-
Haier HSU-12LH13 - page 1
No.00105 0 SPLIT TYPE ROOM AIR CONDITIONER OPERA TION MANUAL Please read this operation manual before using the air conditioner HSU-09LH13 HSU-12LH13 ...
-
Haier HSU-12LH13 - page 2
Bef ore disposing an old air conditioner that goes out of use, please mak e sure it's inop- erativ e and saf e. Unplug the air conditioner in order to av oid the risk of child entrapment. It must be noticed that air conditioner system contains refrigerants, which require speciali- zed w aste disposal. The valuab le materials contained in an ai ...
-
Haier HSU-12LH13 - page 3
Do not obstruct or cov er the ventilation grille of the air conditoner .Do not put fingers or any other things into the inlet/outlet and s wing louver . Do not allow children to pla y with the air conditioner .In no case should children be allow ed to sit on the outdoor unit. The refrigerating circuit is leak-proof. 1.Applicable ambient temper atur ...
-
Haier HSU-12LH13 - page 4
Cautions STRICT ENFORCEMENT Safety Instruction Installation W ARNING Please read the f ollowing Safety Instructions carefully prior to use. The instructions are classified into two le vels , W ARNING and CA UTION according to the seriousness of possible risks and damages as follo ws. Compliance to the instructions are str ictly required f or safety ...
-
Haier HSU-12LH13 - page 5
Cautions W ARNING When abnormality such as burnt-small found, immediately stop the operation button and contact sales shop. OFF Use an exclusive power source with a circuit breaker ENFORCEMENT Connect power supply cord to the outlet completely Use the proper voltage Do not use power supply cord in a bundle. T ake care not to damage the power supply ...
-
Haier HSU-12LH13 - page 6
1 2 3 4 Indoor unit Outdoor unit P ar ts and Functions 5 OUTLET CONNECTING PIPING AND ELECTRICAL WIRING INLET DRAIN HOSE Actual inlet grille may vary from the one shown in the manual according to the product purchased Displa y board Inlet Anion generator V er tical flap (Use remote controller to adjust up and down air flo w . Don't adjust it m ...
-
Haier HSU-12LH13 - page 7
P ar ts and Functions Used to select CODE A or B with a press ,A or B will be display ed on LCD . Please select A without special e xplanation. 1.CODE When the remote controller appears abnormal, use a sharp pointed ar ticle to press this button to reset the remote controller normal. 2.RESET Used to select TIMER ON, TIMER OFF , TIMER ON-OFF . 4. TI ...
-
Haier HSU-12LH13 - page 8
Remov e the batter ies in case unit won't be in usage f or a long per iod. If there are any displa y after taking-out, just need to press reset ke y . P ar ts and Functions Clock Set When unit is star ted f or the first time and after replacing batteries in remote controller , clock should be adjusted as f ollows: Remote controller's oper ...
-
Haier HSU-12LH13 - page 9
Operation Remote controller 8 STERILIZE 2.Health anion function Air conditioner starts health anion function operation. For twice press, disappears,the operation stops. BRIEF INTRODUCTION TO HEAL TH ANION FUCTION The anion generator in the air conditioner can generate a lot of anion eff ectively balance the quantity of position and anion in the air ...
-
Haier HSU-12LH13 - page 10
A uto Operation Operation Remote controller 9 STERILIZE About Auto Oper ation Under the mode of auto operation, air conditioner will automatically select Cool or Dry operation according to room temperature and setting temperature. 5.Unit stop Press ON/OFF button, the unit stops . 1. Unit star t Press ON/OFF on the remote controller , unit star ts. ...
-
Haier HSU-12LH13 - page 11
Cool Operation Remote controller 2.Select operation mode Press F AN button. For each press, fan speed changes as follows: Press MODE button. For each press, operation mode changes as follows: Remote controller: Remote controller: Then Select COOL operation Press TEMP . button Every time the button is pressed, temp.setting increase 1 o C,if kept dep ...
-
Haier HSU-12LH13 - page 12
2.Select operation mode Press F AN button. For each press , f an speed changes as f ollows: Press MODE button. For each press , operation mode changes as f ollows: Remote controller : Remote controller : Then Select DR Y operation Press TEMP . button Every time the button is pressed, temp .setting increase 1 o C ,if kept depressed, it will increase ...
-
Haier HSU-12LH13 - page 13
F an Operation 2.Select operation mode Press F AN button. For each press , fan speed changes as f ollows: Press MODE button. For each press , operation mode changes as f ollows: Remote controller : Remote controller : Then Select F AN operation 3.Fan speed selection 4.Unit stop About F AN operation In F AN operation mode, the unit will not oper ate ...
-
Haier HSU-12LH13 - page 14
2.Up and down air flo w direction V er tical flap P os.1 P os.1 P os.2 P os.3 P os.4 P os.6 P os.1 P os.2 P os.3 P os.4 P os.5 P os.6 P os.2 P os.3 P os.4 P os.5 P os.6 (Auto swing) F or each press of button, air flow direction on remote controller displa ys as f ollows according to diff erent operation modes: remote controller : COOL/DR Y/F AN: re ...
-
Haier HSU-12LH13 - page 15
If the wind speed is high or middle before setting for the sleep, set for lowing the wind speed after sleeping. If it is low wind, no change. 4.Set the wind speed change when sleeping Bef ore going to bed, you can simply press the SLEEP b utton and unit will operate in SLEEP mode and bring you a sound sleep . Use of SLEEP function After the unit st ...
-
Haier HSU-12LH13 - page 16
Remote Controller T imer On/Off Operation Operation Hints: After replacing batteries or a power failure happens, time setting should be reset. Remote controller possesses memory function, when use TIMER mode next time, just press SET button after mode selecting if time setting is the same as previous one. 16 Set clock correctly before starting TIME ...
-
Haier HSU-12LH13 - page 17
Remote Controller T imer On-Off Operation Operation Just press TIMER button several times until TIMER mode disappears. According to the T ime setting sequence of TIMER ON or TIMER OFF , either Start-Stop or Stop-Start can be achieved. Set clock correctly before starting TIMER operation. 1. After unit starts, select your desired operation mode Opera ...
-
Haier HSU-12LH13 - page 18
Operation 19 When the remote controller is manipulated, it gets the system back to the nor mal operation mode . Emer g ency and T est Operation When machine is r unning in emergency , the set value of temper ature and wind speed couldn't be altered; meanwhile, it can't operate f or dehumidifying or under timing mode. Emer gency operation: ...
-
Haier HSU-12LH13 - page 19
For Smar t Use of The Air Conditioner Setting of proper room temperature Close doors and windo ws dur ing oper ation If the unit is not to be used f or a long time, turn off the po wer supply main s witch. Use the timer ef f ectiv ely Use the louv ers eff ectiv ely Do not b lock the air inlet or outlet Maintenance Proper temperature During cooling ...
-
Haier HSU-12LH13 - page 20
For Smar t Use of The Air Conditioner W ARNING Air Filter cleaning Open the inlet grille by pulling it upw ard. Remov e the filter . Clean the filter . Attach the filter . Close the inlet grille. Push up the filter's center tab slightly until it is released from the stopper , and remov e the filter downw ard. Use a vacuum cleaner to remov e du ...
-
Haier HSU-12LH13 - page 21
Maintenance Replacement of Air Purifying Filter 1.Open the lnlet Grille 2.Detach the standard air filter 3.Detach old Air Pur ifying Filter Detach old Air Purifying Filter 4.Attach old Air Pur ifying Filter 5.Attach the standard air filter (Necessar y installation) 6.Close the Inlet Grille Close the Grille surely Open the inlet grille by pushing ea ...
-
Haier HSU-12LH13 - page 22
T o K eep Y our Air conditioner in Good Condition after Season. Operate in cooling mode f or 2-3 hours. Put of f the pow er supply cord. T ak e out the batter ies from the wireless remote controller . Cleaning the body . T o prev ent breeding mold or bad smell, be sure to operate at the designated temperature or 30 O C ,cooling mode and High speed ...
-
Haier HSU-12LH13 - page 23
Bef ore Setting in High season Cleaning the standard air filter . Connecting the ear thing cab le. Do not b loc k the air inlet or outlet. Plug-in Caution Caution After brush awa y dust at the plug, inser t the plug of the pow er supply cord into the outlet completely .In case of suing exclusiv e circuit breaker ,switch on the circuit break er . NO ...
-
Haier HSU-12LH13 - page 24
Is the air filter dir ty? Normally it should be cleaned e very 15 days . Are there any obstacles bef ore inlet and outlet? Is temperature set correctly? Are there some doors or windows left open? Is there any direct sunlight through the window during the cooling operation?(Use cur tain) Are there too much heat sources or too many people in the room ...
Hai una domanda su Haier HSU-12LH13?
Utilizza il modulo sottostante
Se non hai risolto il problema con Haier HSU-12LH13 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Haier HSU-12LH13 è probabile che voglia condividere il modo di risolverlo.