Lanzar Lanzar Vibe VBD300の取扱説明書

12ページ 0.1 mb
ダウンロード

ページに移動 of 12

Summary
  • Lanzar Lanzar Vibe VBD300 - page 1

    OWNER’S MANUAL VBD 300 PLL SYNTHESIZER STEREO RADIO WITH COMP ACT DISC PLA YER DIGIT AL ...

  • Lanzar Lanzar Vibe VBD300 - page 2

    2 INST ALLA TION Notes: • Choose the mounting location where the unit will not interfer e with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sur e it is all connected up properly and the unit and the system work pr operly . • Use only the parts included with the unit ...

  • Lanzar Lanzar Vibe VBD300 - page 3

    1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Scr ew (5 x 25mm) 5. Screw 6. Strap Be sure to use the strap to secur e the back of the unit in place. The strap can be bent by hand to the desired angle. 7. Plain washer Removing the unit 1. Frame 2. Insert fingers into the gr oove in the fr ont of frame and pull out to remove the frame. (When reattach ...

  • Lanzar Lanzar Vibe VBD300 - page 4

    4 HOW TO REMOVE AND INST ALL THE FRONT P ANEL (OPTIONAL) 1. Pr ess the r elease button and pull-off the fr ont panel. Keep front panel into the case. 2. T o install the front panel, insert the panel into the housing and make sur e the panel is properly installed, otherwise, abnormalities occurs on the display or some keys will not function properly ...

  • Lanzar Lanzar Vibe VBD300 - page 5

    ANTENNA CONNECT OR MEMORY BACK-UP FRONT Lch SPEAKER MAIN UNIT FRONT Rch SPEAKER IGNITION SWITCH (B+) POWER ANTENNA REAR Lch SPEAKER REAR Rch SPEAKER GROUND (B–) RED YELLOW BLACK CHOKE BOX BLUE + – + – + – + – Rch RED Lch WHITE (FOR RCA LINE OUT VERSION ONL Y) FRONT RCA CABLE REAR RCA CABLE (BROWN) (GREY) WHITE WHITE/BLACK GREEN GREEN/BLAC ...

  • Lanzar Lanzar Vibe VBD300 - page 6

    6 LOCA TION AND FUNCTION OF CONTROLS (1) ON/OFF Press POWER button (1) to turn on. Press it again to turn it off. If the power is off, press BND button (11) or MOD button (12) also can turn on the unit. (2) DISC PLA Y Gently insert a compact disc with the label side facing up into the disc slot (2). The disc is then automatically loaded into the un ...

  • Lanzar Lanzar Vibe VBD300 - page 7

    7 FM1 FM2 FM3 AM1/MW AM2/L W BAS TRE BAL F AD VOL (Bass) (T r eble) (Balance) (Fader) (Volume) (4) MONO/STEREO (FOR MON VERSION ONL Y) Press MON button (4) to select monaural or ster eo (Mono reception for radio stations). Y ou can sometimes improve r eception of distant stations by selecting mono operation. (4) SUB-WOOFER (FOR SUB.W . VERSION ONL ...

  • Lanzar Lanzar Vibe VBD300 - page 8

    (13) LIQUID CR YST AL DISPLA Y The LCD (13) can show the current state of the unit. (14 & 15) SELECT ST A TIONS Press and r elease a TUNE/SEEK/TRACK button /– (14) or +/ (15) immediately to move radio frequency number up or down on step. Press and hold a TUNE/SEEK/TRACK button /– (14) or +/ (15) for several seconds to seek the next clear st ...

  • Lanzar Lanzar Vibe VBD300 - page 9

    9 (23) AUTOMA TICALL Y STORING & PROGRAM SCANNING Automatically Storing Press and hold AMS button (23) for several seconds to toggle automatically storing function. It starts searching next fr equency in local mode and stores the clear station into the preset memory . If 6 ch. is not fully memorised, it would start the second searching in dista ...

  • Lanzar Lanzar Vibe VBD300 - page 10

    10 Remote Control Handset 8 6 2 1 3 4 5 7 14 9 13 11 12 15 10 Contr ol & Function Keys 1. POWER = Power ON/OFF Button 2. MOD = Mode Button 3. SEL = Select Button 4. EQ = Equalization Button 5. BND = Band Select Button 6. MUTE = Mute Button 7. VOL + = V olume Up Button 8. VOL – = V olume Down Button 9. TUN/SEK = T une/Seek Up Button 10. TUN/SE ...

  • Lanzar Lanzar Vibe VBD300 - page 11

    11 SPECIFICA TION GENERAL Po w er Supply Requirements : DC 12 V olts, Negative Ground Chassis Dimensions : 178 (W) x 155 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) : +10 dB / –10 dB -T r eble (at 10 KHz) : +10 dB / –10 dB Maximum Output P ow er - Version v : 7W x 4 (ch) or 25W x 2 (ch) - Version z : 25W x 4 (ch) - Version y : 40W x 4 (ch) CD ...

  • Lanzar Lanzar Vibe VBD300 - page 12

    TROUBLE SHOOTING Before going thr ough the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer . Symptom Cause Solution No power . The car ignition is not on. If the power supply is properly connected to the car accessory terminal, switch the ignition key to “ACC? ...

メーカー Lanzar カテゴリー Car Stereo System

Lanzar Lanzar Vibe VBD300のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- Vibe VBD300の取扱説明書
- Lanzarの製品カード
- パンフレット
- またはLanzar Lanzar Vibe VBD300の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Lanzar Lanzar Vibe VBD300の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Lanzar Lanzar Vibe VBD300の取り付け説明書、サービスマニュアル、簡易説明書、またはLanzar Lanzar Vibe VBD300のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Lanzar Lanzar Vibe VBD300の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Lanzar Lanzar Vibe VBD300デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがLanzar Lanzar Vibe VBD300を使用するのを助ける技術的文書のことです。説明書は通常、全てのLanzar Lanzar Vibe VBD300ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Lanzarの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Lanzar Lanzar Vibe VBD300の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははLanzar Lanzar Vibe VBD300の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Lanzar Lanzar Vibe VBD300に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Lanzar Lanzar Vibe VBD300デバイスの基本機能を使うにあたってのヒント。 Lanzar Lanzar Vibe VBD300のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Lanzar Lanzar Vibe VBD300に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるLanzar Lanzar Vibe VBD300のメーカー/サービスへの連絡先に関する情報。

Lanzar Lanzar Vibe VBD300についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもLanzar Lanzar Vibe VBD300の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがLanzar Lanzar Vibe VBD300で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)