-
Xilinx ML506 - page 1
ML505/506 QuickStart May 2008 ...
-
Xilinx ML506 - page 2
Overview • Setup • Boot with ACE-loader ACE File • Observe LCD and Terminal messages • Load new Configuration • Re-load ACE-loader ...
-
Xilinx ML506 - page 3
ML505 BSB Hardware • The ML505 MicroBlaze design hardware includes: – DDR2 Interface (256 MB) – BRAM – External Memory Controller (EMC) • ZBT SRAM – Networking – UART – Interrupt Controller – System ACE CF Interface – GPIO (IIC, LEDs and LCD) – PLB Arbiter Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 4
Additional Setup Details • Refer to ml505_overview_setup document for details on: – Software Requirements – ML505 Board Setup • Equipment and Cables • Software • Network – Terminal Programs • This presentation requires the 9600-8-N-1 Baud terminal setup Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 5
Hardware Setup • Connect the Xilinx Parallel Cable IV (PC4) to the ML505 board • Connect the RS232 null modem cable to the ML505 board Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 6
Hardware Setup • The ML505 uses a DVI video interface • Connect a DVI monitor or • Use a DVI/VGA adapter to connect a VGA monitor – http://www.belkin.com Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 7
Hardware Setup • USB Keyboard – www.dell.com Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 8
Factory CompactFlash • The CompactFlash shipped with the ML505 board has the following ace files preloaded: Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 9
Verify Factory Default Settings • Set the Ethernet PHY jumpers, J22, J23 to positions 1-2 (1) • Insert the Factory CompactFlash into the ML505 board (2) • Set the Front DIP switches (SW3) to 00010101 (1 = ON) (3) • Set the Rear DIP switches (SW6) to 11001010 (4) • Power-up the ML505 board 4 Note: Presentation applies to the ML505 and ML50 ...
-
Xilinx ML506 - page 10
Bootload • The system_bootload.ace loads: Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 11
Bootload • The terminal window also reflects the bootload application • Use the left/center/right buttons to choose an application or type a number in the terminal window • After each demo, push the SysACE reset to return to bootload Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 12
Slideshow • Type 1, to launch the slideshow application in Configuration 1 • The slideshow loads the presentation into memory then presents it Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 13
Slideshow • The slideshow app will present a series of slides on the Monitor: Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 14
Web Server • Type 2, to launch the web server application in Configuration 2 – Note : You may need to turn off your br owser's proxy and specify a direct connection to the Internet in your browser options Note: Host IP is 1.2.3.9, subnet mask is 255.0. 0.0; Ethernet connection is 100 Full Duplex ...
-
Xilinx ML506 - page 15
Web Server • In your web browser, enter http://1.2.3.4:8080/index.html Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 16
Simon • Type 3, to launch the Simon application in Configuration 3 Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 17
Board Diagnostics • Type 4, to launch the XROM application in Configuration 4 Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 18
Board Diagnostics • XROM includes a series of board test routines Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 19
USB Keyboard • Type 5, to launch the USB Keyboard application in Configuration 5 • Type ML505 and view results: Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 20
My ACE • Type 6, to launch the My ACE application in Configuration 6 Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 21
Ringtone • Type 7, to launch the Ringtone application in Configuration 7 • Press any key then press 1-7 to play a simple melody Note: Presentation applies to the ML505 and ML506 ...
-
Xilinx ML506 - page 22
Documentation • Virtex-5 – Silicon Devices http://www.xilinx.com/products/silicon_solutions – Virtex-5 Multi-Platform FPGA http://www.xilinx.com/products/silicon_solutions/fpgas/virtex/virtex5 – Virtex-5 Family Overview: LX, LXT, SXT, and FXT Platforms http://www.xilinx.com/support/docum entation/data_sheets/ds100.pdf – Virtex-5 FPGA DC a ...
-
Xilinx ML506 - page 23
Documentation • Virtex-5 – Virtex-5 FPGA User Guide http://www.xilinx.com/support/docum entation/user_guides/ug190.pdf – Virtex-5 FPGA Configuration User Guide http://www.xilinx.com/support/docum entation/user_guides/ug191.pdf – Virtex-5 System Monitor User Guide http://www.xilinx.com/support/docum entation/user_guides/ug192.pdf – Virtex- ...
-
Xilinx ML506 - page 24
Documentation • Virtex-5 RocketIO – RocketIO GTP Transceivers http://www.xilinx.com/products/silicon_solutions/fpgas/virtex/virtex5/ capabilities/RocketIO_GTP.htm – RocketIO GTX Transceivers http://www.xilinx.com/products/silicon_solutions/fpgas/virtex/virtex5/ capabilities/RocketIO_GTX.htm – RocketIO GTP Transceiver User Guide – UG196 ht ...
-
Xilinx ML506 - page 25
Documentation • MicroBlaze – MicroBlaze Processor http://www.xilinx.com/microblaze – MicroBlaze Processor Reference Guide – UG081 http://www.xilinx.com/support/documentation/sw_manuals/mb_ref_guide.pdf ...
-
Xilinx ML506 - page 26
Documentation • Memory Solutions – Demos on Demand – Memory Interface Solutions with Xilinx FPGAs http://www.demosondemand.com/clients/xilinx/001/page_new2/index.asp#35 – Xilinx Memory Corner http://www.xilinx.com/products/design_resources/mem_corner – Additional Memory Resources http://www.xilinx.com/support/software/memory/protected/ind ...
-
Xilinx ML506 - page 27
Documentation • Ethernet – Virtex-5 Embedded Tri-Mode Ethernet MAC Wrapper Data Sheet http://www.xilinx.com/support/documentation/ip_documentation/ v5_emac_ds550.pdf – Virtex-5 Embedded Tri-Mode Ethernet MAC Wrapper Getting Started Guide http://www.xilinx.com/support/documentation/ip_documentation/ v5_emac_gsg340.pdf – Virtex-5 Tri-Mode Eth ...
-
Xilinx ML506 - page 28
Documentation • ML505/506/507 – ML505 Overview http://www.xilinx.com/ml505 – ML506 Overview http://www.xilinx.com/ml506 – ML507 Overview http://www.xilinx.com/ml507 – ML505/506/507 Evaluation Platform User Guide – UG347 http://www.xilinx.com/support/doc umentation/boards_and_kits/ug347.pdf – ML505/506/507 Getting Started Tutorial – ...
-
Xilinx ML506 - page 29
Documentation • ML505/506/507 – ML505/506/507 Schematics http://www.xilinx.com/support/d ocumentation/boards_and_kits/ ml50x_schematics.pdf – ML505/506/507 Bill of Material http://www.xilinx.com/support/d ocumentation/boards_and_kits/ ml505_501_bom.xls ...
Hai una domanda su Xilinx ML506?
Utilizza il modulo sottostante
Se non hai risolto il problema con Xilinx ML506 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Xilinx ML506 è probabile che voglia condividere il modo di risolverlo.