-
Zanussi ZWI 1125 - page 1
EN User manual Washing Machine ZWI 1125 ...
-
Zanussi ZWI 1125 - page 2
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Washing Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Daily ...
-
Zanussi ZWI 1125 - page 3
• If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. • Always be sure, that there is no water leakage from ho- ses and their connections after the installation. • If the appliance is installed in a location subject to frost, please read the “dangers of freezi ...
-
Zanussi ZWI 1125 - page 4
Product description 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adju stable f eet 1 2 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the ...
-
Zanussi ZWI 1125 - page 5
1 2 3 4 5 6 B C A 7 1 Programme selector dial 2 SPIN reduction button 3 OPTIONS button 4 EXTRA RINSE button 5 START/PAUSE button 6 DELAY START button 7 Indicator pilot lights Table of symbols Push buttons Pilot lights Rinse Hold / Prewashing or washing Prewash / Rinsing or spinning Super Quick End Programme selector dial, spin sp eed button and ava ...
-
Zanussi ZWI 1125 - page 6
Start Pause This button allows you to start or to interrupt the selected programme. Delay Start The start of the programme can be delayed by 3, 6 or 9 hours by means of this button. Indicator pilot light (7) B C A When selecting a washing programme both lights A and B illuminate. After having pressed the button 5 the only light corre- sponding to t ...
-
Zanussi ZWI 1125 - page 7
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment COTTONS 60° - 40° - 30° - Cold Main wash - Rinses Maximum spin speed at 1200 rpm Max. load 6 kg - Reduced load 3 kg 1) Whit e and colo ured cot ton (normally soiled items). SPIN REDUCTION RINSE HOLD PR ...
-
Zanussi ZWI 1125 - page 8
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Comp artment WOOL/HANDWASH 30° - C old Main wash - Rinses Maximum spin speed at 900 rpm Max. load 2 kg Washing programme for machine washable wool as well as for hand washable woollens and delicate fabrics. Note : A ...
-
Zanussi ZWI 1125 - page 9
Before loading the laundry Never wash whites and coloureds together. Whites may lose their whiteness in the wash. New coloured items may run in the first wash; they should therefore be washed separately the first time. Button up pillowcases, close zip fasteners, hooks and poppers. Tie any belts or long tapes. Remove persistent stains before washing ...
-
Zanussi ZWI 1125 - page 10
When the degree of hardness is soft, readjust the quantity of the detergent. First use • Ensure that the electrical and water connections comply with the installation instructions. • Remove the polystyrene block and any material from the drum. • Pour 2 litres of water into the main wash com- partment of the detergent drawer in order to activa ...
-
Zanussi ZWI 1125 - page 11
When selecting a programme, the light corresponding to the maximum speed allowed for that programme will illu- minate. Select the available opti ons b y pressing buttons 3 and 4 Depending on the programme, different functions can be combined. These must be selected after choosing the de- sired programme and before starting the programme. When these ...
-
Zanussi ZWI 1125 - page 12
continues to run at regular intervals until the water drain- ing. Follow the below instructions to empty out the water: 1. Turn the programme selector dial to . 2. Set the draining or spinning programme. 3. If needed, reduce the spin speed, . 4. Press button 5 . At the end of the programme, the door can be now opened. Turn the programme selector di ...
-
Zanussi ZWI 1125 - page 13
Place a container close to the pump ( A ) to collect any spillage. Pull out the emergency emptying hose ( B ), place it in the container and re- move its cap. When no more water comes out, unscrew the pump cover by turning it anti-clockwise and remove the filter. Use pliers, if necessary. Always keep a rag nearby to dry up any water spillage when r ...
-
Zanussi ZWI 1125 - page 14
Frost precaution If the machine is exposed to temperatures below 0°C, cer- tain precautions should be taken. • Turn off the water tap. • Unscrew the inlet hose. • Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out. • Screw the water inlet hose back on and reposition ...
-
Zanussi ZWI 1125 - page 15
Problem Possible cause/Solution The washing machine does not start: The door has not been closed (the button 5 red light blinks). • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The ma ...
-
Zanussi ZWI 1125 - page 16
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if ...
-
Zanussi ZWI 1125 - page 17
Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rota- tion of the drum. This may happen several times before the unbalance disap- pears and normal spinning can res ...
-
Zanussi ZWI 1125 - page 18
Consumption values Programme Energy consumption (KWh) 1) Water consumption (litre) 1) Programme duration (Minutes) 1) White Cottons 90 °C 2.0 61 140 Cottons 60 °C 1.35 58 125 Cottons 40 °C 0.75 58 120 Synthetics 40 °C 0.9 50 90 Delicates 40 °C 0.55 58 70 Wool/ Handwash 30 °C 0.25 58 60 1) The consumption info rmation shown in this chart is in ...
-
Zanussi ZWI 1125 - page 19
Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing ma- chine by raising or lower- ing the feet. The feet may be tight to adju st as they incorporate a self locking nut, bu ...
-
Zanussi ZWI 1125 - page 20
1. Into a drainage standpipe. Firstly form a hook in the end of the drain hose using the “U” piece” supplied. “U” piece supplied Place the drain hose into your standpipe, which should have an internal diameter of approximately 38 mm thus ensuring there is an air break between the drain hose and standpipe. When discharging into a standpipe ...
-
Zanussi ZWI 1125 - page 21
SHOWER WASHING MACHINE DISHWASHER BA TH SINK TOILET BIDET RAINWA TER ‘RUN-OFF’ SURF ACE WA TER DRAINS & SEWERS UNTREA TED DISCHARGE RIVER RIVER TREA TED DISCHARGE FOUL DRAIN FOUL SEWERS SEWAGE TREA TMENT WORKS Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or com ...
-
Zanussi ZWI 1125 - page 22
A 600 596 555 170 75 176,5 416 100 60 818 min. 820 min. 560 When installing the appliance into the kitchen furniture ensure, if possible, the hoses are placed in either of the two recesses on the back of the appliance. This will help to prevent the hoses from becoming kinked or trapped. B 1 2 3 7 5 6 4 8 Caution! Do not remove the screw 8 ! Prepara ...
-
Zanussi ZWI 1125 - page 23
D 4 6 8 Caution! Do not remove the screw 8 ! d) Counter-magnet (6) The appliance is prearranged for a magnetic closure of the door. To enable a correct operation of this device, it is neces- sary to screw the counter-magnet (6) (steel disk + rub- ber ring) into the inner side of the door. Its position must correspond to the magnet (4) on the applia ...
-
Zanussi ZWI 1125 - page 24
Drill four fixing holes see Fig. G Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow. The reason for placing the base in this position is to al- low a small strip of beading to be fitted in front of the appliance feet. Graphic H 600-605 490 5 x 25 x 605 Hardwood strip 5 mm x 25 mm Fix the b ...
-
Zanussi ZWI 1125 - page 25
25 ...
-
Zanussi ZWI 1125 - page 26
26 ...
-
Zanussi ZWI 1125 - page 27
27 ...
-
Zanussi ZWI 1125 - page 28
www.zanussi.com/shop 132966891-A-462011 ...
Avez-vous une question à propos de Zanussi ZWI 1125?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Zanussi ZWI 1125, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Zanussi ZWI 1125 il est probable qu’il a envie de partager la façon de le résoudre.