-
Culligan Water Tower - page 1
Culligan W ater T ower ™ Drinking W ater System Owners Guide ...
-
Culligan Water Tower - page 2
NOTICE: This system is intended for use on potable w ater supplies or disinfected water containing cysts. Do not use where water is microbiologically unsafe or with w ater of unknown quality . If bacterial contamination is present, a r ecogniz ed method of w ater disinfection is requir ed. Check with y our public works depar tment for applicable lo ...
-
Culligan Water Tower - page 3
T a b le of Contents Safety/W arnings ...................................................................................................... i System Specifications ............................................................................................. 2 Introduction About Y our System ......................................................... ...
-
Culligan Water Tower - page 4
System Specifications System Flow Sequences ............................... Sediment Filter, Activ ated Carbon Filter, R everse Osmosis Membrane, Stor age Tank, P olishing Filter, Dispensing F aucet. Sediment Filter .............................................. Spun Polypropylene T ype Carbon Filter ................................................ ...
-
Culligan Water Tower - page 5
Intr oduction Thank you for c hoosing a Cullig an W ater T ow er ™ drinking water system. Y our new system is designed to bring you years of healthful, deliciously cr ystal-clear Culligan ® water . With its special faucet installed on your sink, it’ s like getting bottled water straight from y our kitchen tap . With the Culligan W ater T ower ...
-
Culligan Water Tower - page 6
4 Polishing Filter The Cullig an W ater T ower ™ drinking w ater system includes a second activa ted carbon filter in the manifold as added assurance that your water will be crystal clear . Culligan ® Smar tap ® W ater Quality Monitor and F aucet The special drinking water faucet mounts conv eniently on your kitchen sink. A simple twist of the ...
-
Culligan Water Tower - page 7
5 T able 1 Influent W ater Characteristics Pressure 1 35-100 psi (242-690 kP a) T emperature 40-100°F (4-38°C) T otal Dissolved Solids (TDS) 2 0-2000 ppm (0-2000 mg/L) pH 3.0 - 11.0 Chlorine 3 0-2 ppm (0-2 mg/L) Chloramine 0-2 ppm (0-2 mg/L) T urbidity <1.0 NTU Silt Density Index (SDI) <4 Hardness (CaCO 3 ) <350 ppm Hydrogen Sulfide (H 2 ...
-
Culligan Water Tower - page 8
6 Installation This Owner’ s Guide pro vides visual assembly reference only (Figure 2). Since specialized skills are required in the assembly of the drinking water system, we recommend that y ou contact your local independently operated Cullig an ® dealer to complete this installation. Component Location Pr oduct W ater F aucet Faucet ma y be lo ...
-
Culligan Water Tower - page 9
7 Ser vicing Y our System Ser vice Schedule When properly maintained, your Cullig an W ater T ow er ™ drinking water system will gi ve you years of de pendable ser vice. Use the following as a guide to get the most out of your system. Ser vice frequency may v ar y de pending on your local water conditions . High sediment, chlorine, turbidity or h ...
-
Culligan Water Tower - page 10
8 If you wish to ser vice your system, the filters are av ailable from your Cullig an dealer. See the P arts List at the end of this section for re placement numbers. Car tridge Conditioning The activ ated carbon, reverse osmosis , and polishing filter cartridg es must be conditioned as follows prior to installation into the Culligan W ater T ower ...
-
Culligan Water Tower - page 11
9 3. Check product wa ter storage tank air pre-charge using low-pressure gaug e (PN 34002024). Air valv e is located on tank base. Pre-charge should be 55 kPa (8 psig) with tank empty and tank valv e open. Note: Use hand pump to av oid dama ging tank. V erify product water faucet is open before proceeding . Use caution when wo rking with/inside enc ...
-
Culligan Water Tower - page 12
10 9. Clean filter housings/manifold, inside and outside, with washcloth and cleaning solution. Do not use abrasiv e ma terials. 10. Rinse housings/manifold with clean potable water . 11. Inspect filter housing O-ring g roov e and manifold O-ring surface for damage such as nicks or scratc hes. R eplace if damag ed. 12. Place a small amount of O-rin ...
-
Culligan Water Tower - page 13
11 CAUTION: Wear safety glasses while performing this procedure. CAUTION: Read “W ARNINGS” information on bleach container before using contents. Handle sanitizing solution carefully . A void cont act with unprotected areas. 13. Mix sanitizing solution of 1.5 ml (1/3 teaspoon) of household bleach and 3.8 L (1 gallon) of clean, potable water in ...
-
Culligan Water Tower - page 14
12 21. Install car tridges. (R efer to Figure 5 for location of each cartridg e). a. Hold car tridg e by its protecti ve plastic bag . b . Inser t car tridg e into manifold tur ning it 1/2 tur n as it enter s por t. Slide bag from cartridg e and discar d. c . Install filter housing (Item 30) as each cartridge is inser ted. Make sure housing o-ring ...
-
Culligan Water Tower - page 15
13 Note: Replace batter y with a new alkaline 9-volt battery (PN 31300001) 26. Carefully slide batter y into its holder . 27. Connect batter y by pressing clip onto batter y ter minals . 28. T est monitor connection by activ ating monitor . Open product water faucet. If an indicator light illuminates , connection is g ood. Note: Close faucet immedi ...
-
Culligan Water Tower - page 16
14 T r oub leshooting Guide W ater V olume and Quality Symptom Condition Action No product water W ater supply is tur ned OFF T urn water ON Not enough Low water pressure Check source water line pressure product water Inlet wa ter supply valv e is block ed Clear restriction Storag e tank valv e is closed Open storage tank valve Storage tank is de p ...
-
Culligan Water Tower - page 17
15 Leaka ge Symptom Probable Cause Solution Leak at fitting T ubing not pushed completely Push tube into fitting past into fitting O-ring seal Defectiv e tube Cut damaged area from tube or replace tube T ubing makes too tight a bend R un the tubing to reduce the bend near fitting Leak at filter O-ring has not seated properly R emov e O-ring and ins ...
-
Culligan Water Tower - page 18
16 Item Description Part No. 1 Culligan Faucet, Chrome body/spout 1 1403430 Culligan Faucet, White body/spout 1 1403431 Culligan Faucet, Almond body/spout 1 1403433 Culligan Faucet, Black body/spout 1 1403434 Culligan Faucet, Satin body/spout 1 1403436 Culligan Faucet, Black body/Polished spout 1 1403439 2 Battery , 9-volt alkaline 31300001 4 Brack ...
-
Culligan Water Tower - page 19
17 Cullig an W a ter T o w er ™ Ser vice Lo g Model Serial No . Date Installed F or Ser vice Call Cullig an at: Car tridge(s) Changed Activ ated Activ ated Date Sediment Pre-Carbon R O P ost-Carbon Ser viced Filter Filter Membrane Filter Sanitized ( ) — ...
-
Culligan Water Tower - page 20
18 Culligan Lifetime Limited W arranty CULLIGAN W A TER TOWER ™ CWT -35 MODEL SERIES Y ou have just purchased one of the finest drinking water systems made. As an expression of our confidence in Culligan International Company products, your drinking water system is warranted to the original end-user , when installed in accordance with Culligan sp ...
-
Culligan Water Tower - page 21
Materials & description: 8-1/2 x 1 1, 20 page book, saddle stitched, three hole punched - Print s black ink on 50# offset white This p age cont ains materials and DCO information. IT DOES NOT PRINT AS P ART OF THE DOCUMENT! LET CHANGE BY APRVD DA TE A DCO 1254 TPD BL 8/21/00 ...
Hai una domanda su Culligan Water Tower?
Utilizza il modulo sottostante
Se non hai risolto il problema con Culligan Water Tower con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Culligan Water Tower è probabile che voglia condividere il modo di risolverlo.