Italiano dropdown-ico

Manuale per l’uso Electrolux E36GF75GPS

30 pagine 0.94 mb
Scarica

Vai alla pagina of 30

Summary
  • Electrolux E36GF75GPS - page 1

    318201761 E30GF74GPS E36GF75GPS E36GF76GPS ...

  • Electrolux E36GF75GPS - page 2

    2 Finding Information READ AND SA VE THESE INSTRUCTIONS Read all instructions before installing the range. For your safety, please read and observe all safety instructions. This guide will help you anticipate all installations connections. NO NO NO NO NO TE TE TE TE TE Installer: Leave instructions with owner . Owner: Read your range Use & Care ...

  • Electrolux E36GF75GPS - page 3

    3 Finding Information T ABLE OF CONTENTS Please Read And Save This Guide .................... 2 Questions .......................................................... 2 T able Of Content s ............................................. 3 Safety ..................................................................... 4 Important Safety Instructions ...... ...

  • Electrolux E36GF75GPS - page 4

    4 Safety IMPORT ANT SAFETY INSTRUCTIONS ...

  • Electrolux E36GF75GPS - page 5

    5 Safety SAFETY PRECAUTIONS ...

  • Electrolux E36GF75GPS - page 6

    6 Safety WARNING WARNING WARNING WARNING WARNING Never use this appliance as a space heater to heat or warm a room. Doing so may result in carbon monoxide poisoning and overheating of the oven. ...

  • Electrolux E36GF75GPS - page 7

    7 NO NO NO NO NO TE TE TE TE TE This range is shipped from the factory pre-set for use with natural gas. For LP conversion see the accompanying LP Conversion Kit. The electrical information in the table is also located on the serial number label on the range. VERIFY P ACKAGE CONTENTS GAS AND ELECTRIC REQUIREMENT T ABLE • Literature Pack • Gridd ...

  • Electrolux E36GF75GPS - page 8

    8 Prep aring for Inst allation ELECTRICAL POWER SUPPL Y REQUIREMENTS It is the owner’s responsibility to ensure that the electrical connection of this appliance is performed by a qualified electrician. The electrical installation, including minimum supply wire size and grounding, must be in accordance with the National Electric Code ANSI/NFPA 70- ...

  • Electrolux E36GF75GPS - page 9

    9 Prep aring for Inst allation GAS AND ELECTRICAL ROUGH-IN Locations A manual shut valve must be installed in the gas piping, external to the appliance, for the purpose of turning on or shutting off gas to the appliance. Place the location of the range and the gas supply to allow access to the valve when the unit is installed. Access to the remote ...

  • Electrolux E36GF75GPS - page 10

    10 Prep aring for Inst allation CABINET AND COUNTERTOP PREP ARA TION NO NO NO NO NO TES TES TES TES TES • If cabinet storage space is to be provided directly above the range, the risk of personal injury may be reduced by installing a ventilating hood that projects horizontally a minimum of 5 inches beyond the face of the cabinets. • The range m ...

  • Electrolux E36GF75GPS - page 11

    11 Prep aring for inst allation GENERAL DIMENSIONS Plan the installation so that the electrical connection, gas shut-off valve, and pressure regulator are accessible from the front of the cabinet. Model E30GF74 Series E36GF75 Series E36GF76 Series “A” 30” (762 mm) Minimum Recommended 36” (914 mm) Minimum Recommended 36” (914 mm) Minimum R ...

  • Electrolux E36GF75GPS - page 12

    12 Prep aring for Inst allation GENERAL DIMENSIONS ...

  • Electrolux E36GF75GPS - page 13

    13 Prep aring for Inst allation WOOD/COMPOSITE OVERLA Y INST ALLA TION The bottom of an overhead hood should be 30” minimum to 36” above the countertop. This would typically result in the bottom of the hood being 66” to 72” above the floor . These dimensions provide safe an efficient operation of the hood. ...

  • Electrolux E36GF75GPS - page 14

    14 INST ALLING THE ANTI-TIP BRACKET Inst allation FIG. 3 ** **Note: Increase or decrease this dimension as necessary for range top to be flush with countertop. ...

  • Electrolux E36GF75GPS - page 15

    15 Figure 3 Backguard Installation (36" range shown) Backguard WARNING WARNING WARNING WARNING WARNING Be sure the range is not connected to gas or power before proceeding. Inst allation INST ALLING THE 36” RANGE OPTIONAL BACKGUARD Y our Electrolux Icon MR range was shipped with a backguard in place. These instructions cover the installation ...

  • Electrolux E36GF75GPS - page 16

    16 WARNING WARNING WARNING WARNING WARNING Do not attempt to disengage the hinge catches with the door removed from the oven. The hinge springs could release causing personal injury . Do not lift or carry the oven door by the handle door . Figure 4 T o remove oven door , rotate catch as shown. REMOVING THE OVEN DOOR Open the door to its fully opene ...

  • Electrolux E36GF75GPS - page 17

    17 Inst allation 1 The range is equipped with a three-prong power cord (grounding plug which mates with a standard three-prong grounding wall receptacle to minimize the possibility of electrical shock hazard from the range). 2 Where a standard two-prong wall receptacle is encountered, it is the responsibility and obligation of the customer to have ...

  • Electrolux E36GF75GPS - page 18

    18 Inst allation CONNECT RANGE TO GAS SUPPL Y INST ALLING THE RANGE Measure from the floor to the countertop and adjust the leveling legs as required to position the top frame at the desired height, based on the cabinet and countertop installation. Carefully slide the range into position in the cutout. Installing the burner components Remove the bu ...

  • Electrolux E36GF75GPS - page 19

    19 WARNING WARNING WARNING WARNING WARNING • The range and shut-off valve must be disconnected from the gas supply piping during any pressure testing exceeding 1/2 psi (3.5kPa). • The range must be isolated from the gas supply piping by closing the shut-off valve during any pressure testing at or below 1/2 psi (3.5kPa). NO NO NO NO NO TES TES T ...

  • Electrolux E36GF75GPS - page 20

    20 Operation TO ENSURE PROPER AND SAFE OPERA TION • Read all instructions before using this appliance. Install or locate the appliance only in accordance with the provided Installation Instructions. • Do not attempt to adjust, rep air , service, or replace any part of your appliance unless it is specifically recommended in this guide. • Do no ...

  • Electrolux E36GF75GPS - page 21

    21 INST ALLA TION AND SER VICES MUST BE PERFORMED BY A QUALIFIED INST ALLER. IMPORT ANT : SA VE FOR THE LOCAL ELECTRICAL INSPECTOR’S USE. READ AND SA VE THESE INSTRUCTIONS FOR FUTURE REFERENCE. INSTRUCTIONS FOR CONVERTING RANGE OPERA TION TO OPERA TE ON LP GAS Conversion T o LP Gas WARNING WARNING WARNING WARNING WARNING This conversion kit must ...

  • Electrolux E36GF75GPS - page 22

    22 IMPOR IMPOR IMPOR IMPOR IMPOR T T T T T ANT ANT ANT ANT ANT After replacing the natural gas to LP orifices, be sure to keep the original factory installed natural gas orifices for future range conversion back to natural gas. The factory orifices are marked with the following: T op Burners 165; Oven Burner 226; Oven Broiler 185; Griddle 206; Main ...

  • Electrolux E36GF75GPS - page 23

    23 HOW TO CONVERT THE RANGE FOR USE WITH LP/PROP ANE GAS WARNING WARNING WARNING WARNING WARNING a. Electrical shock hazard can occur and result in injury or death. Disconnect electrical power to the range before servicing. Do not remove regulator or allow it to turn during servicing. b. Unscrew the cap from the regulator . Do not remove the spring ...

  • Electrolux E36GF75GPS - page 24

    24 a. Remove top grates, burner caps and inner burner rings. b. Lift off outer burner heads and burner bases. c. Remove the factory installed natural gas orifices from the center of the orifice holders using a 7mm nut driver . Remember to keep the original natural gas orifices for future conversions back to natural gas. Refer to page 22 under “IM ...

  • Electrolux E36GF75GPS - page 25

    25 a. Remove the toe kick panel. b. Remove the two (2) screws on the bottom of the toe kick panel. Hold the bottom edge of toe kick panel at the middle section and slightly lift towards the front. Hold the toe kick panel on both ends and slowly pull away towards the front. c. Remove the (2) screws holding the orifice bracket and locate the orifice. ...

  • Electrolux E36GF75GPS - page 26

    26 a. Remove back cover (See Fig. a) b. Using an adjustable wrench, remove the orifice from the orifice holder . Replace with oven broiler orifice size (#55). Conversion T o LP Gas CONVERT BROIL BURNER ORIFICE FOR LP/ PROP ANE GAS (16.500 BTU) a. b. ...

  • Electrolux E36GF75GPS - page 27

    27 Conversion T o LP Gas a. Remove back cover (See “Fig. a” on previous page) b. Carefully remove the griddle plate using caution as the plate is very heavy . As the plate’s lif ted, make sure to remove the thermostat located beneath the plate. c. Using an adjustable wrench, remove the orifice from the orifice holder . Replace with griddle or ...

  • Electrolux E36GF75GPS - page 28

    28 CONVERT GAS VAL VES FOR LP/PROP ANE GAS a. Remove control knobs, bezel and control panel. b. Using a flat screwdriver , replace main burner bypass jets with bypass jet s for LP and simmer byp ass jet s with byp ass jet s for LP . Save the main bypass jets (blue for NG) in the plastic bag labeled main jets and simmer bypass (blue for NG) jets in ...

  • Electrolux E36GF75GPS - page 29

    29 Conversion T o LP Gas RECONNECT GAS AND ELECTRICAL SUPPL Y T O RANGE Leak testing of the appliance shall be conducted according to the installation instructions provided with the range. Checking for Manifold Gas Pressure If it is necessary to check the manifold gas pressure, remove the burner cap, inner ring, outer burner head and burner base of ...

  • Electrolux E36GF75GPS - page 30

    30 AIR SHUTTER OVEN BURNER The air shutter for the oven burner may need adjustment, especially if the unit has been converted for use with LP/Propane gas. The approximate flame length of the oven burner is one inch (distinct inner blue flame). T o Determine if the oven burner flame is proper: a. With the toe kick removed, set the oven to bake at 35 ...

Fabbricante Electrolux Categoria Range

I documenti che otteniamo dal fabbricante del dispositivoElectrolux E36GF75GPS possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Electrolux
- manuali per l’uso E36GF75GPS
- schede prodotto Electrolux
- opuscoli
- o etichette energetiche Electrolux E36GF75GPS
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Electrolux E36GF75GPS.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Electrolux E36GF75GPS, manuali di manutenzione, brevi manuali o manuali utente Electrolux E36GF75GPS. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Electrolux E36GF75GPS.

Manuali per l’uso simili

Manuale completo del dispositivo Electrolux E36GF75GPS, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Electrolux E36GF75GPS dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Electrolux E36GF75GPS.

Il manuale per l’uso completo Electrolux, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Electrolux E36GF75GPS - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Electrolux E36GF75GPS, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Electrolux E36GF75GPS che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Electrolux E36GF75GPS - che ci dovrebbe aiutare nei primi passi durante l'uso Electrolux E36GF75GPS
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Electrolux E36GF75GPS
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Electrolux E36GF75GPS in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Electrolux E36GF75GPS?

Utilizza il modulo sottostante

Se non hai risolto il problema con Electrolux E36GF75GPS con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Electrolux E36GF75GPS è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)