Italiano dropdown-ico

Manuale per l’uso Husqvarna 420 GN

23 pagine 2.23 mb
Scarica

Vai alla pagina of 23

Summary
  • Husqvarna 420 GN - page 1

    S E R V I C E O 070 7 903 2007-12 Manual No. 203861GS Revision A (09/19/2007) 2000 W att Portable Generator Operator’ s Manual 531 30 97-18 420GN ...

  • Husqvarna 420 GN - page 2

    2 www.usa.husqvarna.com Briggs & Stratton Power Products Group, LLC 900 North Parkway Jefferson, WI 53549 Copyright © 2007 Briggs & Stratton Power Products Group, LLC. All rights reserved. No part of this material may be reproduced or transmitted in any form by any means without the express written permission of Briggs & Stratton Power ...

  • Husqvarna 420 GN - page 3

    3 Español T able of Contents Operator Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Equipment Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Assembly . . . . ...

  • Husqvarna 420 GN - page 4

    4 www.usa.husqvarna.com Operator Safety Equipment Description Read this manual carefully and become familiar with your generator. Know its applications, its limitations and any hazards involved. The generator is an engine–driven, revolving field, alternating current (AC) generator. It was designed to supply electrical power for operating compatib ...

  • Husqvarna 420 GN - page 5

    5 W ARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. W ARNING Starter cord kickback (rapid retraction) can result in bodily injury. Kickback will pull hand and arm toward engine faster than you can let go. Broken bones, fractures, bruises, or ...

  • Husqvarna 420 GN - page 6

    6 www.usa.husqvarna.com W ARNING Starter and other rotating parts can entangle hands, hair, clothing, or accessories. • NEVER operate generator without protective housing or covers. • DO NOT wear loose clothing, jewelry or anything that may be caught in the starter or other rotating parts. • Tie up long hair and remove jewelry. W ARNING Unint ...

  • Husqvarna 420 GN - page 7

    7 Assembly Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended fuel and oil. If you have any problems with the assembly of your generator, please call the generator helpline at (877) 224-0458 . If calling for assistance, please have the model, revision, and serial number from the data ...

  • Husqvarna 420 GN - page 8

    8 www.usa.husqvarna.com System Ground The generator has a system ground that connects the generator frame components to the ground terminals on the AC output receptacles. The system ground is connected to the AC neutral wire (the neutral is bonded to the generator frame). Special Requirements There may be Federal or State Occupational Safety and He ...

  • Husqvarna 420 GN - page 9

    9 Features and Controls Read this Operator’s Manual and safety rules before operating your generator. Compare the illustrations with your generator, to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. A - Fuel Tank — Capacity of 1.32 U.S. gallons (5.0 L). B - Circuit Breaker (AC ...

  • Husqvarna 420 GN - page 10

    10 www.usa.husqvarna.com Cord Sets and Receptacles Use only high quality, well-insulated, grounded extension cords with the generator’s 120 Volt duplex receptacle. Inspect extension cords before each use. Check the ratings of all extension cords before you use them. Extension cord sets used should be rated for 125 Volt AC loads at 15 Amps or grea ...

  • Husqvarna 420 GN - page 11

    11 Operation Starting the Engine Disconnect all electrical loads from the generator. Use the following start instructions: 1. Make sure unit is on a level surface. IMPORTANT: Failure to start and operate the unit on a level surface will cause the unit not to start or shut down during operation. 2. Turn fuel valve ( A ) to “ Open ” position (ful ...

  • Husqvarna 420 GN - page 12

    Charging a Battery Your generator has the capability of recharging a discharged 12 Volt automotive or utility style storage battery. DO NOT use the unit to charge any 6 Volt batteries. DO NOT use the unit to crank an engine having a discharged battery. To recharge 12 Volt batteries, proceed as follows: 1. If necessary, clean battery posts or termin ...

  • Husqvarna 420 GN - page 13

    13 Creating a Temporary Shelter 1. In an emergency, use the original shipping carton. 2. Cut off top carton flaps and one long side of carton to expose muffler side of unit. If required, tape up other sides of carton to fit over generator as shown. NOTE: If required, remove wheel kit to fit carton over generator as shown. 3. Cut appropriate slots t ...

  • Husqvarna 420 GN - page 14

    14 www.usa.husqvarna.com Don’t Overload Generator Capacity You must make sure your generator can supply enough rated (running) and surge (starting) watts for the items you will power at the same time. Follow these simple steps: 1. Select the items you will power at the same time. 2. Total the rated (running) watts of these items. This is the amou ...

  • Husqvarna 420 GN - page 15

    15 Maintenance General Recommendations Regular maintenance will improve the performance and extend the life of the generator. See an authorized dealer for service. The generator’s warranty does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain the generato ...

  • Husqvarna 420 GN - page 16

    16 www.usa.husqvarna.com Storage The generator should be started at least once every seven days and allowed to run at least 30 minutes. If this cannot be done and you must store the unit for more than 30 days, use the following guidelines to prepare it for storage. Generator Storage • Clean the generator as outlined in Cleaning . • Check that c ...

  • Husqvarna 420 GN - page 17

    17 T roubleshooting Problem Cause Correction Engine is running, but no AC output is available. 1. One of the circuit breakers is open. 2. Fault in generator. 3. Poor connection or defective cord set. 4. Connected device is bad. 1. Reset circuit breaker. 2. Contact authorized service facility. 3. Check and repair. 4. Connect another device that is i ...

  • Husqvarna 420 GN - page 18

    18 www.usa.husqvarna.com HUSQVARNA® PORTABLE GENERATOR OWNER WARRANTY POLICY LIMITED WARRANTY “Husqvarna® is a registered trademark of Husqvarna AB and is used under license to Briggs & Stratton Power Products. Briggs & Stratton Power Products Group, LLC will repair or replace, free of charge, any part(s) of the portable generator that ...

  • Husqvarna 420 GN - page 19

    19 www.usa.husqvarna.com Briggs & Stratton Power Products Group, LLC 900 N. Parkway Jefferson, Wisconsin, 53549 U.S.A. Portable Generator Product Specifications Starting Wattage . . . . . . . . . . . . . . . . . . . . . . . .3,000 watts Wattage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2,000 watts Load Current: at 120 Volts AC ...

  • Husqvarna 420 GN - page 20

    2 www .usa.husqvarna.com Exploded View - Main Unit Copyright © 2007 Briggs & Stratton Power Products Group, LLC. All rights reserved. No part of this material may be reproduced or transmitted in any form by any means without the express written permission of Briggs & Stratton Power Products Group, LLC. ...

  • Husqvarna 420 GN - page 21

    3 Exploded View - Main Unit ...

  • Husqvarna 420 GN - page 22

    4 www .usa.husqvarna.com Parts List - Main Unit Item Part # Description 1 187757GS BOL T , COVER, MUFFLER 2 197871GS DECAL, ON-OFF 3 187450GS SWITCH, ENG, ON/OFF 4 187766GS DECAL, CHOKE 5 205088GS SP ACER 6 187761GS NUT , M4, FLANGE 7 187760GS SCREW , M4X12 8 197797GS DECAL, FUEL SHUTOFF , CCW 9 205086GS P ANEL, END, RECOIL 10 205092GS HOSE, DRAIN ...

  • Husqvarna 420 GN - page 23

    5 4 5 6 11 7 10 8 1 2 15 16 18 17 13 14 9 3 12 Item Part # Description 1 NSP ADPTR, ENG 2 197890GS ASSY , ROTOR 3 NSP BOL T , ROTOR 4 197892GS ASSY , ST A TOR 5 NSP SCREW , M5 X 7 6 197894GS BOL T , ST A TOR 7 197895GS SCREW , M4 X 18 8 197896GS SCREW , M5 X 10 9 187462GS RECTIFIER Item Part # Description 10 NSP BRACKET , RECTIFIER 11 NSP RBC 12 19 ...

Fabbricante Husqvarna Categoria Portable Generator

I documenti che otteniamo dal fabbricante del dispositivoHusqvarna 420 GN possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Husqvarna
- manuali per l’uso 420 GN
- schede prodotto Husqvarna
- opuscoli
- o etichette energetiche Husqvarna 420 GN
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Husqvarna 420 GN.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Husqvarna 420 GN, manuali di manutenzione, brevi manuali o manuali utente Husqvarna 420 GN. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Husqvarna 420 GN.

Manuali per l’uso simili

Manuale completo del dispositivo Husqvarna 420 GN, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Husqvarna 420 GN dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Husqvarna 420 GN.

Il manuale per l’uso completo Husqvarna, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Husqvarna 420 GN - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Husqvarna 420 GN, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Husqvarna 420 GN che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Husqvarna 420 GN - che ci dovrebbe aiutare nei primi passi durante l'uso Husqvarna 420 GN
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Husqvarna 420 GN
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Husqvarna 420 GN in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Husqvarna 420 GN?

Utilizza il modulo sottostante

Se non hai risolto il problema con Husqvarna 420 GN con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Husqvarna 420 GN è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)