LOADW: External load name (LOADR, LOADI) V(TPyyy): Voltage at internal test point (TPyyy). For example, V(T ...

  • Texas Instruments SLUU477 - page 5

    BQ24210 EVM HP A678 GND J1 VBUS J2 GND BA T APPLICATION CIRCUIT U1 V Iin I Power supply #1 IBAT V Load #1 I TS PG JP1 D1 LED CHG D2 J4 JP4 JP5 JP7 JP6 JP2 J3 JP3 www.ti.com Test Summary 2.5 Equipment 2.5.1 Power Supplies Power Supply #1 (PS#1): a power supply capable of supplying 20-V at 1-A is required. 2.5.2 Loads LOAD #1 A 20V (or above), 1A (or ...

  • Texas Instruments SLUU477 - page 6

    PCB Layout Guideline www.ti.com 2.7 Procedure 2.7.1 Power Supply Make sure EQUIPMENT SETUP steps are followed. Disconnect LOAD #1. Turn on PS#1. Measure → V(J1(VBUS)) = 6.5V ± 200mV Measure → V(J2(VBAT)) = 0V ± 200mV Measure → V(J4(VTSB)) = 0V ± 200mV Observe → D1 (PG) ON, D2 (CHG) OFF 2.7.2 Charger Enable and Battery Detection Connect J ...

  • Texas Instruments SLUU477 - page 7

    www.ti.com Bill of Materials, Board Layout and Schematics 4 Bill of Materials, Board Layout and Schematics 4.1 Bill of Materials Table 4. Bill of Materials -001 RefDes Value Description SIZE Part Number MFR 1 C1 10 µ F Capacitor, Ceramic, 25V,X7R, 10% 1206 STD STD 2 C2, C4 0.1 µF Capacitor, Ceramic, 25V, X7R, 10% 0603 STD STD 1 C3 10 µF Capacito ...

  • Texas Instruments SLUU477 - page 8

    Bill of Materials, Board Layout and Schematics www.ti.com 4.2 Board Layout Figure 2. Top Assembly 8 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path SLUU477 – December 2010 Submit Documentation Feedback © 2010, Texas Instruments Incorporated ...

  • Texas Instruments SLUU477 - page 9

    www.ti.com Bill of Materials, Board Layout and Schematics Figure 3. Top Layer 9 SLUU477 – December 2010 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path Submit Documentation Feedback © 2010, Texas Instruments Incorporated ...

  • Texas Instruments SLUU477 - page 10

    Bill of Materials, Board Layout and Schematics www.ti.com Figure 4. Bottom Layer 10 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path SLUU477 – December 2010 Submit Documentation Feedback © 2010, Texas Instruments Incorporated ...

  • Texas Instruments SLUU477 - page 11

    www.ti.com Bill of Materials, Board Layout and Schematics 4.3 Schematics Figure 5. bq24210 EVM Schematic 11 SLUU477 – December 2010 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path Submit Documentation Feedback © 2010, Texas Instruments Incorporated ...

  • Texas Instruments SLUU477 - page 12

    Evaluation Board/Kit Important Notice Texas Instruments (TI) provides the enclosed product(s) under the following conditions: This evaluation board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR EVALUATION PURPOSES ONLY and is not considered by TI to be a finished end-product fit for general consumer use. Persons handling th ...

  • Texas Instruments SLUU477 - page 13

    IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or service without notice. Customers should obtain the latest relevant information before placing orders ...

Fabricant Texas Instruments Catégorie Automobile Battery Charger

Les documents que nous recevons du fabricant de l'appareilTexas Instruments SLUU477 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Texas Instruments
- manuels d’utilisations SLUU477
- fiches produit Texas Instruments
- dépliants
- ou étiquettes-énergie Texas Instruments SLUU477
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Texas Instruments SLUU477.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Texas Instruments SLUU477, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Texas Instruments SLUU477. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Texas Instruments SLUU477.

Manuel d’utilisation complet de l’appareil Texas Instruments SLUU477, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Texas Instruments SLUU477 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Texas Instruments SLUU477.

Le manuel d’utilisation complet Texas Instruments, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Texas Instruments SLUU477 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Texas Instruments SLUU477, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lTexas Instruments SLUU477 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Texas Instruments SLUU477 - qui devraient nous aider dans les premières étapes lors de l'utilisation Texas Instruments SLUU477
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Texas Instruments SLUU477
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Texas Instruments SLUU477 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Texas Instruments SLUU477?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Texas Instruments SLUU477, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Texas Instruments SLUU477 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (1)

Jim

Hello, my name is James and I was just looking your website usermanuals.org over and thought I would message you on your contact form and offer some help. I really like your site but I noticed you weren’t getting a lot of traffic and your Alexa ranking isn’t as strong as it could be. Fortunately, I may have an answer for you. I can get you 1,000’s of visitors looking at usermanuals.org ready to buy your product, service or sign up for an offer and fast. Our advertising network of over 9000 websites provides a low cost and effective online marketing solutions that actually works. I can help your business get more online quality traffic by advertising your business on websites that are targeted to your specific market. The Internet is vast but you don’t have to spend huge amounts of cash to jump start your business. I can get you 10,000 highly targeted visitors directly to your website for as little as $39.00 for a 30 day trial run. https://worldtrafficsolutions.xyz It has taken us 12 years to perfect our system and in addition to being exciting, it works!! We also have a special offer of 200,000 Targeted visitors spread over 60 days for a special one time charge of $299.00. https://worldtrafficsolutions.xyz Also check out the short video here and see how everything works. Best Regards support@worldtrafficsolutions.xyz WorldTrafficSolutions.xyz https://worldtrafficsolutions.xyz To be placed on our removal list please visit: https://zfrmz.com/vTN2gJq4qHlWtaZ1YFQO