Français dropdown-ico

Manuel d’utilisation Wagner SprayTech Power Painter

19 pages Non applicable
Télécharger

Aller à la page of 19

Summary
  • Wagner SprayTech Power Painter - page 1

    English Owner’s Manual Read this manual for complete instructions Table of Contents Safety Information ................................................... 2 What’s in the Box .................................................... 3 Before you Begin ..................................................... 4 Selecting the proper spray tip............. ...

  • Wagner SprayTech Power Painter - page 2

    This symbol indicates a hazardous situation, which, if not not avoided could result in death or serious injury. HAZARD: INJECTION INJURY A high pressure stream of paint produced by this equipment can pierce the skin and underlying tissues, leading to serious injury and possible amputation. DO NOT TREAT AN INJECTION INJURY AS A SIMPLE CUT! Injection ...

  • Wagner SprayTech Power Painter - page 3

    3 English Important Safety Information · Read all safety information before operating the equipment. SAVE THESE INSTRUCTIONS. Grounding Instructions This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped ...

  • Wagner SprayTech Power Painter - page 4

    English 4 Before You Begin Important Preparation Tips: Selecting the Proper Spray Tip: • It is important to mix the material thoroughly before you begin. Do not shake the material to mix it. Always stir the material gently but thoroughly before use. • Remove any skin that has formed on the top of the material. Do not mix the skin into the mater ...

  • Wagner SprayTech Power Painter - page 5

    5 English Material Container Setup 1. Remove the material container from the pump housing by turning the pump housing ring counterclockwise. 7. Twist the pump housing ring to thread the container onto the pump housing. Plug in the unit. 3. Fill the container with the material to be used. 5. Insert the suction tube into the intake opening. 2. Remove ...

  • Wagner SprayTech Power Painter - page 6

    English 6 Remote Suction Set Setup (optional) 1. Remove the material container from the pump housing by turning the pump housing ring counterclockwise. 7. Submerge the suction tube assembly into the material container and attach the container clip (l) to the side to hold it securely. Make certain the return line (m) is inside the container. 3. Plac ...

  • Wagner SprayTech Power Painter - page 7

    7 English Flow Control Knob / Practice Spraying 1. Turn the ow knob fully counterclockwise to maximum. 3. Turn the ow knob clockwise until you have a good spray pattern. 2. Point the sprayer at a scrap piece of wood or cardboard, and pull the trigger to prime the sprayer. Release trigger when material sprays evenly from the spray gun. 4. A po ...

  • Wagner SprayTech Power Painter - page 8

    English 8 Title Usage Overspray: Priming with the Remote Suction Set: 1. If you are using the remote suction set, you will need to prime the sprayer by removing air from the system. To prime: Make sure the sprayer is plugged in, and turn the ow control knob counterclockwise to maximum. 3. Aim the sprayer at a piece of scrap wood or cardboard. Sq ...

  • Wagner SprayTech Power Painter - page 9

    9 English Title Spraying Technique 1. Keep your arm moving at constant speed and keep the sprayer at a constant distance from the surface. The sprayer should be triggered at the beginning of the stroke and released at the end of the stroke. 2. Keep the sprayer at right angles to the surface. This means moving your entire arm back and forth rather t ...

  • Wagner SprayTech Power Painter - page 10

    English 10 Title Using the Quick Flush Lid (latex materials only) Cleaning the material container: 1. Unplug the sprayer. Pour the remaining material back into the original container. Remove the suction tube. 4. Slide the pump housing assembly off the sprayer. Remove the piston and spring from the pump housing. Place all removed parts (except the p ...

  • Wagner SprayTech Power Painter - page 11

    11 English Title Using the Quick Flush Lid (latex materials only) Cleaning the Remote Suction Set: You will need a garden hose to complete the steps below. If you do not have a garden hose available, or if you used oil- based materials, follow the Cleanup for Oil-Based Materials instructions on page 12-13 . 1. To remove any remaining material that ...

  • Wagner SprayTech Power Painter - page 12

    English 12 Title Cleanup - Oil-based Materials Cleaning the Material container: 1. Unplug the sprayer. Pour the remaining material back into the original container. 2. Fill the container half full of the cleaning solution appropriate to the type of material you sprayed (warm, soapy water for latex-based materials; mineral spirits for oil-based mate ...

  • Wagner SprayTech Power Painter - page 13

    13 English Cleanup - Oil-based Materials Cleaning the Remote Suction Set: 1. Make sure the sprayer is unplugged. 2. Remove the suction tube from the material container and submerge into a container of the solvent appropriate to the type of material you sprayed (warm, soapy water for latex-based materials; mineral spirits for oil-based materials. 3. ...

  • Wagner SprayTech Power Painter - page 14

    English 14 Title Cleaning the Components - Oil-based materials Reassembly - all materials 1. Turn the spray tip counterclockwise until it is removed. Pull out the atomizer valve, being careful not to lose it. 1. Slide the spring onto the front end of the piston. 4. Place the locking nut onto the motor housing. Press in while turning the locking nut ...

  • Wagner SprayTech Power Painter - page 15

    15 English Maintenance Replacement Parts 1. Turn the sprayer upside-down while the material container is removed. Squeeze a small amount of standard household oil into both the intake (a) and return (b) openings on the pump housing. Atomizer valve: The atomizer valve is shaped to cause the material to spin as it comes out of the sprayer. The spinni ...

  • Wagner SprayTech Power Painter - page 16

    English 16 Troubleshooting Problem A. Motor will not run. B. Motor has a low hum and does not spray. C. Motor operates properly but does not spray. D. Material spitting or globbing. E. Excessive fogging. F. Runs and sags in paint. G. Material drips from spray tip guard. H. Motor overheats. I. Material leaking from between spray tip and locking nut. ...

  • Wagner SprayTech Power Painter - page 17

    50 Parts list • Liste de pièces • Lista de piezas (i) (a) (g) (h) (j) (p) (q) (r) (m) (b) (c) (d) (e) (f) (k) (l) (n) (o) ...

  • Wagner SprayTech Power Painter - page 18

    51 Parts list • Liste de pièces • Lista de piezas Item Article Articulo Part No. Nº de piéce Pieza No. English Description Français Description Español Descripción Quantity Quantite Cantidad a) ---------- Sprayer assembly Pulvérisateur Rociador 1 b) 0525351 Pump housing ring Anneau du corps de pompe Anillo de la caja de la bomba 1 c) 052 ...

  • Wagner SprayTech Power Painter - page 19

    52 Warranty • Garantie • Garantía Wagner Spray Tech Corporation 1770 Fernbrook Lane Plymouth, Minnesota 55447 Telephone 1-800-328-8251 Copyright © Wagner Spray Tech Corporation. All rights reserved, including right of reproduction in whole or in part, in any form. WAGNER ONE-YEAR LIMITED WARRANTY - Keep on File This product, manufactured by W ...

Fabricant Wagner SprayTech Catégorie Paint Sprayer

Les documents que nous recevons du fabricant de l'appareilWagner SprayTech Power Painter peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Wagner SprayTech
- manuels d’utilisations Power Painter
- fiches produit Wagner SprayTech
- dépliants
- ou étiquettes-énergie Wagner SprayTech Power Painter
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Wagner SprayTech Power Painter.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Wagner SprayTech Power Painter, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Wagner SprayTech Power Painter. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Wagner SprayTech Power Painter.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Wagner SprayTech Power Painter, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Wagner SprayTech Power Painter par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Wagner SprayTech Power Painter.

Le manuel d’utilisation complet Wagner SprayTech, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Wagner SprayTech Power Painter - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Wagner SprayTech Power Painter, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lWagner SprayTech Power Painter qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Wagner SprayTech Power Painter - qui devraient nous aider dans les premières étapes lors de l'utilisation Wagner SprayTech Power Painter
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Wagner SprayTech Power Painter
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Wagner SprayTech Power Painter dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Wagner SprayTech Power Painter?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Wagner SprayTech Power Painter, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Wagner SprayTech Power Painter il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)