-
HP (Hewlett-Packard) EAZ0012L02A - page 1
EAZ0012L02A (01/16/2008) REV A. INSTALLATION OVERVIEW: ______________________________________________ These instructions are for the installation of an Off- the-Shelf Oki B4 400 printer for all OBIS Analyzers, SIS Machine Bar 97 Analyzers, Sun Machi nes and MCS-2500 for Pep Boy units. Wh en installing this new printer a Utility Disk, will be needed ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 2
Page 2 of 16 EAZ0012L02A (01/16/2008) REV A. REQUIRED TOOLS: _____________________________________________________ • Complete Tool Kit INSTALLATION INSTRUCTIONS: __________________________________________ See Table below for analyzer installation instructions: All OBIS Analyzers Installing Oki B4400 Printer on OBIS Page 3 SIS Machine (Win 95 or W ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 3
Page 3 of 16 EAZ0012L02A (01/16/2008) REV A. INSTALLING OKI B4400 PRINTER on OBIS: _________________________________ Removing old Printer Icons 1. Leave old or defective Printer Installed and turned on durin g this next part. 2. Turn computer on, and log in as PC . Do not enter in a password. 3. Select Start ⇒ Settings ⇒ Printers . Right click ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 4
Page 4 of 16 EAZ0012L02A (01/16/2008) REV A. 14. Follow the on-screen instructions until the driv ers and Status monito r software is completely loaded. 15. After the software has been loaded, the screen will pr ompt you to connect the new printer with the power off. (Don’t forget to connect the USB cable to the printer). 16. Next turn On the Pri ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 5
Page 5 of 16 EAZ0012L02A (01/16/2008) REV A. OKI B4400 PRINTER on SIS ANALYZERS with WIN 9X OS (Ontario GAS & HD; Virginia SIS): __________________________________________________________ NOTE: A SEPARATE SHEET METAL DRAWER KIT (EAK0226L00A) MAY BE REQUIRED , WHEN REPLACING AN EXISTING O KIDATA 6E, 10E OR 14E PRINTER WITH A N O KI B4400 PRINTER ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 6
Page 6 of 16 EAZ0012L02A (01/16/2008) REV A. OKI B4400 Printer on SIS (BAR 97) ; DOS 6.22 for NJ; PA; TX, NC, CA (BAR 97 ONLY): _______________________________________________________________ NOTE: A SEPARATE SHEET METAL DRAWER KIT (EAK0226L00A) IS REQUIRED , WHEN REPLACING AN EXISTING HP D ESK J ET ; OKI 6E; OKI 10E OR OKI 14E PRINTE R WITH AN O K ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 7
Page 7 of 16 EAZ0012L02A (01/16/2008) REV A. OKI B4400 PRINTER on SIS with SUN MACHINE Version 3.3; 5.0 w ith WIN 9X OS: 1. Leave old or defective printer connected at this time. 2. Power up the Analyzer using the rea r panel "Main Power" Switch. 3. Once the Emissions Software has loade d select, "PC OPTION" and press <Y > ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 8
Page 8 of 16 EAZ0012L02A (01/16/2008) REV A. 24. From the desktop, select Star t ⇒ Programs ⇒ MS DOS Prompt . 25. At the DOS prompt type $?6QDSRQ and press <ENTER> . 26. A message indicating 1 file copied should be displa yed, if not you are not in the correct drive or the floppy disk is bad, verify the problem and retry running the Sn ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 9
Page 9 of 16 EAZ0012L02A (01/16/2008) REV A. OKI B4400 PRINTER on SIS with SUN MA CHINE Version 3.3 w ith DOS OS: NOTE: M AKE SURE O KI B4400 PRINTER IS INSTALLED , AND THE AC POWER CORD AND THE E XISTING DATA CABLE ARE CONNECTED TO THE O KI B4400 PRINTER . E NSURE THE P RINTER IS TURNED ON (1) POSITION . 1. Power up the Analyzer using the rea r pa ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 10
Page 10 of 16 EAZ0012L02A (01/16/2008) REV A. OKI B4400 PRINTER on MCS 2500 Pep Boys: _______________________________ NOTE: A SEPARATE SHEET METAL DRAWER KIT (EAK0226L10A) IS REQUIRED , WHEN REPLACING AN EXISTING OKI 6E; OKI 10E OR OKI 14E PRINTER WITH AN O KI B4400 PRINTER . O RDER AND INSTALL THIS KIT FIRST , BEFORE CONTINUING . T HIS KIT IS N OT ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 11
Page 11 of 16 EAZ0012L02A (01/16/2008) REV A. OKI B4400 PRINTER on SUN MACHINE ANALYZERS with WIN 9X: _____________ NOTE: A separate sheet metal dra wer kit (EAK0226L10A) is required, when replacing an existing HP DeskJet; OK I 6E; OKI 10E or OKI 14E PRINTER with AN Oki B4400 printer. Order and install this kit first, before continuing. T HIS KIT I ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 12
Page 12 of 16 EAZ0012L02A (01/16/2008) REV A. 29. From the A: prompt type “ Snapon” and press <ENTER> . 30. A message indicating 1 file copied should be displa yed, if not you are not in the correct drive or the floppy disk is bad, verify the problem and retry running the snapon batch file. 31. Exit the DOS window by typing H[LW at the DO ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 13
Page 13 of 16 EAZ0012L02A (01/16/2008) REV A. OKI B4400 PRINTER SUN MACHINE A NALYZERS with DOS 6.22: ______________ NOTE: A separate sheet metal dra wer kit (EAK0226L10A) is required, when replacing an existing HP DeskJet; OK I 6E; OKI 10E or OKI 14E PRINTER with AN Oki B4400 printer. Order and install this kit first, before continuing. T HIS KIT ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 14
Page 14 of 16 EAZ0012L02A (01/16/2008) REV A. OKI B4400 PRINTER INSTALLATION VERIFICATION: _________________________ • Printer Power LED is on, no blinking or red LED’s should be seen • Upon Power up the printer should initialize • Test Page should be printed with no errors. • Perform Print Screen Test after installation is complete to ve ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 15
Page 15 of 16 EAZ0012L02A (01/16/2008) REV A. PRINTER INSTALLATION TROUBLESHOOTING: _____________________________ Fault Resolution No Printer Power LED On Check AC Cord Connectio n from the Source to the Printer Printer does not print (No Error LEDS) Check data printer cabl e or USB connection from the computer to the printer. Unplug and plug it ba ...
-
HP (Hewlett-Packard) EAZ0012L02A - page 16
Page 16 of 16 EAZ0012L02A (01/16/2008) REV A. Fault Resolution Fuzzy print. Dirty LED array. Clean LED array. The LED array is on the underside of the printer cover. Wipe it gently with the cleaning pad that is incl uded in the toner cartridge kit. You can also use a clean, soft cloth with a small amount of rubbing alcohol on it Printer does not pr ...
HP (Hewlett-Packard) EAZ0012L02Aについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもHP (Hewlett-Packard) EAZ0012L02Aの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがHP (Hewlett-Packard) EAZ0012L02Aで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。