Manuale per l’uso Haier 650

20 pagine 0.71 mb
Scarica

Vai alla pagina of 20

Summary
  • Haier 650 - page 1

    Service-650 T win-tub Washing Machine Names of the parts.............the 2 nd cover Safety precautions ...............................1 Installation and adjustment ..................3 Introduction of the major functions .......5 Preparation before washing ................6 The musts in washing .........................7 Usage of the detergent ..... ...

  • Haier 650 - page 2

    Before Using Before Using Names of the par ts Buzzer Water-filling entrance Water inlet selector handle Wash selector Wash timer Control panel Overflow filter Quick water-filling entrance Cascade outlet Water level adjusting lever Lint filter Valve cover Pulsator Wash tub Drain hose Base frame Outer cover of the spin tub Inner cover of the spin tub ...

  • Haier 650 - page 3

    Before Using Before Using Safety precautions If the power cord is bad, to avoid risk it is required to replace it by the technicians of our special shop or the after-sale service department. Keep the pin of the power plug clean. Be sure to use three-phase receptacle. Earth the earthing terminal of the receptacle reliably. Do not put the machine at ...

  • Haier 650 - page 4

    Before Using Before Using Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. T ake special care of the children. Handicapped or children without care shall not use the machine. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine. Do not decompose, repair or alter t ...

  • Haier 650 - page 5

    Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause incomplete d ...

  • Haier 650 - page 6

    Extend the drain hose from the rear side How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. T ake off the drain hose from the cabinet. T ake the hose out of the fixing groove. (S ...

  • Haier 650 - page 7

    Using process Using process Intr oduction of the major function Use the foam-removing spinning to remove the extra detergent liquid. It can both shorten the washing time and save the water consumption. Foam-removing spinning Remove most of the foam extra detergent liquid. Remove the detergent liquid remained The effect is best when the laundries qu ...

  • Haier 650 - page 8

    Confirm if there's special requirement for the laundries. Clear the pocket. T ake out the coins , sand, hairpins etc. Fasten the buttons and zippers. When the pulsator is running , the buttons of the laundries may cause noise. For the sake of discretion,please put the laundries with buttons into other laundries. Preparation before washing 1.Co ...

  • Haier 650 - page 9

    Reference weight of the laundries Working suit up,down Jeans about 800g The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The largest capacity of this ...

  • Haier 650 - page 10

    Selection of the quantity of the washing powder list 1 Selection of the current , water level and washing time list 2 How to use the washing powder How to use the whitener Fill water to decided level. Dilute the whitener with container. Pour it slowly into the washing tub. Avoid using whitener on laundries with color or pattern as they are prone to ...

  • Haier 650 - page 11

    OFF OFF OFF OFF DRAIN STRONG ST ANDARD MAX Washing sequence Figure 1 Figure 2 Figure 3 Figure 4 Figure 5 WOOL WOOL WOOL Spin timer SPIN TIMER SPIN WASH Wash timer WASH TIMER WASH TIMER WASH SELECTOR Wash selector Buzzer BUZZER Water-filling entrance (T o set to below 2 minute, first set to 5 minute then turn it back. it can increase the service lif ...

  • Haier 650 - page 12

    Midway spinning 1. 2. 3. Put the laundries into the spin tub evenly and smoothly . Spin Run the foam-removing spinning. Push Push Proper Proper Outer cover of The spin tub Inner cover of The spin tub The laundries are slanting Gland No gland Using process Using process (1) Put the gland in properly. Please put in the gland properly even if the laun ...

  • Haier 650 - page 13

    Rinse with stored water Rinse with water-filing 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is below 2.4kg, please use "Standard" current. If you use "Strong&quo ...

  • Haier 650 - page 14

    Selection of the spin time list 3 Laundries Spin time (minutes) About 4~5 Bed sheet or blanket About 2~4 Underwear (knitwear) Swear (chemical fiber) About 1~2 Within 1 minute Blending thin laundries Using process Using process 1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and out ...

  • Haier 650 - page 15

    After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. 1 T ake off the overflow filter. As indicated in the figure, nip the elastic fixing claw and pull it to the direction of ...

  • Haier 650 - page 16

    Wipe the complete unit with soft cloth twisted dry. Wipe with neutral detergent if too dirty Do not wash it directly by water Using process Using process Cleaning the overflow filter 2. T ake off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1). 3. Cleaning the overflow fi ...

  • Haier 650 - page 17

    2~3L T rouble-shooting Answer to question Below 50 When the remained water is frozen Prevent the freezing (be sure to discharge the water completely after using) After complete draining, set the "W ASH SELECTOR" at "STRONG" or "ST ANDARD". If it is set at "DRAIN", it will be rather difficult for the frozen wa ...

  • Haier 650 - page 18

    T rouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do n ...

  • Haier 650 - page 19

    User's manual One One One One One Water inlet hose Water-filling jointer Gland Twin-tub washing machine Packing list ...

  • Haier 650 - page 20

    Type Model Power source Water level Water quantity about Rated washing capacity kg Rated input power W Dimension(mm) Wash pattern Weight kg Injection pressure Rated spinning capacity kg Twin-tub washing machine XPB50-22S 220V~, 50Hz High/43L Medium/36L Low/30L 5.0 5 Wash 380 Spin 150 L780 W428 H 90 New current + cascade 27 0.02MPa~0.2MPa Rated volt ...

Fabbricante Haier Categoria Washer

I documenti che otteniamo dal fabbricante del dispositivoHaier 650 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Haier
- manuali per l’uso 650
- schede prodotto Haier
- opuscoli
- o etichette energetiche Haier 650
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Haier 650.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Haier 650, manuali di manutenzione, brevi manuali o manuali utente Haier 650. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Haier 650.

Manuali per l’uso simili

Manuale completo del dispositivo Haier 650, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Haier 650 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Haier 650.

Il manuale per l’uso completo Haier, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Haier 650 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Haier 650, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Haier 650 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Haier 650 - che ci dovrebbe aiutare nei primi passi durante l'uso Haier 650
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Haier 650
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Haier 650 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Haier 650?

Utilizza il modulo sottostante

Se non hai risolto il problema con Haier 650 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Haier 650 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)