Smeg CIR60XSの取扱説明書

24ページ 1.3 mb
ダウンロード

ページに移動 of 24

Summary
  • Smeg CIR60XS - page 1

    Index 1. INSTRUCTIONS FOR SAFE AND PROPER USE ________________ 4 2. POSITIONING OF HOB ____________________________________ 6 3. GAS CONNECTION ______________________________________ 11 4. ELECTRICAL CONNECTION ______________________________ 12 5. GAS CONNECTION ______________________________________ 13 6. ADAPTATION TO DIFFERENT TYPES OF GAS _____ ...

  • Smeg CIR60XS - page 2

    Introduction 1. INSTRUCTIONS FOR SAFE AND PR OPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKING HOB. ALSO KEEP TH E SERIES OF NOZZLES SUPP ...

  • Smeg CIR60XS - page 3

    Introduction THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER TH E CASING. THE PLATE ON THE CASING MUST NOT BE R EMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT HAS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDER THE CASING. DO NOT PUT PANS WITHOUT PERFECTLY SMO ...

  • Smeg CIR60XS - page 4

    Instructions for the installer 6 2. POSITIONING OF HOB It is the law that all gas appliances are installed by authorised persons . Clearance around the appl iance must comply with the requirements of AS5601. The following operation r equires building and/or carpentry work so must be carried out by a competent tradesman. Installation c an be carried ...

  • Smeg CIR60XS - page 5

    Instructions for the installer 7 In case of installation on a hollo w compartment with doors, a separating panel has to be placed under the hob. Keep a minimum distance of 10 mm between the bottom of the uni t and the panel surface. The panel has to be easily removable to allow a ccess in the event of te chnical service. Overall dimensions: locatio ...

  • Smeg CIR60XS - page 6

    Instructions for the installer 8 2.2 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances – (Measureme nt A ) Range hoods and exha ust fans shall be installed in accor dance with the manufacturer’s instructions. Howev er, in no case shall the clearance between the highest part of the hob of the c ...

  • Smeg CIR60XS - page 7

    Instructions for the installer 9 be protected in accorda nce with Clause 5.12.1.2 to a height C of not less than 150 mm above the hob for th e full dimension (width or depth) of the cooking surfac e area. Where the cooking applian ce is fitted with a ‘splashback’, protection of the re ar wall is not required. 3 Additional requirements for Frees ...

  • Smeg CIR60XS - page 8

    Instructions for the installer 10 2.3 Room ventilation Caution – This hob may o nly be installed and operated in rooms permanently ventilated in accordance with current regulations. For proper operation of a gas a ppliance it is essential for the air nec essary for combustion of the gas to be able to flow naturally into t he room. Air must flow d ...

  • Smeg CIR60XS - page 9

    Instructions for the installer 11 3. GAS CONNECTION This appliance is suita ble for installation with Natural Gas or ULPG (propane). Refer to page 12 for the relevant burner press ure and appropriate injector sizes. When th e appliance is to be connected to Natura l Gas then the pressure regulator supplied m ust be fitted to the gas inlet. A test p ...

  • Smeg CIR60XS - page 10

    Instructions for the installer 12 4. ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on the plate locat ed under the casing. Do not remove this plate for any reason. The plug on the end of the supply cable and the wall socket must be the same type and conform to the curr ent electrical syste ...

  • Smeg CIR60XS - page 11

    Instructions for the installer 13 5. GAS CONNECTION Connection to the gas mains may be made with a rigid copper pipe or with a flexible pipe and conforming to the prov isions defi ned by standard regulations in force. To facilitate connection, fitting A on the r ear of the appliance may be adjusted laterally. For th is purpose, loosen hexagon nut B ...

  • Smeg CIR60XS - page 12

    Instructions for the installer 14 5.1 Connection to LPG Use a pressure regul ator and make the connection to the tank according to the provisions of standar d s regulations in force. Make sure that feed pressure conforms to the lev els shown in the table in paragraph “ 6.2 Regulation for LPG ”. 5.2 Ventilation of rooms The hob may be installed ...

  • Smeg CIR60XS - page 13

    Instructions for the installer 15 6. AD APT A TION T O DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The hob has been inspected for NG natural gas at a pressure of 1.0 kPa. For functioning with other types of gas the nozzles must be r eplaced and the primary air adjusted. ...

  • Smeg CIR60XS - page 14

    Instructions for the installer 16 6.2 Regulation for LPG Loosen screw A and push supp ort B all the way. Use a double head wrench to remove nozzle C and assemble the suitable one, followin g the instructions indicated in the reference charts, with respect to the type of gas to use. The screwing torque of the nozzle should nev er exceed 3 Nm . Repos ...

  • Smeg CIR60XS - page 15

    Instructions for the installer 17 6.3 Regulation for natural gas The hob has been adjusted for natural gas at a pressure o f 1.0kPa. To allow the unit to work back with this ty pe of gas, after it has been adjusted for LPG, perform t he same operations described in paragraph “ 6.2 Regulation for LPG ”, but refer to the following table for the p ...

  • Smeg CIR60XS - page 16

    Instructions for the installer 18 7.3 Arrangement of burners on hob BURNERS 1 Auxiliary 2 Semi-rapid 3 Rapid 4 Rapid 5 WOK 7.4 Lubrification of gas taps After a while, the gas tap may become hard to turn or lock. If this happens, it has to be cleaned inside and re-gr eased. This must be done by a qualified techn ician. ...

  • Smeg CIR60XS - page 17

    Instructions for the user 19 8. USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted correctly. In the ultrarapid burner, notch A must be aligned with pin B . Grid C provided is intended for use with woks (Chinese pan s). Adapter D comes only with open grids models and is int ended for use wi ...

  • Smeg CIR60XS - page 18

    Instructions for the user 20 8.2 Practical advice for usin g the burners For better burner performance an d minimum gas consumption, flat bottomed, even recipie nts must be used, with covers and proportiona l in size to the burners (see paragraph “ 8.3 Diameter of containers ”). To avoid overcooking or damage to the surface top w hile cooking, ...

  • Smeg CIR60XS - page 19

    Instructions for the user 21 8.4.2 Using the electric elements The electric elements are ideal for ultrarapid cooking. The settings shown in the table are merely indicativ e. POSITION HEAT INTENSITY POSSIBLE COOKING - 0 Off To melt butter, chocolate, etc. 1 Weak To heat small amounts of liquid. 2 Soft To heat larger amounts of liquid. To defrost fr ...

  • Smeg CIR60XS - page 20

    Instructions for the user 22 9. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 9.1 Cleaning Clean the cooking top regularly every time you use it, obviously after it has cooled. NEVER USE A STEAM JET TO CLEAN THE APPLIANCE. 9.1.1 Regular daily cleaning of the hob In order to clean and preserve the su rf ...

  • Smeg CIR60XS - page 21

    Instructions for the user 23 9.2.1 Ignition plugs and safety devices For good functioning of the l ighting ignition plugs and the s afety devices, keep them very clean. Check frequently and clean with a damp clot h when necessary. 9.2.2 The cover Clean the glass or steel cover, w here mount ed, with warm water. Never use abrasive sponges or deterge ...

  • Smeg CIR60XS - page 22

    Instructions for the user 24 10. PR OBLEMS AND CA USES Each of the following cases is caused by an abnormal op eration of the appliance and shoul d be dealt with by a authorised persons: please contact your local dealer or Service Center in case you detect any of these malfunctioning. PROBLEM CAUSE WHAT TO DO The flame is very long with bright yell ...

  • Smeg CIR60XS - page 23

    ...

  • Smeg CIR60XS - page 24

    914772609/ B ...

メーカー Smeg カテゴリー Cooktop

Smeg CIR60XSのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- CIR60XSの取扱説明書
- Smegの製品カード
- パンフレット
- またはSmeg CIR60XSの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Smeg CIR60XSの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Smeg CIR60XSの取り付け説明書、サービスマニュアル、簡易説明書、またはSmeg CIR60XSのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Smeg CIR60XSの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Smeg CIR60XSデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがSmeg CIR60XSを使用するのを助ける技術的文書のことです。説明書は通常、全てのSmeg CIR60XSユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Smegの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Smeg CIR60XSの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははSmeg CIR60XSの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Smeg CIR60XSに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Smeg CIR60XSデバイスの基本機能を使うにあたってのヒント。 Smeg CIR60XSのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Smeg CIR60XSに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるSmeg CIR60XSのメーカー/サービスへの連絡先に関する情報。

Smeg CIR60XSについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもSmeg CIR60XSの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがSmeg CIR60XSで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)