Manuel d’utilisation Desa CGN12

24 pages 0.2 mb
Télécharger

Aller à la page of 24

Summary
  • Desa CGN12 - page 1

    OWNER’S OPERA TION AND INST ALLA TION MANUAL ® VENT -FREE NA TURAL GAS HEA TER Model: CGN12 Save this manual for future reference WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, per- sonal injury, or loss of life. — Do not store or use gasoline or other flammable vapor ...

  • Desa CGN12 - page 2

    2 CONTENTS SECTION PAGE Safety Information ......................................................................... 2 Product Identification .................................................................... 4 Local Codes ................................................................................... 4 Unpacking ............................. ...

  • Desa CGN12 - page 3

    3 SAFETY INFORMA TION Continued ! WARNING ICON G 001 W ARNINGS Continued 1. Use only natural gas. Do not convert heater to use different fuel type. 2. If you smell gas • shut off gas supply • do not try to light any appliance • do not touch any electrical switch; do not use any phone in your building • immediately call your gas supplier fro ...

  • Desa CGN12 - page 4

    4 PRODUCT IDENTIFICA TION LOCAL CODES Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223.1, also known as NFPA 54*. *Available from: American National Standards Institute, Inc. 1430 Broadway New York, NY 10018 National Fire Protection Association, I ...

  • Desa CGN12 - page 5

    5 INST ALLING T O W ALL NOTICE A qualified service person must install heater. Follow all local codes. Continued CHECK GAS TYPE Use only natural gas. If your gas supply is not natural, do not install heater. Call dealer where you bought heater for proper type heater. INSTALLATION ITEMS Before installing heater, make sure you have the items listed b ...

  • Desa CGN12 - page 6

    6 ! WARNING ICON G 001 W ARNING Maintain minimum clearances shown in Figure 3. If you can, provide greater clearances from floor and joining wall. 2. Mark two mounting screw locations on wall (see Figure 3). INSTALLING HEATER TO WALL Marking Screw Locations 1. Determine where you will locate heater. Figure 3 - Mounting Screw Locations Mounting Scre ...

  • Desa CGN12 - page 7

    7 Installing Two Mounting Screws Note: Wall anchors and mounting screws are in hardware package. The hardware package is provided with heater. Attaching to wall stud method For attaching mounting screw to wall stud 1. Drill hole at marked location using 9/64" drill bit. 2. Insert mounting screw into wall stud. 3. Tighten screw until 1/16" ...

  • Desa CGN12 - page 8

    8 Placing Heater On Mounting Screws 1. Locate two keyhole slots on back panel of heater (see Figure 7). 2. Place large openings of slots over screwheads. Slide heater down until screws are in small portion of slots. Figure 9 - Installing Bottom Mounting Screw Removing Front Panel Of Heater 1. Remove two screws near bottom corners of front panel. 2. ...

  • Desa CGN12 - page 9

    9 ! WARNING ICON G 001 W ARNING Never connect heater to private (non-utility) gas wells. This gas is commonly known as well-head gas. NOTICE A qualified service person must connect heater to gas supply. Follow all local codes. CONNECTING T O GAS SUPPL Y IMPORTANT: Check gas line pressure before connecting heater to gas line. Gas line pressure must ...

  • Desa CGN12 - page 10

    10 ! WARNING ICON G 001 W ARNING Test all gas piping and connections for leaks after installing or servicing. Correct all leaks at once. Manual Shutoff Valve * IMPORTANT: Hold pressure regulator with wrench when connecting it to gas piping and/or fittings. Figure 10 - Gas Connection * An A.G.A. design-certified manual shutoff valve with 1/8" N ...

  • Desa CGN12 - page 11

    11 4. Check all joints of gas supply piping system. Apply mixture of liquid soap and water to gas joints. Bubbles forming show a leak. 5. Correct all leaks at once. Test Pressures Equal To or Less Than 1/2 PSIG 1. Close manual shutoff valve (see Figure 11). 2. Pressurize supply piping system by either using compressed air or opening main gas valve ...

  • Desa CGN12 - page 12

    12 OPERA TING HEA TER FOR YOUR SAFETY READ BEFORE LIGHTING A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. WHAT ...

  • Desa CGN12 - page 13

    13 4. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information at the top of page 12. If you don’t smell gas, go to the next step. 5. Press in control knob. Note: You may be running this heater for the first time after hooking up to gas supply. If so ...

  • Desa CGN12 - page 14

    14 TO SELECT HEATING LEVEL 1. Slightly press in control knob and turn counterclockwise to the LOW or HIGH positions. IMPORTANT: Release downward pressure while turning control knob. Control knob will lock at the desired position. C-clockwise Control Knobs Burners LOW OFF PILOT IGN HIGH OFF PILOT IGN OFF Figure 15 - Burner Patterns ! WARNING ICON G ...

  • Desa CGN12 - page 15

    15 GRH/OV 009 GOOD PILOT GRH/OV 010 BAD PILOT Shutting Off Heater 1. Turn control knob clockwise to the OFF position. Shutting Off Burner Only (pilot stays lit) 1. Turn control knob clockwise to the PILOT position. MANUAL LIGHTING PROCEDURE 1. Remove front panel (see Figure 8, page 8). 2. Follow steps 1 through 6 under LIGHTING INSTRUCTIONS, pages ...

  • Desa CGN12 - page 16

    16 BURNER FLAME PATTERN Figure 18 shows a correct burner flame pattern. Figure 19 shows an incorrect burner flame pattern. Figure 18 - Correct Burner Flame Pattern Figure 19 - Incorrect Burner Flame Pattern If burner flame pattern is incorrect, as shown in Figure 19 • turn heater off (see TO TURN OFF GAS TO APPLIANCE, page 15) • see TROUBLESHOO ...

  • Desa CGN12 - page 17

    17 CLEANING AND MAINTENANCE ODS/PILOT AND BURNER ORIFICE • Use a vacuum cleaner, pressurized air, or small, soft bristled brush to clean. CABINET Air Passageways • Use a vacuum cleaner or pressurized air to clean. Exterior • Use a soft cloth dampened with a mild soap and water mixture. Wipe the cabinet to remove dust. OBSERVED PROBLEM When co ...

  • Desa CGN12 - page 18

    18 REMEDY 1. Turn on gas supply or open manual shutoff valve 2. Press in control knob while turning to PILOT/ IGN position 3. Continue holding down control knob. Repeat ig- niting operation until air is removed 4. Clean ODS/pilot (see CLEANING AND MAINTENANCE, page 17) or replace ODS/pilot assembly 5. Replace gas regulator 1. Press in control knob ...

  • Desa CGN12 - page 19

    19 OBSERVED PROBLEM Burner(s) does not light after ODS/pilot is lit Delayed ignition of burner(s) Burner backfiring during combustion Burner plaque(s) does not glow Slight smoke or odor during initial opera- tion Heater produces a clicking/ticking noise just after burner is lit or shut off REMEDY 1. Clean burner orifice(s) (see CLEANING AND MAINTEN ...

  • Desa CGN12 - page 20

    20 POSSIBLE CAUSE 1. Heater burning vapors from paint, hair spray, glues, etc. 2. Gas leak. See Warn- ing statement at top of page 1. Not enough fresh air is available 2. Low line pressure 3. ODS/pilot is partially clogged 1. Gas leak. See Warn- ing statement at top of page 2. Control valve defective 1. Foreign matter between control valve and burn ...

  • Desa CGN12 - page 21

    21 SPECIFICA TIONS B.T.U. (Variable) 6,000/12,000 Type Gas Natural Only Ignition Piezo Pressure Regulator Setting 3" W.C. Inlet Gas Pressure (inches of water) Maximum 10.5" Minimum 4" Dimensions, Inches (H x W x D) Heater 20 1/2 x 13 1/2 x 5 Carton 25 x 16 11/16 x 7 1/2 Weight (pounds) Heater 14 Shipping 17 Note: Use only original re ...

  • Desa CGN12 - page 22

    22 These Parts Centrals are privately owned businesses. They have agreed to support our customer’s needs by providing original replacement parts and accessories. P ARTS CENTRALS Albany Ladder 1586 Central Avenue Albany, NY 12205 (518) 869-5335 Parts Department 1-800-354-7368 Cans Unlimited, Inc. P.O. Box 645 Taylor, SC 29687 (803) 879-3009 U.S. 1 ...

  • Desa CGN12 - page 23

    23 KEY PART NO. NUMBER DESCRIPTION QTY. 13 099391-02 Tubing - Regulator to valve 1 14 099385-01 Control Valve 1 15 099057-01 Pressure Tap Fitting 1 16 098276-01 1/8 Pipe Plug 1 17 099468-02 Cabinet Assembly 1 18 099415-01 Gas Regulator 1 19 098303-02 Screw, #6 x 5/16" 2 20 098508-01 Valve Retainer Nut 1 21 099393-01 Control Knob 1 22 M11084-26 ...

  • Desa CGN12 - page 24

    LIMITED WARRANTY COMFORT GLOW VENT-FREE RESIDENTIAL GAS HEATERS DESA International warrants this product to be free from defects in materials and components for one (1) year from the date of first purchase, provided that the product has been properly installed, operated and maintained in accordance with all applicable instructions. To make a claim ...

Fabricant Desa Catégorie Outdoor Fireplace

Les documents que nous recevons du fabricant de l'appareilDesa CGN12 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Desa
- manuels d’utilisations CGN12
- fiches produit Desa
- dépliants
- ou étiquettes-énergie Desa CGN12
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Desa CGN12.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Desa CGN12, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Desa CGN12. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Desa CGN12.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Desa CGN12, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Desa CGN12 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Desa CGN12.

Le manuel d’utilisation complet Desa, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Desa CGN12 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Desa CGN12, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lDesa CGN12 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Desa CGN12 - qui devraient nous aider dans les premières étapes lors de l'utilisation Desa CGN12
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Desa CGN12
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Desa CGN12 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Desa CGN12?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Desa CGN12, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Desa CGN12 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)