-
RCA RTB1013 - page 1
USER MANU AL RTB1013 It's impor tant to read this instruction prior to using your new product for the fi rst time. ...
-
RCA RTB1013 - page 2
- 1 - This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits f ...
-
RCA RTB1013 - page 3
- 2 - Important Information THE LIGHTNING FLASH AND ARROWHEAD WITHIN THE TRIANGLE IS A W ARNING SIGN ALERTING YOU OF “DANGEROUS VOL T AGE” IN- SIDE THE PRODUCT. THE EXCLAM A TION POINT WITHIN THE TRI- ANGLE IS A W ARNING SIGN ALERTING YOU OF IMPORT ANT INSTRUC TIONS ACC OMP ANYING THE PRODUCT. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO N ...
-
RCA RTB1013 - page 4
- 3 - Important Information Important Battery Information • Do not mix diff erent types of batteries or new and old batteries. Do not use rechar geable batteries. • In order to avoid any risk of explosion, observe the polarities indicated inside the battery compartment. Replace only with the type of batteries specifi ed. Do not dispose of the ...
-
RCA RTB1013 - page 5
- 4 - Impor tant Safety Instructions Please Read and Save for F uture Referenc e. Some of the following information may not apply to your particular product; however , as with any electronic product, precautions should be observed during handling and use. Read these instructions. • Keep these instructions. • Heed all warnings. • Follo w all i ...
-
RCA RTB1013 - page 6
- 5 - Things to C onsider before Y ou Connect • Ensure that the mains (AC pow er) supply in your house complies with that indicated on the identifi cation sticker located on the back of your unit. • Install your unit horizontally , away from an y source of heat (fi replace) or appliances cr eating strong magnetic or electric fi elds. The com ...
-
RCA RTB1013 - page 7
- 6 - Connections and Setup Connecting to your T V Method 1 (best) HDMI • Connect the HDMI OUT jack on the rear of the unit to the HDMI IN jack on your TV using a HDMI cable (not included). • Y ou can selec t the resolution of the play er ’ s HDMI output signals (HDMI Auto , 1080p, 1080i, 720p , 480p and 480i) to match your TV ’ s resolutio ...
-
RCA RTB1013 - page 8
- 7 - Connections and Setup Connecting your pla yer to a wired net- work router (optional) Connect an Ethernet cable (CA T5 or better with RJ45 connector) to the ETHERNET jack on the back of your player and to an Ethernet jack on a network hub or broadband router . Notes: • Do not connect a modular phone cable to the ETHERNET jack . • When plug ...
-
RCA RTB1013 - page 9
- 8 - Connecting the Speakers Speaker wires are color-coded to match the terminals . Connect the speaker wire from the back of each speaker to the corresponding color terminal at the back of the unit. P ress down the tab to open the terminal and insert the wire. Release the tab to lock wire in the terminal. Connections and Setup Subwoofer Purple an ...
-
RCA RTB1013 - page 10
- 9 - Connections and Setup Note: Center speaker provided with this unit is magnetically shielded to protect your T V set. It is not recommended to place speak- ers without magnetic shield near the T V set. 1. Left, Right (Front Speakers) Fr ont speakers carr y primarily music and sound eff ects. 2. Center In surround mode, the center speaker carr ...
-
RCA RTB1013 - page 11
- 10 - Connections and Setup Overview of Contr ols - Fron t Panel C ontrols Better Surround Placement Location If possible, place surround speakers to either side of the listening area, not behind it. Height If space permits, install surround speakers 2-3 feet abo ve viewers. This helps to minimize localization eff ects. Aiming Aim surround speake ...
-
RCA RTB1013 - page 12
- 11 - Overview of Contr ols ON/OFF Press to turn on your unit, or put your unit in standby mode. When your unit is in standby mode, power is still entering your unit. To disconnect power, unplug the power cord. OPEN/CLOSE Press to open or close the disc tray. R(red), G(green), B(blue), Y(yellow) When playing a Blu-ray Disc that has a Java applicat ...
-
RCA RTB1013 - page 13
- 12 - Overview of Contr ols Note: Insert the t wo “ AAA ” (included with this unit) batteries into the remote control prior t o use. MEM/ANGLE Stores a station in tuner mode. Accesses the camera angle function for Blu-ray or DVD discs if available. ZOOM Press to zoom in on the video. Each time you press this button, the magnifi cation level c ...
-
RCA RTB1013 - page 14
- 13 - Quick Setup When turned on for the fi rst time or after resetting it to the factory default, the Quick Setup menu will pop up as following . Follo w the below steps to make the basic settings for using the Blu-ray player . 1. Press OK to perform Quick Setup. • T o exit Quick Setup, press button to select “No” and then press OK . The d ...
-
RCA RTB1013 - page 15
- 14 - Playing a Blu-ray Disc or DVD Regional Coding This unit has been designed to play back BD-video encoded for region “A” and DVD-video encoded for region “1”. You cannot play back BD-video or DVD- video that are labeled for other regions. Look for the symbols on the right on your BD-video or DVD-video. If these region symbols do not ap ...
-
RCA RTB1013 - page 16
- 15 - Special F unctions Primary video Secondary video Notes • The available options of Audio vary from diff erent disc format. • PiP Subtitle is not available f or all discs. It only applies to Blu-ray discs that supports picture -in- picture features. • Some discs allow you to turn PiP on/off only via the disc menu. Selecting a play sour ...
-
RCA RTB1013 - page 17
- 16 - Playing an audio CD 1. Press ON/OFF button on the remote control or ON/STANDBY button located on the unit’s front panel. 2. Press OPEN/CLOSE butt on to open the disc tray. 3. Place a CD on the disc tray with the label facing up, then press OPEN/CLOSE button to close the disc tray. It may take a few seconds for the CD to load. 4. After load ...
-
RCA RTB1013 - page 18
- 17 - Watching Movies with Net ix T o use Netfl ix ser vice, connect this player to y our network, and confi gure the network settings if they are not fi nished yet. (See “Network Setting” sec tion on page 24). Launching Net ix movie 1. In home menu, press or button to select Connected . 2. Press button and then press OK button to ent ...
-
RCA RTB1013 - page 19
- 18 - Note Resolution of video streamed from Netfl ix varies depending on communication speed or bitrate of each content, etc. Preparing Instant Queue T o play streaming video via Netfl ix ser vice, Netfl ix service, you must have an appropriat e Netfl ix subscription and the player needs to be reg istered for Netfl ix service. See previous s ...
-
RCA RTB1013 - page 20
- 19 - Some BD-ROMs contains BD-Live features that can be downloaded to the external memory (local storage) for enjoyment. In order to access BD-Live functions, the Blu-ray disc player must be properly confi gured for BD- Live internet access , and it must be equipped with additional memory (USB Flash Drive). 1. Inser t a USB Flash Drive of at at ...
-
RCA RTB1013 - page 21
- 20 - Radio This unit has a built-in digital-tuning FM radio . Manual tuning 1. Connect the FM antenna at the back of the unit. 2. Press TUNER button. 3. Tune a station b y pressing TUNE / buttons repeatedly until the desired station is f ound. Alternatively , you can press and hold the same button down for about two seconds t o activate the autom ...
-
RCA RTB1013 - page 22
- 21 - Display Setting 1. In the main menu of Settings , press button, then use or button to select Display . 2. Press button and press or button to select an option, then press OK button. 3. Press or button to select the desired option, and then press OK button to confi rm your selection. 4. Press or EXIT button to go to the previous menu. The Se ...
-
RCA RTB1013 - page 23
- 22 - Digital Output: • PCM Stereo — Sets the HDMI audio format to PCM Stereo , this is useful if you have an audio receiver connected that is not a 5.1 channel receiver . • Bitstream Legacy — Sends a DTS or Dolby Digital bitstream from the disc ov er the HDMI connections. Blu-ray audio is limited to the soundtrack for the main movie (no P ...
-
RCA RTB1013 - page 24
- 23 - The Settings Menu Stereo Downmix: Allows you to do wnmix the multi-channel audio into fewer channels . • Stereo (LoRo) — Downmixes the multi-channel audio into two channel stereo . Choose when the Blu-ray disc player is connected to the equipment that does not support vir tual surround function such as Dolby Pro L ogic. • Surround Enco ...
-
RCA RTB1013 - page 25
- 24 - 3. Press or button to select Wi re d , then press OK button. The IP Settings screen appears. If the network connection is active, Link Up appears next to Link Status . If the network connection is not active, Link Down displays next to Link Status . 4. Press or button to select IP Mode , then press OK button. 5. Press or button to select an ...
-
RCA RTB1013 - page 26
- 25 - The unit does not switch on. • Make sure it is plugged in. • Press ON/OFF button on the remote contr ol or ON/ ST ANDBY button on the front of the unit. The device switches o spontaneously. • T o save pow er , the device switches off aut omati- cally when it is not being used for more than 30 minutes. Switch it on again. • If the ...
-
RCA RTB1013 - page 27
- 26 - correctly . • T est the I nternet connection to make sure that it is working. • Make sure that the BD-Live Internet Access op- tion is not set to Prohibit A ccess. • Make sure that the disc your ar e playing is a legal copy. After connecting to the Internet, I cannot down- load a le • Erase BD Storage. • Make sure that the inte ...
-
RCA RTB1013 - page 28
- 27 - Precautions Use • If your unit has been stored in a c ool place for any length of time, during a journey for example , wait for about 2 hours befor e using it. • The openings located on the top and bottom are for ven tilation and must not be obstructed. • During thunderstorms, w e recommend that you isolate the unit from the electrical ...
-
RCA RTB1013 - page 29
- 28 - DVD-Video Digital video discs - 12 cm, single or double sided, single or dual layer . DVDs are high density optical discs on which high quality picture and audio are recorded by means of dig ital signals. DVD-R, DVD-R W , DVD+R, DVD+RW Most DVD-R and DVD+R (one recording only), DVD-RW and DVD+R W discs (rewritable), depending on the DVD writ ...
-
RCA RTB1013 - page 30
- 29 - Internet Con tent and Services Disclaimer All internet content and services accessible through this device belong to thir d parties and are protected by copyright, patent, trademark and/or other intellectual proper ty laws. Such internet content and services are provided solely for y our personal noncommercial use, and y ou may not use such ...
-
RCA RTB1013 - page 31
- 30 - A VC MUL TIMEDIA ("A VC") makes the following limited warranty . These limited warranties extend to the original consumer purchaser and is limited t o non-commercial user of the product. One Y ear Parts & Labor Warr anty A VC products purchased in the United States are warrant ed to be free from defects in materials or workmans ...
-
RCA RTB1013 - page 32
- 31 - Printed in China 811-101391W010 All warranties implied by state law , including the implied warranties of merchantability and fi tness for a particular purpose, are expressly limited to the duration of the limited warranties set f or th above . W ith the exception of any warranties implied b y state law as hereby limited , the foregoing war ...
Hai una domanda su RCA RTB1013?
Utilizza il modulo sottostante
Se non hai risolto il problema con RCA RTB1013 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con RCA RTB1013 è probabile che voglia condividere il modo di risolverlo.