-
Weber 42376 - page 1
BUILT-IN LP SIDE BURNER INST ALLA TION/ OWNER'S GUIDE 42376 US 01/18/06 LP YOU MUST READ THIS O WNERS GUIDE BEF ORE OPERA TING YOUR G A S GRILL DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open fl ames. 3. Open lid. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or ...
-
Weber 42376 - page 2
2 DANGERS & W ARNINGS DANGER Failure to follow the Dangers, W arnings and Cautions contained in this Owner ’s Manual may result in serious bodily injury or death, or in a fi re or an explosion causing damage to property . W ARNINGS Do not store a spare or disconnected liquid propane cylinder under or near this barbecue. ? ...
-
Weber 42376 - page 3
3 STORA GE AND/ OR NONUSE • The gas must be turned of f at the liquid propane cylinder when the Weber ® gas barbecue is not in use. OPERA TING W ARNING: Only use this barbecue outdoors in a well-ventilated area. Do not use in a garage, building, breezeway or any other enclosed area. W ARNING: Y our Summit® Built-In gas barbecue shall no ...
-
Weber 42376 - page 4
4 L OCA TING YOUR BUIL T -IN SIDE BURNER When determining a suitable location for your Built-In Side Burner installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the Sum- mit ® Built-In Side Burner in a garage, breezeway , shed, under an ...
-
Weber 42376 - page 5
5 MOUNTING THE SIDE BURNER Connect the corrugated gas line to the side burner valve located on the back right hand side of side burner . TEST CONNEC TIONS All connections and joints must be thoroughly tested for leaks in accordance with local codes and all listed procedures in the latest edition of ANSI Z223.1/NFP A 54. BUIL T -IN GAS LINE LOCA TIO ...
-
Weber 42376 - page 6
6 TYPICAL BULK PROP ANE GAS SUPPL Y INST ALLA TION We recommend that this installation be done by a LICENSED professional. General Specifi cations for Piping Note - Contact your local municipality for building codes regulating outdoor gas grill installations. In absence of Local Codes, you must conform to the latest edition of the National Fuel Ga ...
-
Weber 42376 - page 7
7 TYPICAL 20 LP PROP ANE GAS SUPPL Y INST ALLA TION We strongly recommend that you use the Summit ® Built-In T ank Cabinet (#21280) for installations using a 20 lb LP cylinder , mounted remotely in an “island” structure. The Summit ® Built-In T ank Cabinet is a CSA listed accessory for installing a remote mounted 20 lb LP cylinder , in an “ ...
-
Weber 42376 - page 8
8 3). The minimum size of the ventilation hole (s) should not be less than 1/4 inch. d). The remote LP cylinder enclosure should be constructed with non- combustible materials. The remote LP cylinder enclosure should isolate the LP cylinder from the burner compartment, so that it provides shielding from radiation, be a fl ame barrier and provide p ...
-
Weber 42376 - page 9
9 GAS INSTRUC TIONS FILL LIQUID PROP ANE CYLINDER T o fi ll, take the liquid propane cylinder and fi ller adapter to an R V center or look up gas-propane in the phone book for other sources of liquid propane gas. W ARNING: We recommend that your liquid propane cylinder be fi lled at an authorized liquid propane gas dealer by a qualifi ed at ...
-
Weber 42376 - page 10
10 T o Connect the hose to the cylinder: 3) Remove the plastic dust cover from the valve. 4) Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand-tighten only . Note: This connection tightens clockwise and will not allow gas to fl ow unless the connection is tight. The connection requires tightening by hand only . ...
-
Weber 42376 - page 11
11 Check: 3) “T” Connection-to-Hose connections. 4) The hose-to-Regulator connection. W ARNING: If there is a leak at connections (2,3, or 4), turn OFF the gas. DO NOT OPERA TE THE GRILL. Contact Customer Service 1-800-446-1071. When leak checks are complete, turn gas supply OFF at the source and rinse connections with water . OPERA TING (2 ...
-
Weber 42376 - page 12
12 LIGHTING THE SIDE BURNER. 1) Open the side burner lid. 2) Check that the side burner valve is turned OFF . (Push knob in and turn clockwise to ensure that it in the off position.) W ARNING: The burner control knob must be in the OFF position before turning on the liquid propane cylinder valve. If it is not in the OFF position, when you turn ...
-
Weber 42376 - page 13
13 CROSSOVER ® IGNITION S YSTEM OPERA TIONS If the Crossover ® ignition system fails to ignite the LEFT burner in a burner set, light the LEFT burner with a match. If the LEFT burner lights with a match, then check the Crossover ® ignition system. • Check that both ignition wires(1,2) are attached properly . • Check that the Crossover ® ign ...
-
Weber 42376 - page 14
14 SIDE BURNER MAINTENANCE W ARNING: All gas controls and supply valves should be in the OFF position. Make sure wire is connected between the igniter and electrode. Spark should be a white/blue color , not yellow . 1) Igniter Wire 2) Burner (3) Side Burner Grate Side Burner Cap Side Burner Ring & Head Igniter Electrode Control Knob Igniter ...
-
Weber 42376 - page 15
15 A TTENTION: This product has been safety tested and is only certifi ed for use in a specifi c country . Refer to country designation located on outer carton. These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co., Customer Service Department for genuine Weber-Stephen Products Co. replacement pa ...
-
Weber 42376 - page 16
©2003 The following trademarks are registered in the name of W eber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A. Australia; Smokey Joe, Weber , Kettle Silhouette ® , Genesis, Austria; Kettle Silhouette ® , Smokey Joe, Weber , Benelux; Kettle Silhouette ® , Smokey Joe, Weber , C ...
Hai una domanda su Weber 42376?
Utilizza il modulo sottostante
Se non hai risolto il problema con Weber 42376 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Weber 42376 è probabile che voglia condividere il modo di risolverlo.