-
Nady Systems U-1000 - page 1
U U - - 1 1 0 0 0 0 0 0 S S e e r r i i e e s s 1000 Channel PLL Frequency Synthesized UHF Wireless Micr ophone and Instrument System Owners Manual nady .com ...
-
Nady Systems U-1000 - page 2
T ABLE OF CONTENTS INTRODUCTION ................................................................................................2 SYSTEM FEA TURES ..........................................................................................3 OPERA TING INSTRUCTIONS ..........................................................................4 U-1000, U-2 ...
-
Nady Systems U-1000 - page 3
SYSTEM FEA TURES U-1000 RECEIVER (Single Channel) and U-2000 RECEIVER (Dual Channel) • Unsurpassed UHF performance with 120 dB dynamic range and operation up to 500 feet line-of-sight • Rugged 19” 1U rackmountable UHF-1000/2000 receiver with dual removable antennas (for convenient front panel placement), 1000 user switchable UHF frequencies a ...
-
Nady Systems U-1000 - page 4
SPECIFICA TIONS 21 Input Impedance ........................................UH-1000: 10 K Ohms UB-1000: 500 K Ohm (Instr .), 10 K Ohms (Lav), 20 K Ohms (HM) Controls ......................................................UH-1000: On/Of f switch, Mute, Set, and UP or DOWN buttons UB-1000: On/Off switch, Mute, Set, and UP or DOWN buttons, 3-Pin Mini XL ...
-
Nady Systems U-1000 - page 5
20 SPECIFICA TIONS SYSTEM SPECIFICA TIONS Operating Frequency Range ....................1000 channels switchable Freq. Synthesized ......................................PLL system with frequency stability <0.005% Frequency Response ................................30 HZ-15 KHZ ± 3 dB Dynamic Range ..........................................120 dB ...
-
Nady Systems U-1000 - page 6
19 TIPS • For operation with external antenna, low loss RF shielded cable should be used and the length of the cable should not exceed 3m. • Do not place the receive antenna within 1 meter of another receiver or antenna. • The receiver antenna should be kept away from any metal surface. • If the V olume Control of the receiver is set too hi ...
-
Nady Systems U-1000 - page 7
18 SYSTEM OPERA TION (Note: The UH transmitter CAP (7) must be removed before installing the USB cable.) (Note: Only one transmitter can be used with one UHF-1000 receiver . It is not possible to use two transmitters on the same frequency and mix the output of these transmitters into one wireless receiver . If you have any questions, please contact ...
-
Nady Systems U-1000 - page 8
Connecting Audio Output There are two audio outputs on the back of the receiver . Mic-level balanced and Line-level unbalanced. Use shielded audio cable for the connection between the receiver and the mixer . If the mixer / amp is a 1/4” phone jack, connect a cable from the 1/4” unbalanced audio output from the receiver . The 1/4” output can ...
-
Nady Systems U-1000 - page 9
16 SYSTEM OPERA TION Level adjustment UB-1000 T ransmitter The input level has four choices. “1” is the lowest gain, and “4” is the highest. For instrument, lavalier mic, and HM-1 headset mic use the normal setting of “3”. For HM-1 use setting “1”. When ready to speak, move the audio MUTE switch to the OFF position. Adjust the volum ...
-
Nady Systems U-1000 - page 10
15 SYSTEM OPERA TION Frequency Selection The transmitter and receiver must be on the same frequency to operate correctly . Use the Channel frequency , or Group and Channel menus described in the Receiver and T ransmitter setup instructions. Instrument Connection Using the UB-1000 transmitter in the “instrument” setting Insert an audio cord with ...
-
Nady Systems U-1000 - page 11
14 OPERA TING INSTRUCTIONS UB-1000 Bodypack T ransmitter 6. Sensitivity Set Level (Input level sensitivity) In input level sensitivity has four choices. “1” is lowest gain, and “4” is highest gain. In the Sens Set Level Menu, hold the SET (10) button for 3 seconds. The curser will blink; press the UP (1 1) or DOWN (12) buttons to select 1 o ...
-
Nady Systems U-1000 - page 12
13 OPERA TING INSTRUCTIONS UB-1000 Bodypack T ransmitter 2. “NADY UB-100” (can not be edited) 3. User Name The User Name field has 8 character spaces. Choose from upper and lower case alphabet, 27 special characters (including space), and 10 numbers. In the User Name Menu, hold the SET (10) button for 3 seconds. The curser will blink, press the ...
Nady Systems U-1000についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもNady Systems U-1000の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがNady Systems U-1000で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。