Manuale per l’uso Kenwood Ez700SR

23 pagine 0.94 mb
Scarica

Vai alla pagina of 23

Summary
  • Kenwood Ez700SR - page 1

    Ez900HDS Ez700SR CD-RECEIVER INSTR UCTION MANU AL AMPLI-TUNER-LECTEUR DE CD MODE D’EMPLOI REPRODUCT OR DE DISCOS COMP A CTOS RECEPT OR DE FM/AM MANU AL DE INSTR UCCIONES © B64-3019-00/00 (K)(A) T ake the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance ...

  • Kenwood Ez700SR - page 2

    2 | English English | 3 Con tents 2 W arning 2 CAUTION Use of controls or adjustments or performance of procedures other than those specified her ein may result in hazardous radiation exposur e. In compliance with Federal Regulations, f ollowing are repr oductions of labels on, or inside the product relating to laser product saf ety. KENWOOD CORPOR ...

  • Kenwood Ez700SR - page 3

    4 | English English | 5 Safety precautions About CD play ers/disc changers connected to this unit KENWOOD disc changers/ CD players released in 1999 or later can be connected to this unit. Refer to the catalog or consult your Kenw ood dealer for connectable models of disc changers/ CD players. Note that any KENWOOD disc changers/ CD players release ...

  • Kenwood Ez700SR - page 4

    6 | English English | 7 Handling CDs • Don ’t touch the recording surface of the CD. • CD-R and CD-R W are easier to damage than a normal music CD. Use a CD-R or a CD-R W after reading the caution items on the package etc. • Don ’t stick tape etc. on the CD. Also, don ’t use a CD with tape stuck on it. When using a new CD If the CD cent ...

  • Kenwood Ez700SR - page 5

    8 | English English | 9 Notes on playing MP3/WMA Ez900HDS/Ez700SR can play MP3 (MPEG1, 2 Audio Layer 3)/WMA. Not e, however , that the MP3/WMA recording media and f ormats acceptable are limited. When wr iting MP3/WMA, pay attention t o the following restrictions. Acc eptable media The MP3/WMA recor ding media acceptable to this unit are CD-ROM, CD ...

  • Kenwood Ez700SR - page 6

    10 | English English | 11 General fea tures Powe r T urning ON the Power Press the [SRC] button. T urning OFF the Power Press the [SRC] button for at least 1 sec ond. V olume Increasing V olume T urn the [ VOL] knob clockwise. Decreasing V olume T urn the [ VOL] knob counterclockwise. Attenua tor T urning the volume down quickly . Press the [ A T T ...

  • Kenwood Ez700SR - page 7

    12 | English English | 13 General fea tures Speaker Setting Fine-tuning so that the System Q value is optimal when setting the speaker type. 1 Enter Standby Press the [SRC] button. Select the "ST ANDBY" display. 2 Enter Speaker Setting mode Press the [ AUDIO ] knob. 3 Select the Speaker type T urn the [ 4 ] / [ ¢ ] knob. Each time the kn ...

  • Kenwood Ez700SR - page 8

    14 | English English | 15 General fea tures Subw oofer Output T urning the Subwoofer output ON or OFF . Press the [SW] button for at least 1 second. Each time the button is pressed Subwoof er output switches ON or OFF . When it’ s ON, "Sub -W ON" is displayed . Theft Deterrent F a cepla te The faceplate of the unit can be detached and t ...

  • Kenwood Ez700SR - page 9

    16 | English English | 17 T uner featur es F unction of remote Direct Acc ess T uning Entering the frequency and tuning. 1 Select the band Press the [F M] / [AM] button. 2 Enter Direct Acc ess T uning mode Press the [DIRECT ] button on the remote . "– – – –" is displayed. 3 Enter the frequency Press the number buttons on the r emo ...

  • Kenwood Ez700SR - page 10

    18 | English English | 19 T uning Selecting the station. 1 Select HD R adio source Press the [SRC] button. Select the "HD Radio" display. 2 Select the band Press the [F M] button. Each time the [FM] button is pr essed, it switches between the HF1, HF2, and HF3 bands. When the [AM] button is pr essed, it switches HA band. 3 T une up or dow ...

  • Kenwood Ez700SR - page 11

    20 | English English | 21 SIRIUS featur es Channel Preset Memory Putting the channels in the memory. 1 Select the band Press the [F M] button. 2 Select the channel to put in the memor y T urn the [ 4 ] / [ ¢ ] knob. 3 Put the channel in the memory Press the desired [1] — [6] butt on for at least 2 seconds. The preset number display blinks 1 time ...

  • Kenwood Ez700SR - page 12

    22 | English English | 23 CD/MP3/WMA/External disc control f eatures Playing External Disc Playing discs set in the optional accessory disc player connected to this unit. Press the [SRC] button. Select the display for the disc player you want. Display examples: Display Disc player "CD2" CD player "CD CH" CD changer "MD CH&q ...

  • Kenwood Ez700SR - page 13

    24 | English English | 25 CD/MP3/WMA/External disc control f eatures T rack/File/Disc/F older Repeat Replaying the song, disc in the Disc changer or MP3/WMA folder y ou’ re listening to . Press the [REP] button. Each time the button is pressed the Repeat Pla y switches as shown below . In CD & External disc source Repeat play Display T rack R ...

  • Kenwood Ez700SR - page 14

    26 | English English | 27 Menu system Menu Sy stem Setting during operation beep sound etc. functions. The Menu system basic operation method is explained here. The reference f or the Menu items and their setting content is after this operation explanation. 1 Enter Menu mode Press the [MENU] button f or at least 1 second. "MENU" is displa ...

  • Kenwood Ez700SR - page 15

    28 | English English | 29 Menu system Con trast Adjustmen t Adjusting the display contrast. Display and Setting "Con trast 0" … "Con trast 7" (Original setting) … "Con trast 10" Dimmer Dimming this unit’ s display automatically when the vehicle light switch is turned ON. Display Setting "Dimmer ON" The ...

  • Kenwood Ez700SR - page 16

    30 | English English | 31 Menu system In HD Radio mode Receiv e mode Setting Sets the receive mode . 1 Select the Receive mode Press the [ AUDIO ] knob. Select the "Receive Mode" display. • This function can be used the [FM] / [AM] button. 2 Enter Receive mode Press the [MENU] button. 3 Set the Receive mode Press the [ AUDIO ] knob. Eac ...

  • Kenwood Ez700SR - page 17

    32 | English English | 33 In SIRIUS source SIRIUS Lock C ode S etting If you have locked any str eams in the channel lock mode, you will need to ent er 4 digit Lock Code to unlock them. Y ou can change the Lock Code (default is “0000”) as you like. 1 Select Lock Code mode Press the [ AUDIO ] button. Select the "Lock Code" display . ? ...

  • Kenwood Ez700SR - page 18

    34 | English English | 35 Basic Operations of r emote In T uner source [FM]/ [ AM] buttons Select the band. Each time the [FM] button is pr essed it switches between the FM1, F M2, and FM3 bands. [ 4 ]/ [ ¢ ] buttons T une up or down band. [0] — [9] buttons Pr ess buttons [1] — [6] to recall preset stations. [DIRECT ] button Enters and cancels ...

  • Kenwood Ez700SR - page 19

    36 | English English | 37 Connecting W ires to T erminals MUTE ANT CONT P.CONT FRONT L FRONT R REAR L REAR R – + AUX IN REAR SUB WOOFER FRONT FM/AM antenna input F use (10A) Wiring harness (Accessory 1 ) Ignition wire (Red) Battery wire ( Y ellow) Ground wire (Black) - ( T o car chassis) Ignition key switch Car fuse box (Main fuse) ACC Car fuse b ...

  • Kenwood Ez700SR - page 20

    38 | English English | 39 Screwing the F aceplate on the Unit If you want to fasten the faceplate to the main unit so that it does not fall off . 1 Ref er to the section <Removing the hard rubber frame> (page 40) and then remove the hard rubber frame. 2 Drop open the faceplat e by pressing the Release button. 3 Tighten the scr ews (ø2.6 × 1 ...

  • Kenwood Ez700SR - page 21

    40 | English English | 41 T roubleshooting Guide What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Befor e calling ser vice, first check the following table f or possible problems. Gener al ? Can't select the source. ✔ Can't be selecting the source without SIRIUS. ☞ Subscribe ...

  • Kenwood Ez700SR - page 22

    42 | English English | 43 The messages shown belo w display your systems condition. EJEC T: No disc magazine has been loaded in the changer . The disc magazine is not completely loaded. ➪ Load the disc magazine properly. No CD in the unit. ➪ Inser t the CD. No Disc: No disc has been loaded in the disc magazine. ➪ Load a disc into the disc mag ...

  • Kenwood Ez700SR - page 23

    English | 45 44 | English Specifications Specifications subject to change without notice. Analog FM tuner section Fr equency range (200 kH z space) : 87.9 MHz – 107.9 MH z Usable sensitivity (S/N = 30dB) : 9.3dBf (0.8 µV/75 Ω) Quieting Sensitivity (S/N = 50dB) : 15.2dBf (1.6 µV/75 Ω) Fr equency response (±3 dB) : 30 Hz – 15 kH z Signal t ...

Fabbricante Kenwood Categoria Car Stereo System

I documenti che otteniamo dal fabbricante del dispositivoKenwood Ez700SR possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Kenwood
- manuali per l’uso Ez700SR
- schede prodotto Kenwood
- opuscoli
- o etichette energetiche Kenwood Ez700SR
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Kenwood Ez700SR.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Kenwood Ez700SR, manuali di manutenzione, brevi manuali o manuali utente Kenwood Ez700SR. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Kenwood Ez700SR.

Manuali per l’uso simili

Manuale completo del dispositivo Kenwood Ez700SR, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Kenwood Ez700SR dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Kenwood Ez700SR.

Il manuale per l’uso completo Kenwood, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Kenwood Ez700SR - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Kenwood Ez700SR, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Kenwood Ez700SR che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Kenwood Ez700SR - che ci dovrebbe aiutare nei primi passi durante l'uso Kenwood Ez700SR
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Kenwood Ez700SR
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Kenwood Ez700SR in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Kenwood Ez700SR?

Utilizza il modulo sottostante

Se non hai risolto il problema con Kenwood Ez700SR con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Kenwood Ez700SR è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)