Manuale per l’uso Auto Page RF-350

16 pagine 0.3 mb
Scarica

Vai alla pagina of 16

Summary
  • Auto Page RF-350 - page 1

    1 RF - 350 PROFESSIONAL VEHICLE SECURITY SYSTEM WITH KEYLESS ENTRY INSTALLATION & USERS MANUAL (For Authorized Dealers Only) Please register your product at www.autopageusa.com THIS PRODUCT IS DES IGNED FOR PROFESSIONAL INSTALLATION ONLY ...

  • Auto Page RF-350 - page 2

    2 WIR ING DIAGRAM ...

  • Auto Page RF-350 - page 3

    3 (RELAY REQUIRED) 8. GRAY ...2ND CHANNEL OUTPUT 2. WHITE ...DOME LIGHT / 3RD CHANNEL OUTPUT 7. ORANGE ...STARTER INTERUPT OUTPUT (RELAY REQUIRED) 5. GREEN ...NEGATIVE DOOR TRIGGER (-) INPUT 6. YELLOW ...IGNITION INPUT 3. VIOLET ...POSITIVE DOOR TRIGGER (+) INPUT 1. BROWN/WHITE ...(-) HORN OUTPUT 4. BLUE ...NEGATIVE INSTANT (-) INPUT H1: MAIN 5 PIN ...

  • Auto Page RF-350 - page 4

    4 VACUUM OPERATED CENTRAL LOCKING Green Wire Blue Wire +12V X Cut Compressor Door Switch 30 86 87a 85 87 30 86 87a 85 87 3 Pin Plug To Alarm VACUUM OPERATED DOOR LOCKING SYSTEM: TYPICAL OF MERCEDES BENZ AND AUDI. Locate the wire under the driver's kick panel. Use the voltmeter connecting to ground, verify that you have the correct wire with th ...

  • Auto Page RF-350 - page 5

    5 2 STEP DOOR UNLOCK WIRE CONNECTION FOR POSITIVE SWITCHED DOOR LOCKS Cut Existing Unlock X Lock Unlock OEM Door Master Lock Switch To All Other Door Lock Motors 8 - Pin Plug From Alarm H2/ 8 Gray Wire OEM Driver's Door Lock Motor + 12V Existing Pos. Lock Wire Existing Pos. Unlock Wire 30 87A 87 86 85 +12V + 12V OEM Door Lock Relay 86 30 85 87 ...

  • Auto Page RF-350 - page 6

    6 Note: If more than 4 transmitters are programmed, the system will only keep the last 4 transmitters and delete the others. ALARM FEATURE “ A ” PROGRAMMING: 1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. 2. Push the Valet switch 3 times and hold in on the 3 rd push . When a long chirp is heard, release the val ...

  • Auto Page RF-350 - page 7

    7 ALARM FEATURE “ B ” PROGRAMMING: 1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. 2 Push the Valet switch 5 times and hold in on the 5 th push. When a long chirp is heard, release the valet swit ch. You are now in the Alarm feature ‘B ’ programming mode. 3 Press the transmitter button corresponding to the fe ...

  • Auto Page RF-350 - page 8

    8 ALARM FEATURE “ C ” PROGRAMMING: 1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIME S and stay in OFF position. 2. Push the Valet switch 7 times and hold on the 7 th push until Three chirps with a long chirp is heard then release the valet switch. You are now in the Alarm feature ‘C’ programming mode. 3. Press and hold the transmitter ...

  • Auto Page RF-350 - page 9

    9 O peration Manual TRANSMITTER OPERATION: Transmitter Button System Function Remark Lock Doors & Arm System Panic function Press and Hold for 3 seconds Car Locator Under armed mode - Arm and Delete The 2 Stage Shock Sensor Press twice wit hin 3 seconds + Silent Arming / Disarming Ignition in "off" position. Unlock Doors & Disarm ...

  • Auto Page RF-350 - page 10

    10 / hood / trunk, the security system LED will stop flashing. It will b egin flashing again once all vehicle entrances are closed. 2. After 30 - second timer has elapsed, the security system will automatically “ARM”. The siren will chirp [1] time and the parking lights will flash [1] time. PASSIVE DOOR LOCKING: The vehicle doors will automatic ...

  • Auto Page RF-350 - page 11

    11 ANTI CAR - JACKING: ( OPTIONAL) If alarm option is installed. Warning: If you don't need the carjacking function in this alarm system, be sure to set carjacking feature “OFF”. This system is default setting Car - jacking “OFF”. 1. TRANSMITTER ACTIVATE THE CAR JACKING: Press and hold + button on the transmitter for 1 second while the ...

  • Auto Page RF-350 - page 12

    12 TRUNK RELEASE. Press and hold button on transmitter for two seconds to remote control the trunk release or other electric device s. CAR LOCATOR Press the button on the transmitter to active car locator function. The siren will chirp 6 times. The parking light will flash 12 times, allowing you to easily locate your car. P. PATHWAY ILLUMINAT ION W ...

  • Auto Page RF-350 - page 13

    13 CHANGING THE BATTERY IN YOUR TRANSMITTERS XT - 33: The XT - 33 transmitter uses two (2) 3 - volt lithium ion batteries (#CR2016) that are sandwiched together wit h the (+) side facing upward. To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the transmitter case next to ...

  • Auto Page RF-350 - page 14

    14 LIMITED LIFETIME WARRANTY PROVISIONS ( U.S. ,Continental U.S. and Canada Only) 1. Auto Page, Inc. WARRANTS that this new unit has been thoroughly inspected and tested at the factory prior to delivery. Your Auto Page equipment is guaranteed for “life” to the original purchaser/user of the equipment and the original vehicle in which it was ins ...

  • Auto Page RF-350 - page 15

    15 You must register your product online at http://www.autopageu sa.com to receive any warranty service. Please go to the customer service tab and select product registration. It is the purchaser’s responsibility to register this product for any future warranty service. Warning: Some batteries may contain Perchlorate What is Perchlorate? Perchlor ...

  • Auto Page RF-350 - page 16

    16 960 Knox Stre et Unit B, Torrance, CA 90502 Tel: (310) 323 - 1800 or (800) 262 - 2527 www.autopageusa.com Technical Support: 800 - 945 - 2527 (For Authorized Dealers Only) ...

Fabbricante Auto Page Categoria Automobile Alarm

I documenti che otteniamo dal fabbricante del dispositivoAuto Page RF-350 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Auto Page
- manuali per l’uso RF-350
- schede prodotto Auto Page
- opuscoli
- o etichette energetiche Auto Page RF-350
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Auto Page RF-350.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Auto Page RF-350, manuali di manutenzione, brevi manuali o manuali utente Auto Page RF-350. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Auto Page RF-350.

Manuale completo del dispositivo Auto Page RF-350, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Auto Page RF-350 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Auto Page RF-350.

Il manuale per l’uso completo Auto Page, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Auto Page RF-350 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Auto Page RF-350, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Auto Page RF-350 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Auto Page RF-350 - che ci dovrebbe aiutare nei primi passi durante l'uso Auto Page RF-350
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Auto Page RF-350
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Auto Page RF-350 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Auto Page RF-350?

Utilizza il modulo sottostante

Se non hai risolto il problema con Auto Page RF-350 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Auto Page RF-350 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (1)

Roland Baumgartner

Sehr geehrte Damen und Herren, Bei meinen ausdrucken von meinem Gerät: aficio sp c 220n bekomme ich immer feine Farb-Streifen bei jedem Ausdruck. An den Tonern liegt es nicht! Diese habe ich alle bereits gewechselt. Welches Modul ist dafür verantwortlich? Herzlichen Dank schon mal für Ihr Bemühen und Ihre Hilfe mfg Roland Baumgartner