-
JVC LVT1115-003B - page 1
LVT1115-003B [B] INSTR UCTIONS MICR O COMPONENT SYSTEM UX-H9 —Consists of CA-UXH9 and SP-UXH9 TIMER SET RANDOM SLEEP INTRO / RDS SEARCH STANDBY/ON TIMER ON/OFF REMAIN /RDS MODE BEAT CUT DISPLAY /CLOCK SET MUTING RM-SUXH9R REMOTE CONTROL SOUND /BASS CD TAPE CD VOLUME TUNER /BAND REPEAT ST/MONO PROGRAM STANDBY/ON STANDBY OPEN VOLUME MICRO COMPONENT ...
-
JVC LVT1115-003B - page 2
W arnings, Cautions and Others IMPORT ANT for the U .K. DO NO T cut off the mains plug from this equipment. If the plug fitted is not suitable f or the power points in y our home or the cable is too short to reach a power point, then obtain an appro- priate safety appro ved extension lead or consult y our dealer . BE SURE to replace the fuse only w ...
-
JVC LVT1115-003B - page 3
G-2 SAFETY INSTR UCTIONS “ SOME DOS AND DON ’ TS ON THE SAFE USE OF EQUIPMENT ” This equipment has been designed and manuf actured to meet international safety standards but, lik e any electrical equipment, care must be taken if y ou are to obtain the best results and saf ety is to be assured. Do read the operating instructions before y ou at ...
-
JVC LVT1115-003B - page 4
1 Power sources • When unplugging the unit from the wall outlet, alw ays pull on the plug, not the A C po wer cord. DO NO T handle the A C power cord with wet hands. Moisture condensation Moisture may condense on the lenses inside the unit in the following cases: • After starting to heat the room. • In a damp room. • If the unit is brought ...
-
JVC LVT1115-003B - page 5
2 Contents Location of the Buttons and Controls ............................. 3 Main unit ................................................................................... 3 Remote Control ......................................................................... 5 Getting Started .................................................................. ...
-
JVC LVT1115-003B - page 6
3 Location of the Buttons and Controls Become familiar with the b uttons and controls on your unit. Main Unit TIMER ON/OFF PHONES SOUND /BASS BAND OPEN MULTI CONTROL CD CONTROL TAPE TUNER CD 1 2 3 4 5 6 7 8 STANDBY/ON STANDBY OPEN VOLUME MICRO COMPONENT SYSTEM CD SYNCHRO RECORDING 9 p q w e r t y T op view Front view Inside the front cover EN01-05_ ...
-
JVC LVT1115-003B - page 7
4 ON OFF 1ALL PROG RANDOM INTR O T O T AL REMAIN CD MHz kHz SYNC SLEEP ST MONO SOUND BASS 12 3 4 56 7 t e w q p r 9 8 Display window on the front panel Display window 1 (timer) indicator 2 ON/OFF (timer on-time/off-time) indica tors 3 SLEEP indicator 4 FM mode indicators • ST (stereo), MONO 5 SOUND indicator 6 BASS indicator 7 RDS indicator 8 CD ...
-
JVC LVT1115-003B - page 8
5 TIMER SET RANDOM SLEEP INTRO / RDS SEARCH STANDBY/ON TIMER ON/OFF REMAIN /RDS MODE BEAT CUT DISPLAY /CLOCK SET MUTING RM-SUXH9R REMOTE CONTROL SOUND /BASS CD TAPE CD VOLUME TUNER /BAND REPEAT ST/MONO PROGRAM 1 2 3 4 5 6 7 8 u y t r e w q p 9 Remote Control See pages in parentheses for details. STANDBY/ON STANDBY VOLUME MICRO COMPONENT SYSTEM CD S ...
-
JVC LVT1115-003B - page 9
6 Getting Started Unpacking After unpacking, check to be sure that you ha ve all the follo wing items. The number in parentheses indicates the quantity of each piece supplied. • AM (MW) loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately . Putting the Batteries into the Remote Control ...
-
JVC LVT1115-003B - page 10
7 T o connect AM (MW) and FM antennas 1 Connect the supplied AM (MW) loop antenna to the AM LOOP terminal. Place the antenna aw ay from the unit and adjust its position for the best reception. 2 Adjust the position f or the FM antenna f or the best reception. For better r eception of both FM and AM (MW) • Make sure the antenna conductors do not t ...
-
JVC LVT1115-003B - page 11
8 Basic and Common Operations Setting the Clock Before operating the unit any further , f irst set the unit’ s clock. When you plug in the po wer cord, “0:00” starts flashing on the display . Y ou can set the clock when the unit is either turned on or in standby mode. On the r emote control ONL Y : 1 When the unit is in standby mode, press an ...
-
JVC LVT1115-003B - page 12
9 Selecting the Sound Modes Y ou can select one of the 4 sound modes. • This function also af fects the sound from headphones. • This function only af fects the playback sound, and does not af fect your recording. T o select the sound modes, press SOUND/B ASS repeatedly . • Each time you press the button, the sound mode changes as follows: PO ...
-
JVC LVT1115-003B - page 13
10 T uning in to a Station 1 Pr ess TUNER/B AND to select either “FM” or “AM. ” The unit automatically turns on and tunes in to the previously recei v ed station—either FM or AM (MW). • Each time you press the button, the band alternates between FM and AM (MW). 2 Pr ess and hold ¢ or 4 (or ¡ / ¢ or 4 / 1 on the unit) f or more than 1 ...
-
JVC LVT1115-003B - page 14
11 Presetting Stations Y ou can preset 20 FM and 20 AM (MW) stations manually . In some cases, test frequencies hav e been already stored for the tuner since the factory e xamined the tuner preset function before shipment. This is not a malfunction. Y ou can preset the stations you want into memory by following the presetting method. • There is a ...
-
JVC LVT1115-003B - page 15
12 RDS (Radio Data System) allo ws FM stations to send an additional signal along with their regular pr ogram signals. For e xample, the stations send their station names, as well as information about what type of program the y broadcast, such as sports or music, etc. When tuned in to an FM station which pro vides the RDS service, the RDS indicator ...
-
JVC LVT1115-003B - page 16
13 Playing Back the Entire Disc—Normal Play 1 Pr ess 0 OPEN on the unit. The disc cov er opens. • Y ou can insert a disc while listening to another source. 2 Place a disc corr ectly with its label side up. 3 Close the disc cov er gently . Playing Back Discs This unit has been designed to play back the follo wing discs—CD, CD-R, and CD-R W . W ...
-
JVC LVT1115-003B - page 17
14 Basic Disc Operations While playing a disc, you can do the follo wing operations. T o stop playing for a moment During play , press CD 3 / 8 . While pausing, the elapsed playing time flashes on the display . T o resume playing, press CD 3 / 8 again. T o go to another track Before or during play , press ¢ or 4 repeatedly . • ¢ : Skips to the ...
-
JVC LVT1115-003B - page 18
15 Playing at Random — Random Play Y ou can play the tracks at random. On the r emote control ONL Y : Press RANDOM bef or e or during playing. The RANDOM indicator lights up on the display . RANDOM T o exit from Random Play , press RANDOM again. The RANDOM indicator goes of f. • It is not possible to activ ate the random play function during Pr ...
-
JVC LVT1115-003B - page 19
16 For T ape operations, use buttons inside the front co ver on the unit. Playing Back a T ape Y ou can play back type I ta pes only . On the unit ONL Y : 1 Open the front co ver . 2 Press & / ) (stop/cassette holder open). The cassette holder opens. 3 Put a cassette in with the exposed part of the tape down. Playing Back T apes 5 Pr ess T APE. ...
-
JVC LVT1115-003B - page 20
17 IMPORT ANT : • It should be noted that it may be unlawful to re-r ecord pr e-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video recording , broadcast or cable pr ogram and in any literary , dramatic, musical, or artistic embodied therein. • The recording lev el is automatically set correctly ...
-
JVC LVT1115-003B - page 21
18 Recording Discs — Disc Synchronized Recording Y ou can start disc play and recording at the same time. On the unit ONL Y : 1 Put a r ecordable cassette in with the exposed part of the tape down. • See also page 16. 2 Close the cassette holder gently . 3 Pr ess CD select the CD player as the source. 4 Pr ess ‡ (recording). The CD SYNC indic ...
-
JVC LVT1115-003B - page 22
19 Using the T imers On the r emote control ONL Y : 1 Pr ess TIMER SET . The (timer) and the ON (on-time) indicators flash and the on-time setting appears on the display . If you does not need to change the on-time setting, go to step 3 . 2 Pr ess PROGRAM to set the on-time y ou want the unit to turn on. The hour indication starts flashing on the d ...
-
JVC LVT1115-003B - page 23
20 9 Pr ess ST ANDBY/ON to turn off the unit if the unit is on. T o deactiv ate the timer temporarily , press TIMER ON/OFF until the (timer) indicator goes of f. T o activ ate and change the timer , repeat steps 1 to 8 on pages 19 and 20. • T o activ ate the timer again without changing the setting, press TIMER ON/OFF until the (timer) indicator ...
-
JVC LVT1115-003B - page 24
21 Maintenance T o get the best performance of the unit, keep your discs, tapes and mechanism clean. General Notes In general, you will hav e the best performance by keeping your discs, tapes and the mechanism clean. • Store discs and tapes in their cases, and keep them in cabinets or on shelves. Cleaning the unit • Stains on the unit Should be ...
-
JVC LVT1115-003B - page 25
22 If you are ha ving a problem with your unit, check this list for a possible solution before calling for ser vice. If you cannot solve the problem from the hints gi ven here, or the unit has been ph ysically damaged, call a qualified person, such as your dealer , for service. T roubleshooting Symptom Power does not come on. No sound is heard. Har ...
-
JVC LVT1115-003B - page 26
VICTOR COMP ANY OF JAP AN , LIMITED EN 0603MWMMDWORI J V C © 2003 VICTOR COMPANY OF JAPAN, LIMITED COVER_UX-H9[B]f.p65 03.6.23, 11:39 AM 2 ...
Avez-vous une question à propos de JVC LVT1115-003B?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec JVC LVT1115-003B, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec JVC LVT1115-003B il est probable qu’il a envie de partager la façon de le résoudre.