-
Kenwood KDC-101 - page 1
B64-5057-10/01 (EW) © 2012 JVC KENWOOD Corporation KDC-201 KDC-101 CD-RECEIVER INSTRUCTION MANUAL CD-RECEIVER BEDIENUNGSANLEITUNG CD-PECИBEP ИHCTPУKЦИЯ ПO ЭKCПЛУA T AЦИИ CD-РЕСІВЕР ІНСТРУКЦІЯ З ЕКСПЛУ А Т АЦІЇ Изделие изготовлено в Mалайзии B64-5057-10_01_KDC201_E_En.indd 1 12/1 ...
-
Kenwood KDC-101 - page 2
i Declaration of Conformity with regard to the EMC Directive 2004/108/EC Manufacturer: JVC KENWOOD Corporation 3-12,Moriya-cho,Kanagawa-ku,Yokohama-shi,Kanagawa,221-0022,Japan EU Representative’s: KenwoodElectronicsEuropeBV Amsterdamseweg37,1422ACUITHOORN,TheNetherlands Konformitätserklärung in Bezug ...
-
Kenwood KDC-101 - page 3
ii The marking of products using lasers Thelabelisattachedtothechassis/caseandsaysthatthecomponentuseslaser beamsthathavebeenclassifiedasClass1.Itmeansthattheunitisutilizinglaser beamsthatareofaweakerclass.Thereisnodangerofh ...
-
Kenwood KDC-101 - page 4
2 CONTENTS BEFORE USE Warning Do not operate any function that takes your attention away from safe driving. Caution Volume setting: • Adjustthevolumesothatyoucanhearsoundsoutsidethecartopreventaccident. • Lowerthevolumebeforeplayingdigitalsourcestoavoiddamagingthes ...
-
Kenwood KDC-101 - page 5
3 KDC - 201 KDC - 101 BASICS To Do this (on the faceplate) Turn on the power Pressandhold SRC . • Pressandholdtoturnoffthepower. Adjust the volume Turnthevolumeknob. Select a source Press SRC repeatedly. Change the display information Press DISP repeatedly. • Pressandholdtoscr ...
-
Kenwood KDC-101 - page 6
4 GETTING STARTED Set the clock 1 Press the volume knob to enter [FUNCTION] . 2 Turn the volume knob to select [SETTINGS] , then press the knob. 3 Turn the volume knob to select [CLOCK] , then press the knob. 4 Press the volume knob to select [CLOCK ADJ] . 5 Turn the volume knob to adjust the hour, then press the knob. 6 Turn the volume knob to adj ...
-
Kenwood KDC-101 - page 7
5 ENGLISH | RADIO Search for a station 1 Press SRC to select TUNER. 2 Press repeatedly to select FM1, FM2, FM3, MW/ LW. 3 Press 4 / ¢ to search for a station. • To store a station: Press and hold one of the number buttons ( 1 to 6 ). • To select a stored station: Press one of the number buttons ( 1 to 6 ). Other settings 1 Press the volu ...
-
Kenwood KDC-101 - page 8
6 CD / USB / iPod Start playback CD ThesourcechangestoCDandplayback starts. USB ThesourcechangestoUSBandplayback starts. iPod/iPhone ( KDC - 201 only) ThesourcechangestoiPodandplayback starts. Press and hold iPod to select the control mode while in iPod source. MODE ON: Fromthe ...
-
Kenwood KDC-101 - page 9
7 ENGLISH | Select a song by name ( KDC - 201 only) WhilelisteningtoiPod... 1 Press . 2 Turn the volume knob to select a category, then press the knob. 3 Press again. 4 Turn the volume knob to select the character to be searched for. 5 Press 4 / ¢ to move to the entry position. Youcanenteruptothreecharacters. 6 Press ...
-
Kenwood KDC-101 - page 10
8 AUDIO SETTINGS Whilelisteningtoanysource... 1 Press the volume knob to enter [FUNCTION] . 2 Turn the volume knob to select [AUDIO CTRL] , then press the knob. 3 Turn the volume knob to make a selection (see the table below), then press the knob. Repeatstep 3 untilthedesireditemisselectedoractivate ...
-
Kenwood KDC-101 - page 11
9 ENGLISH | DISPLAY SETTINGS 1 Press the volume knob to enter [FUNCTION] . 2 Turn the volume knob to select [SETTINGS] , then press the knob. 3 Turn the volume knob to make a selection (see the table below), then press the knob. Repeatstep 3 untilthedesireditemisselectedoractivated. 4 Press and hold to exit. • ...
-
Kenwood KDC-101 - page 12
10 TROUBLESHOOTING Symptom Remedy Sound cannot be heard. • Adjustthevolumetotheoptimumlevel. • Checkthecordsandconnections. “PROTECT” appears and no operations can be done. Check to be sure the terminals of the speaker wires are insulated properly, then reset the unit. If this does not solve the problem, ...
-
Kenwood KDC-101 - page 13
11 ENGLISH | SPECIFICATIONS Tuner FM FrequencyRange 87.5 MHz to 108 MHz (50 kHz space) UsableSensitivity(S/N=26dB) 7.2 dBf (0.63 μV/75 Ω) QuietingSensitivity (DINS/N=46dB) 15.2 dBf (1.6 μV/75 Ω) FrequencyResponse(±3dB) 30 Hz to 15 kHz Signal‑to‑NoiseRatio(MONO) 75 dB StereoSeparation(1? ...
-
Kenwood KDC-101 - page 14
12 INSTALLATION / CONNECTION Do the required wiring. ( ➜ 13) Dashboard of your car Bend the appropriate tabs to hold the mounting sleeve firmly in place. How to remove the unit 1 Detach the faceplate. 2 Fit the catch pin on the extraction keys into the holes on both sides of the trim plate, then pull it out. 3 Insert the extraction keys deeply in ...
-
Kenwood KDC-101 - page 15
13 ENGLISH | REMOTE CONT STEERING WHEEL REMOTE INPUT MUTE P . CONT ANT CONT R L REAR/SW Wiring connection Part list for installation Fuse (10 A) Antenna terminal (JASO) ( ×4 ) ( ×4 ) ( ×2 ) ( ×1 ) ( ×1 ) ( ×1 ) ( ×1 ) A Faceplate B Mounting sleeve C Trim plate D Wiring harness E Extraction key Light blue/yellow (Steering remote control wire) ...
Kenwood KDC-101についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもKenwood KDC-101の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがKenwood KDC-101で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。