Italiano dropdown-ico

Manuale per l’uso Omnitron Systems Technology 564 SS

28 pagine 1.64 mb
Scarica

Vai alla pagina of 28

Summary
  • Omnitron Systems Technology 564 SS - page 1

    564 SS F i r e p l ace • Operation • Maintenance Tested and Listed by OMNI-Test Laboratories, Inc. Beaverton, Oregon Report # 028-F-80-5 ANSI Z21.88a-2003 WARNING: I f the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. - Do not store or use gaso ...

  • Omnitron Systems Technology 564 SS - page 2

    2 Introduction © Travis Industries 4070626 100-01189_000 Introduction We welcome you as a new owner of a 564 SS gas fireplace. This manual details operation and maintenance of this fireplace. Please familiarize yourself with the Owner's Manual before operating your heater and save the manual for future reference. Important Information No othe ...

  • Omnitron Systems Technology 564 SS - page 3

    Introduction 3 © Travis Industries 4070626 100-01189_000 Table of Contents Introduction and Important Information Introduction ............................................................. 2 Important Information ................................................ 2 Installation Warnings ................................................. 2 Features .. ...

  • Omnitron Systems Technology 564 SS - page 4

    4 Safety Precautions © Travis Industries 4070626 100-01189_000 IF YOU SMELL GAS: * Do not light any appliance * Extinguish any open flame * Do not touch any electrical switch or plug or unplug anything * Open windows and vacate building * Call gas supplier from neighbor's house, if not reached, call fire department This unit must be installed ...

  • Omnitron Systems Technology 564 SS - page 5

    Safety Precautions 5 © Travis Industries 4070626 100-01189_000 Do not place clothing or other flammable items on or near the heater. Because this heater can be controlled by a thermostat there is a possibility of the heater turning on and igniting any items placed on or near it. Light the heater using the built-in piezo igniter. Do not use matches ...

  • Omnitron Systems Technology 564 SS - page 6

    6 Operation © Travis Industries 4070626 100-01189_000 Before You Begin • Read this entire manual before you use your new fireplace (especially the section "Safety Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or even death. Location of Controls Lift the control cover ...

  • Omnitron Systems Technology 564 SS - page 7

    Operation 7 © Travis Industries 4070626 100-01189_000 Starting The Pilot Flame The pilot flame is required to ignite the main burners (it also plays a safety role). It should be left on once lit. It will stay lit unless the gas control valve is turned to "OFF". However, the pilot will go out if the gas is shut off, the propane tank runs ...

  • Omnitron Systems Technology 564 SS - page 8

    8 Operation © Travis Industries 4070626 100-01189_000 Starting the Fireplace for the First Time • Burn the heater at a high setting with the blower off for an extended period (up to 48 hours). This will cure the painted surfaces. Fumes from the paint curing and oil burning off the steel will occur. This is normal. We recommend opening a window t ...

  • Omnitron Systems Technology 564 SS - page 9

    Operation 9 © Travis Industries 4070626 100-01189_000 Adjusting the Optional Blower Speed The blower helps transfer heat from the heater into the room. It will not turn on until the heater is up to temperature (approximately 10 minutes after starting). See the illustration below for instructions on adjusting the blower speed. NOTE: With the rear b ...

  • Omnitron Systems Technology 564 SS - page 10

    1 0 Maintenance © Travis Industries 4070626 100-01189_000 Maintaining Your Fireplace's Appearance Fingerprints or other marks left on the optional plated surface may become etched in place if they are not wiped clean prior to turning the fireplace on. Clean the plated surface with denatured alcohol and a soft cloth (with the fireplace cool). ...

  • Omnitron Systems Technology 564 SS - page 11

    Maintenance 1 1 © Travis Industries 4070626 100-01189_000 Grill Installation and Removal Follow the directions below to install. Upper Grill Installation (FPX and Avalon) Hold the grill at an angle and insert the lower slot over the lower bushing on the fireplace (both sides) Swing the grill upwards to engage the upper slot. You will need to lift ...

  • Omnitron Systems Technology 564 SS - page 12

    1 2 Maintenance © Travis Industries 4070626 100-01189_000 Face Installation and Removal Some fireplaces have a face that fits over the glass frame. The face can be removed following the directions below. Phillips Screwdriver Four screws hold the face in place. The screws are accessed through the grills on the face. ...

  • Omnitron Systems Technology 564 SS - page 13

    Maintenance 1 3 © Travis Industries 4070626 100-01189_000 Glass Frame Removal and Installation Warning: The appliance must be completely cool before removing the glass. Warning: Do not strike or slam the glass. Based upon the face being used, either: (a) swing the access door down and remove the top grill, (b) remove the face (unscrew or lift off ...

  • Omnitron Systems Technology 564 SS - page 14

    1 4 Maintenance © Travis Industries 4070626 100-01189_000 Glass Frame Removal and Installation (continued) The latch can come loose from the latch assembly. This occurs only when it is rotated. Follow the directions below to re-install the latch if it comes loose. Top of Firebox Hold the latch at an angle and insert it into the slot on the glass f ...

  • Omnitron Systems Technology 564 SS - page 15

    Maintenance 1 5 © Travis Industries 4070626 100-01189_000 Log Set Installation Log Set Overview When installed, the logs should appear as shown below. Rear Log R ight Twig Left Log Left Twig R ight Log ...

  • Omnitron Systems Technology 564 SS - page 16

    1 6 Maintenance © Travis Industries 4070626 100-01189_000 Rear Log Installation The rear log has a flat notch on both sides that center it on the grate. Place the rear log on the grate and slide it all the way back until the log contacts the end- brackets on the grate. ...

  • Omnitron Systems Technology 564 SS - page 17

    Maintenance 1 7 © Travis Industries 4070626 100-01189_000 Right Log Installation The left log has a groove that fits over the grate. Note how the left side of the log rests on the burner but does not cover any burner holes. ...

  • Omnitron Systems Technology 564 SS - page 18

    1 8 Maintenance © Travis Industries 4070626 100-01189_000 Left Log Installation The left log has a groove that fits over the grate. Note how the right side of the log rests on the burner but does not cover any burner holes. ...

  • Omnitron Systems Technology 564 SS - page 19

    Maintenance 1 9 © Travis Industries 4070626 100-01189_000 Left Twig Installation The left twig should be positioned so the front edge contacts the grate as shown above. This hole fits over the pin on the rear log. ...

  • Omnitron Systems Technology 564 SS - page 20

    2 0 Maintenance © Travis Industries 4070626 100-01189_000 Right Twig Installation The right twig has two holes for the pins on the rear and right log. When in place the right twig will appear as shown above. ...

  • Omnitron Systems Technology 564 SS - page 21

    Maintenance 2 1 © Travis Industries 4070626 100-01189_000 Ember Installation A bag of embers is provided to further enhance the firebox. Place the embers on the firebox floor and on the burner. Do not place embers over any of the burner holes or air channels. ...

  • Omnitron Systems Technology 564 SS - page 22

    2 2 Maintenance © Travis Industries 4070626 100-01189_000 Glass Cleaning The glass may be cleaned with a non- abrasive cleaner. To clean the inside of the glass, simply remove the glass frame, place it on a non-scratching surface, and clean the inside surface. If the outside surface of the glass frame requires cleaning, follow the directions below ...

  • Omnitron Systems Technology 564 SS - page 23

    Maintenance 2 3 © Travis Industries 4070626 100-01189_000 Troubleshooting Table Problem: Possible Cause: Don't Call for Service Until You: Pilot Will Not Light A gas shut off valve is turned off The gas control knob isn't turned to "PILOT" The valve control knob isn't pushed in The igniter wasn't pressed repeatedly No ...

  • Omnitron Systems Technology 564 SS - page 24

    2 4 Maintenance © Travis Industries 4070626 100-01189_000 How this Fireplace Works This fireplace was designed with safety as the primary concern. Many of the components inside this fireplace are for safety purposes. Therefore, only certified gas service technicians should service this fireplace. What Turns the Main Burners On and Off This firepla ...

  • Omnitron Systems Technology 564 SS - page 25

    Maintenance 2 5 © Travis Industries 4070626 100-01189_000 Wiring Diagram Millivolt Wiring (stock configuration) Orange White Piezo Igniter Thermopile Red Thermocouple Copper Co-Axial Wire Red Optional Remote Control Spark Electrode Pilot Hood On/Off Switch Brown Optional Thermostat Optional Blower Wiring Harness 7 4 10 9 1 3 Optional Blowers Green ...

  • Omnitron Systems Technology 564 SS - page 26

    2 6 Limited 7 Year Warranty © Travis Industries 4070626 100-01189_000 To register your TRAVIS INDUSTRIES, INC. 7 Year Warranty, complete the enclosed Warranty card and mail it within ten (10) days of the appliance purchase date to: TRAVIS INDUSTRIES, INC., 4800 Harbour Pointe Blvd. SW, Mukilteo, WA 98275. TRAVIS INDUSTRIES, INC. warrants this gas ...

  • Omnitron Systems Technology 564 SS - page 27

    Optional Equipment 2 7 © Travis Industries 4070626 100-01189_000 Accessories The accessories listed below are available at your Travis dealer. To locate a dealer, visit: www.travisproducts.com Blower The optional blowers help transfer heat to your home. Firebacks There are several styles of decorative ceramic firebacks that fit inside the firebox ...

  • Omnitron Systems Technology 564 SS - page 28

    2 8 Index © Travis Industries 4070626 100-01189_000 Index Accessories .......................................................2 7 Adjusting the Flame Height ....................................8 Adjusting the Optional Blower Speed .......................9 Before You Begin ................................................6 Blower Operation (optional) ...

Fabbricante Omnitron Systems Technology Categoria Indoor Fireplace

I documenti che otteniamo dal fabbricante del dispositivoOmnitron Systems Technology 564 SS possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Omnitron Systems Technology
- manuali per l’uso 564 SS
- schede prodotto Omnitron Systems Technology
- opuscoli
- o etichette energetiche Omnitron Systems Technology 564 SS
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Omnitron Systems Technology 564 SS.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Omnitron Systems Technology 564 SS, manuali di manutenzione, brevi manuali o manuali utente Omnitron Systems Technology 564 SS. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Omnitron Systems Technology 564 SS.

Manuali per l’uso simili

Manuale completo del dispositivo Omnitron Systems Technology 564 SS, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Omnitron Systems Technology 564 SS dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Omnitron Systems Technology 564 SS.

Il manuale per l’uso completo Omnitron Systems Technology, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Omnitron Systems Technology 564 SS - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Omnitron Systems Technology 564 SS, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Omnitron Systems Technology 564 SS che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Omnitron Systems Technology 564 SS - che ci dovrebbe aiutare nei primi passi durante l'uso Omnitron Systems Technology 564 SS
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Omnitron Systems Technology 564 SS
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Omnitron Systems Technology 564 SS in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Omnitron Systems Technology 564 SS?

Utilizza il modulo sottostante

Se non hai risolto il problema con Omnitron Systems Technology 564 SS con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Omnitron Systems Technology 564 SS è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)