TRENDnet TPL-310APの取扱説明書

21ページ 2.8 mb
ダウンロード

ページに移動 of 21

Summary
  • TRENDnet TPL-310AP - page 1

    Quick Installation Guide TPL-310AP 1 .0 1 ...

  • TRENDnet TPL-310AP - page 2

    T able of Contents V ersion 01.07.2011 English 1 1. Before Y ou Start 2. Configure the TPL-310AP 3 3. Create a powerline network 7 4. LEDs and Buttons 9 1 T roubleshooting 1 1 Wireless T ips 15 ...

  • TRENDnet TPL-310AP - page 3

    1. Before Y ou Start Ÿ Ÿ A Desktop or Laptop PC with or wireless Network Adapter Installed Ÿ Existing 10/100Mbps wired network when TPL-310AP is used to a powerline network to an existing wired network Ÿ Web Browser: Internet Explorer (6.0 or higher) ® Ÿ Additional HomePlug A V powerline adapter (e.g. TRENDnet TPL-303E, TPL-304E, TPL-305E, or ...

  • TRENDnet TPL-310AP - page 4

    The installation diagram shows a typical setup of the TPL-310AP extending your wireless network connectivity to another room when bridged with an additional powerline adapter , in this case, the TRENDnet TPL-303E. Assuming you have the TPL-310AP and one additional TRENDnet Powerline A V adapter, this guide will provide the procedure to installing a ...

  • TRENDnet TPL-310AP - page 5

    3 Note: When installing for the first time, it is required that you configure the Access Point from a wired computer . Assign a Static IP address to your computer's network adapter in the subnet of 192.168.10.x. Since the Access Point's default IP address is 192.168.10.100, make sure no other network devices are assigned an IP address of ...

  • TRENDnet TPL-310AP - page 6

    4 7. The Setup Wizard will automatically appear . Click Setup Wizard if the Setup Wizard does not automatically appear . 8. Click Next . 9. For DHCP , click on the drop down arrow and Select Client for DHCP to have the TPL-310AP automatically obtain an IP address from your DHCP server (router). If Disabled is selected for DHCP , you will need to co ...

  • TRENDnet TPL-310AP - page 7

    5 10. Y ou will need to configure the following: Band : In most cases, the default setting (2.4GHz (B+G+N) should be fine. Mode : In most cases, the default setting (AP) should be fine. Network T ype : This setting does not apply to (AP) mode. Continue to the next setting. SSID : The SSID is the wireless network name of your wireless network (e.g. ...

  • TRENDnet TPL-310AP - page 8

    6 15. After the settings are applied and the device has rebooted, disconnect the TPL-310AP from the power outlet. 1 1. Select WP A2(AES) . 12. Select Passphrase or Hex (64 characters) for Pre-Shared Key Format. 13. Enter characters for your Pre-Shared key and then click Next . For WP A-PSK or WP A2-PSK, the Pre-Shared Key must be between 8 and 63 A ...

  • TRENDnet TPL-310AP - page 9

    7 Note: 1. DO NOT install the TPL-310AP until instructed to do so. 2. DO NOT plug the TPL-310AP into a surge protector or power strip. 3. It is NOT recommended to use this product on electrical systems that use AFCI circuit breakers or plugged into GFI protected outlets as this may cause performance degradation or loss in connectivity . 4. Assuming ...

  • TRENDnet TPL-310AP - page 10

    8 4. (OPTIONAL) Connect a network cable from the TPL-310AP into the network port on your remote computer or network appliances (e.g. Game Console, IP Set box, network enabled TV , etc.). 5. V erify that the WIFI (Wireless) (Blinking/Green), ETH (Ethernet) (Green), PL (Powerline) and PWR (Power) (Solid/Green) LEDs are on for the TPL-310AP . Outlet O ...

  • TRENDnet TPL-310AP - page 11

    9 4. LEDs and Buttons WPS (Wi-Fi Protected Setup) ETH (Network Port) WIFI(Wireless) PWR (Power) PL (Powerline) ...

  • TRENDnet TPL-310AP - page 12

    10 Note: The Network Port, WPS button, Reset button and Sync button are located at the bottom of the device. *Note: The following factors may affect the powerline network's connection quality: · Noise – Generated by appliances that are connected to your electrical system through power outlets that have high power consumption requirements. ( ...

  • TRENDnet TPL-310AP - page 13

    1. How do I configure TCP/IP settings on my computer's network adapter? T roubleshooting 1 1 Windows 7 Windows Vista Windows XP/2000 1. Go into the Control Panel , click Network and Internet , click Network and Sharing Center , click Change Adapter Settings and then right-click the Local Area Connection icon and then click Properties . 1. Go i ...

  • TRENDnet TPL-310AP - page 14

    12 2. 1. other powerline devices to factory default. The default network name/key is “HomePlugA V”. The Reset button is located on the bottom of the TPL-310AP . With a pin or paperclip, press and hold the reset button for 1 second and release it. The PWR and PL LEDs will turn of f and turn back on. (Note: The PL LED will flash in amber .) T o v ...

  • TRENDnet TPL-310AP - page 15

    13 Windows Vista Windows XP/2000 1. Go into the Control Panel , click Network and Internet , click Network and Sharing Center , click Manage Network Connections and then right-click the Local Area Connection icon and then click Properties . 2. Click Internet Protocol V ersion 4(TCP/IPv4) and then click Properties. Then click on Obtain an IP address ...

  • TRENDnet TPL-310AP - page 16

    14 7. After I successfully configured the Access Point to meet my network settings, I cannot connect to my network using wireless computers. If you have a DHCP server in your network, you need to go into TCP/IP settings again and re-select "Obtain an IP address automatically" to allow the PC to regain an IP address from your DHCP server. ...

  • TRENDnet TPL-310AP - page 17

    15 Wireless T ips The following are some general wireless tips to help minimize the impact of interference within an environment. Assign your network a unique SSID Do not use anything that would be identifying like “Smith Family Network”. Choose something that you would easily identify when searching for available wireless networks. Do not turn ...

  • TRENDnet TPL-310AP - page 18

    3. Building materials can have a large impact on your wireless signal. In an indoor environment, try to position the wireless devices so that the signal passes through less dense material such as dry wall. Dense materials like metal, solid wood, glass or even furniture may block or degrade the signal. 4. Antenna orientation can also have a large im ...

  • TRENDnet TPL-310AP - page 19

    ...

  • TRENDnet TPL-310AP - page 20

    Description of Modes Erp (EuP) Operation: Standby Mode The EUT has no external mechanical switch and uses an internal program to control active and standby modes. Disconnect the Ethernet cables from the device Ethernet ports, and after 3 minutes, the device will enter standby mode. The Power (PWR) LED will flash every 15 seconds to indicate that th ...

  • TRENDnet TPL-310AP - page 21

    Copyright ©20 1 1 . All Rights Reserved. TRENDnet. ...

メーカー TRENDnet カテゴリー Network Hardware

TRENDnet TPL-310APのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- TPL-310APの取扱説明書
- TRENDnetの製品カード
- パンフレット
- またはTRENDnet TPL-310APの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、TRENDnet TPL-310APの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、TRENDnet TPL-310APの取り付け説明書、サービスマニュアル、簡易説明書、またはTRENDnet TPL-310APのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、TRENDnet TPL-310APの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

TRENDnet TPL-310APデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがTRENDnet TPL-310APを使用するのを助ける技術的文書のことです。説明書は通常、全てのTRENDnet TPL-310APユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

TRENDnetの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. TRENDnet TPL-310APの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははTRENDnet TPL-310APの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。TRENDnet TPL-310APに関してこのドキュメントで見つけることができる全てのヒントの目次
3. TRENDnet TPL-310APデバイスの基本機能を使うにあたってのヒント。 TRENDnet TPL-310APのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。TRENDnet TPL-310APに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるTRENDnet TPL-310APのメーカー/サービスへの連絡先に関する情報。

TRENDnet TPL-310APについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもTRENDnet TPL-310APの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがTRENDnet TPL-310APで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)