Italiano dropdown-ico

Manuale per l’uso JVC SP-UXNB7DAB

24 pagine 1.08 mb
Scarica

Vai alla pagina of 24

Summary
  • JVC SP-UXNB7DAB - page 1

    MICR O COMPONENT SYSTEM UX-NB7D AB GNT0065-025A [B] —Consists of CA-UXNB7D AB and SP-UXNB7D AB INSTR UCTIONS UX-NB7DAB[B]ff.indb 1 UX-NB7DAB[B]ff.indb 1 06.7.4 2:40:56 PM 06.7.4 2:40:56 PM ...

  • JVC SP-UXNB7DAB - page 2

    G-1 IMPORT ANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fi tted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer . BE SURE to replace the fuse only with an identical approved type, ...

  • JVC SP-UXNB7DAB - page 3

    G-2 CAUTION: P roper V entilation T o avoid risk of electric shock and fi re, and to pr event damage, locate the apparatus as follows: 1. Fr ont: No obstructions and open spacing. 2. Sides/ T op/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path f ...

  • JVC SP-UXNB7DAB - page 4

    1 Con tents Precautions ........................................................... 2 Getting Star ted ..................................................... 2 Supplied Accessories ............................................................... 2 Prepar e the Remote Control ................................................. 2 Connections ............ ...

  • JVC SP-UXNB7DAB - page 5

    2 Notes on the power c ord • When you are away on tra vel or other wise for an extended period of time, remove the plug from the wall outlet. A small amount of power (2.5 W ) is always consumed while the power cord is connected to the wall outlet. • When unplugging the System from the wall outlet, always pull the plug, not the pow er cord. • ...

  • JVC SP-UXNB7DAB - page 6

    3 SPEAKERS PHONES RIGHT IMPEDANCE MIN LEFT ANTENNA COAXIAL AM EXT LOOP DAB Connections Do not connect the AC pow er cord until all other connections hav e been made. T o a wall outlet Plug the AC pow er cord only after all connections are complete. T o connect the speaker cords Make sure the both speakers are connected correctly and fi rmly. When ...

  • JVC SP-UXNB7DAB - page 7

    4 AM loop antenna (supplied) T urn it until the best reception is obtained. T o assemble the AM loop antenna T o connect the AM loop antenna NOTES • DO NOT connect more than one speaker to each terminal. • DO NOT allow the conductor of the speaker cords to be in touch with the metallic parts of the System. 2 Insert 3 Release Outdoor FM antenna ...

  • JVC SP-UXNB7DAB - page 8

    5 Basic and Common Oper ations NOTE DO NOT turn off (standby) the System with the volume set to an extremely high level; Other wise, the sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the System or start playback. Using Headphones Be sure to turn down the volume befor e connecting or wearing the headphon ...

  • JVC SP-UXNB7DAB - page 9

    6 Operating on the Remote Contr ol T o Press T urn on or off (standby) the power The standby lamp on the System turns off /on. Select a source See “Playing Back Discs” on page 7. See “Listening to the Radio” on page 9. See “Connecting a Portable Audio Device ” on page 13. Adjust the volume Y ou can adjust the volume level fr om level ...

  • JVC SP-UXNB7DAB - page 10

    7 This System can play back the follo wing discs—regular CD and CD-R/CD -RW (recorded either in the audio CD or MP3 format). • When playing back the MP3 track , MP3 indicator appears on the display . T o S et a Disc 1 On the System 2 3 On the System The disc cover on the System opens. Place a disc correctly with its label side up, then press do ...

  • JVC SP-UXNB7DAB - page 11

    8 Programming the Playing Or der— Progr am Play (ex cept f or MP3) 1 Pr ess repeatedly until the PRGM (program) indicator appears on the display befor e you star t playback. 2 or Select the track number to program. 3 Pr ess to program the selected track. 4 Repeat step 2 and 3 to program other tracks y ou want. • I f you try to program a 33rd tr ...

  • JVC SP-UXNB7DAB - page 12

    9 Basic T uner Opera tions To Press On the System On the remote Select a band Each time you press the button, the band changes as follows: DAB FM AM The selected band and frequency appear on the main display . • When an FM stereo broadcast with suffi cient signal strength is tuned in, the ST (stereo) indicator lights on the display . When you cha ...

  • JVC SP-UXNB7DAB - page 13

    10 Improving the DAB rec eption With the supplied DAB antenna, y ou may not be able to receive L -Band ensembles depending on your reception condition. Y ou can improve the r eception of both L -Band and Band III ensembles by connecting an active antenna (see page 3) and supplying electricity to the antenna. While the System is on standby (Displa y ...

  • JVC SP-UXNB7DAB - page 14

    11 Receiving FM Stations with Radio Data S ystem Radio Data System allows FM stations to send an additional signal along with their r egular program signals. With the System, you can r eceive the following types of Radio Data System signals. PS (Program Service): Shows commonly known station names. PTY (Program T ype): Shows types of broadcast prog ...

  • JVC SP-UXNB7DAB - page 15

    12 Switching T emporarily to a Progr am of Y our Choice Automa tically The Enhanced Other Networ ks function allows the System to switch temporarily to a preset F M station broadcasting a program of your choice ( T A, NEWS, or INFO). • This func tion works while listening to an F M program providing the requir ed signals. Pr ess repeatedly to sel ...

  • JVC SP-UXNB7DAB - page 16

    13 This System has LINE IN/OUT jacks to connect a portable audio device. Connect between the device and the System by using the stereo mini plug cord (not supplied). IMPORT ANT: It should be noted that it may be unlawful to re-record pre-recorded tapes, r ecords, or discs without the consent of the owner of copyright in the sound or video recording ...

  • JVC SP-UXNB7DAB - page 17

    14 1 Start recording or standby recording on the device. 2 or Start playing the CD or tune into the station you want to recording . T o Select the Audio Output Level If the recorded sound on the device connected to the LINE OUT jack is too loud or too quiet, you can change the audio output level through the LINE OUT jack (without changing the volum ...

  • JVC SP-UXNB7DAB - page 18

    15 Setting the Clock and Daily T imer S etting the Clock Without setting the built-in clock, you cannot use Daily Timer and Sleep Timer . 1 Pr ess to activate the clock setting mode. • I f you hav e already adjusted the clock before , press the button repeatedly until the clock setting mode is selected. 2 or Adjust the hour , then the minute. • ...

  • JVC SP-UXNB7DAB - page 19

    16 Learning More about This S ystem Basic and Common Opera tions (see page 5) • Sound adjustments also aff ect the sound through the headphones. • Sound adjustments do not aff ect recording to the external device. • Y ou can set the clock and daily timer while the Save mode is turned on. While setting the clock or daily timer , the display ...

  • JVC SP-UXNB7DAB - page 20

    17 T roubleshooting General Po wer does not come on. Pow er plug is not inser ted securely . Plug in securely . Adjustments or settings are suddenly canc eled before y ou fi nish. There is a time limit. Repeat the procedure again. Operations are disabled . The built-in microprocessor ma y malfunction due to external electr ical interference. ...

  • JVC SP-UXNB7DAB - page 21

    18 Maintenance Specifi cations Specifi cations and appearance are subject to change without prior notic e. Handling discs • Remove the disc from its case by holding it at the edge while pressing the center hole lightly . • Do not touch the shiny surface of the disc, or bend the disc. • Put the disc back in its case after use. • Be careful ...

  • JVC SP-UXNB7DAB - page 22

    19 Description of the PTY codes for Radio Data S ystem and D AB * 1 The PT Y codes are diff erent between Radio Data System and DAB . The f ormer is for Radio Data System, and the latter is for DAB . * 2 Only Radio Data System has this PT Y code. NOTE Classifi cation of the PTY codes for some FM stations may be diff erent from the above list. NE ...

  • JVC SP-UXNB7DAB - page 23

    20 SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international saf ety standards but, like any electrical equipment, care must be taken if you are to obtain the best r esults and safety is to be assured. Do read the operating instructions before you att empt to ...

  • JVC SP-UXNB7DAB - page 24

    0706KTCMD WJSC EN © 2006 Victor Company of J apan, Limited MICRO COMPONENT SYSTEM UX-NB7D AB UX-NB7DAB[B]ff.indb 2 UX-NB7DAB[B]ff.indb 2 06.7.4 2:40:58 PM 06.7.4 2:40:58 PM ...

Fabbricante JVC Categoria Speaker System

I documenti che otteniamo dal fabbricante del dispositivoJVC SP-UXNB7DAB possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici JVC
- manuali per l’uso SP-UXNB7DAB
- schede prodotto JVC
- opuscoli
- o etichette energetiche JVC SP-UXNB7DAB
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso JVC SP-UXNB7DAB.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione JVC SP-UXNB7DAB, manuali di manutenzione, brevi manuali o manuali utente JVC SP-UXNB7DAB. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto JVC SP-UXNB7DAB.

Manuali per l’uso simili

Manuale completo del dispositivo JVC SP-UXNB7DAB, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare JVC SP-UXNB7DAB dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti JVC SP-UXNB7DAB.

Il manuale per l’uso completo JVC, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale JVC SP-UXNB7DAB - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice JVC SP-UXNB7DAB, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per JVC SP-UXNB7DAB che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo JVC SP-UXNB7DAB - che ci dovrebbe aiutare nei primi passi durante l'uso JVC SP-UXNB7DAB
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del JVC SP-UXNB7DAB
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio JVC SP-UXNB7DAB in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su JVC SP-UXNB7DAB?

Utilizza il modulo sottostante

Se non hai risolto il problema con JVC SP-UXNB7DAB con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con JVC SP-UXNB7DAB è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)