-
IBM P76 - page 1
3-867-449- 11 (1) Operating Instructions Mode d’emploi Bedienungsanleitung Manual de instrucciones Istruzioni per l’uso P76 Color Monitor FR GB DE ES IT ...
-
IBM P76 - page 2
...
-
IBM P76 - page 3
i Getting Started Getting Started DANGER To avoid shock hazard: • Do not remove the covers. • Do not operate this product unless the stand is attached. • Do not connect or disconnect this product during an electrical storm. • The power cord plug must be connected to a properly wired and grounded power outlet. • Any equipment to which this ...
-
IBM P76 - page 4
ii PELIGRO Para evitar riesgos de descargas eléctricas: • No retire bajo ningún concepto las cubiertas. • No maneje el monitor sin antes acoplar el soporte. • No conecte ni desconecte el equipo de una toma de alimentación durante una tormenta eléctrica. • El cable de alimentación debe estar conectado a un enchufe debidamente cableado y ...
-
IBM P76 - page 5
iii Getting Started Getting Started FARE Slik unngår du fare for elektrisk støt: • Ikke ta av dekslene. • Ikke bruk produktet dersom sokkelen ikke er montert. • Ikke koble produktet til eller fra under tordenvær. • Pluggen på strømledningen må kobles til korrekt montert og jordet strømuttak. • Utstyr som dette produktet eventuelt b ...
-
IBM P76 - page 6
iv TEHLİKE Elektrik çarpması tehlikesinden kaçınmak için: • Kapakları çıkarmayınız. • Bu cihazı kaidesine takılı durumda değilken çalıştırmayınız. • Bu cihazı elektriksel fırtına sırasında prize takmayınız veya prizden çıkarmayınız. • Elektrik kablosunun fişi, elektrik ve toprak bağlantıları usulüne uygu ...
-
IBM P76 - page 7
Getting Started Getting Started F GB ES C English ...
-
IBM P76 - page 8
Edition 1 This publication could contain technical inaccuracies or typographical errors. Changes are made periodically to the information herein; these changes will be made in later editions. IBM may make improvements and/or changes in the product(s) and/or program(s) at any time. It is possible that this publication may contain reference to, or in ...
-
IBM P76 - page 9
1 Getting Started F GB ES C T ABLE OF CONTENTS • E NERGY S TAR is a U.S. registered mark. • Trinitron ® is a registered trademark of Sony Corporation. • VGA is a registered trademark of IBM Corporation of the U.S.A. • VESA is a trademark of Video Electronics Standard Association. • All other product names mentioned herein may be the trad ...
-
IBM P76 - page 10
2 Getting Started Use of the Tilt-Swivel This monitor can be adjusted within the angles shown below. To find the center of the monitor’s turning radius, align the center of the monitor’s screen with the centering dots on the stand. Hold the monitor at the bottom with both hands when you turn it horizontally or vertically. Be careful not to pinc ...
-
IBM P76 - page 11
3 Getting Started Getting Started F GB ES C Identifying P arts and Contr ols See the pages in parentheses for further details. Front 1 ? (reset) button (page 13) Resets the adjustments to the factory settings. 2 ¨ (brightness) down and up ( . / > ) buttons (pages 5 – 13) Adjust the picture brightness. Function as the ( . / > ) buttons when ...
-
IBM P76 - page 12
4 Getting Started to a power outlet to AC IN Power cord To a computer with an HD15 video output Setup This monitor works with platforms running at horizontal frequencies between 30 and 96 kHz. Step 1: Make sure the computer and monitor are switched off Step 2: Connect the monitor to the computer Connect the video signal cable to the video output of ...
-
IBM P76 - page 13
5 Getting Started F GB ES C Customizing Your Monitor Before adjusting • Connect the monitor and the computer, and turn them on. Selecting the On-scr een Display Language If you need to change the OSD language, see “Using the LANGUAGE On-screen Display” on page 10. The default setting is English. Adjusting the Pictur e Brightness and Contrast ...
-
IBM P76 - page 14
Customizing Your Monitor 6 To adjust the horizontal centering of the picture adjust the vertical centering of the picture adjust the horizontal size of the picture adjust the vertical size of the picture enlarge and reduce the picture Using the SIZE/CENTER On- scr een Display The SIZE/CENTER settings allow you to adjust the picture’s size, center ...
-
IBM P76 - page 15
7 Getting Started F GB ES C Customizing Your Monitor Using the GEOMETR Y On- screen Display The GEOMETRY settings allow you to adjust the shape and orientation of the picture. Once the (Rotation) is adjusted, it will be stored in memory for all input signals received. All other adjustments will be stored in memory for the current input signal. 1 Pr ...
-
IBM P76 - page 16
8 Customizing Your Monitor 9300 K 5000 K C OLO R Using the COLOR On-scr een Display You can change the monitor’s color temperature. For example, you can adjust or change the colors of a picture on the screen to match the actual colors of the printed picture. Once the setting is adjusted, it will be stored in memory for all input signals received. ...
-
IBM P76 - page 17
Getting Started Customizing Your Monitor F GB ES C 9 Using the CONVERGENCE On- screen Display The CONVERGENCE settings allow you to adjust the quality of the picture by controlling the convergence. The convergence refers to the alignment of the red, green, and blue color signals. If you see red or blue shadows around letters or lines, adjust the co ...
-
IBM P76 - page 18
10 Customizing Your Monitor Using the LANGU AGE On- scr een Display English, French, German, Spanish, Italian, Dutch, Swedish, Russian and Japanese versions of the OSDs are available. 1 Press the button. The MENU OSD appears. 2 Press the . / > buttons to select “ LANGUAGE,” and press the button again. The LANGUAGE OSD appears. 3 Press the . ...
-
IBM P76 - page 19
11 Getting Started F GB ES C Customizing Your Monitor Changing the on-screen display position You can change the OSD position (for example, when you want to adjust the picture behind the OSD). 1 Press the button. The MENU OSD appears. 2 Press the . / > buttons to select “ OPTION,” and press the button again. The OPTION OSD appears. 3 Press t ...
-
IBM P76 - page 20
12 Customizing Your Monitor Locking the controls You can protect adjustment data by locking the controls. 1 Press the button. The MENU OSD appears. 2 Press the . / > buttons to select “ OPTION,” and press the button again. The OPTION OSD appears. 3 Press the . / > buttons to select “ (CONTROL LOCK).” 4 Press the / button to select “ ...
-
IBM P76 - page 21
13 Getting Started F GB ES C Customizing Your Monitor Resetting the Adjustments Resetting an adjustment item 1 Press the , . / > buttons to select the OSD containing the item you want to reset. 2 Press the . / > buttons to select the item you want to reset. 3 Press the ? (reset) button. Resetting all of the adjustment data for the current inp ...
-
IBM P76 - page 22
14 Technical Features Plug & Play This monitor complies with the DDC 1, DDC2B and DDC2Bi Display Data Channel (DDC) standards of VESA. When a DDC1 host system is connected, the monitor synchronizes with the V. CLK in accordance with the VESA standards and outputs the EDID (Extended Display Identification Data) to the data line. When a DDC2B ...
-
IBM P76 - page 23
15 Getting Started F GB ES C Technical Features Preset Modes No. 1 2 3 4 5 6 7 8 Resolution (dots × lines) 640 × 480 640 × 480 640 × 480 800 × 600 800 × 600 1024 × 768 1024 × 768 1280 × 1024 Horizontal Frequency 31.5 kHz 37.5 kHz 43.3 kHz 46.9 kHz 53.7 kHz 60.0 kHz 68.7 kHz 80.0 kHz Vertical Frequency 60 Hz 75 Hz 85 Hz 75 Hz 85 Hz 75 Hz 85 ...
-
IBM P76 - page 24
16 Additional Information T roubleshooting This section may help you isolate the cause of a problem and as a result, eliminate the need to contact technical support. Symptom Check these items No picture If the u indicator is not lit If the “CHECK SIGNAL CABLE” message appears on the screen, or if the u indicator is either orange or alternating ...
-
IBM P76 - page 25
17 Getting Started F GB ES C Additional Information Additional Information Symptom Check these items Screen image is not centered or sized properly Edges of the image are curved White lines show red or blue shadows at edges Picture is fuzzy Picture bounces or has wavy oscillations Picture is flickering Picture appears to be ghosting Wavy or ellipti ...
-
IBM P76 - page 26
18 Additional Information Specifications Picture tube 0.24 mm aperture grille pitch 17 inches measured diagonally 90-degree deflection Viewable image size Approx. 327 × 243 mm (w/h) (12 7 / 8 × 9 5 / 8 inches) 16.0” viewable diagonal Resolution Horizontal: Max. 1600 dots Vertical: Max. 1200 lines Standard image area Approx. 312 × 234 mm (w/h) ...
-
IBM P76 - page 27
I Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radi ...
-
IBM P76 - page 28
II MPRII This product complies with Swedish National Council for Metrology (MPR) standards issued in December 1990 (MPRII) for very low frequency (VLF) and extremely low frequency (ELF). Hinweise Gemäß der Amtsblätter des BMPT Nm. 61/1991 und 6/1992 wird der Betreiber darauf aufmerksam gemächt, daß die von ihm mit diesem Gerät zusammengestell ...
-
IBM P76 - page 29
III European Union (EU) Statement This product has been tested and found to comply with the limits for Class B Information Technology Equipment according to CISPR 22 / European Standard EN 55022. The limits for Class B equipment were derived for typical residential environments to provide reasonable protection against interference with licensed com ...
-
IBM P76 - page 30
IV Statement of Limited Warranty U.S., Canada and Puerto Rico The warranties provided by IBM in this Statement of Limited Warranty apply only to Machines you originally purchase for your use, and not for resale, from IBM or your reseller. The term “Machine” means an IBM machine, its features, conversions, upgrades, elements, or accessories, or ...
-
IBM P76 - page 31
V Extent of Warranty IBM does not warrant uninterrupted or error-free operation of a Machine. The warranties may be voided by misuse, accident, modification, unsuitable physical or operating environment, improper maintenance by you, removal or alteration of Machine or parts identification labels, or failure caused by a product for which IBM is not ...
-
IBM P76 - page 32
VI Congratulations! You have just purchased a TCO’95 approved and labelled product! Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and also, to the further development of environmentally adapted electronics products. Why do we have environmen ...
-
IBM P76 - page 33
Getting Started Appendix VII On this page, you will find a brief summary of the environmental requirements met by this product. The complete environmental criteria document may be ordered from: TCO Development Unit S-114 94 Stockholm Sweden Fax: +46 8 782 92 07 Email (Internet): development@tco.se Current information regarding TCO’95 approved and ...
-
IBM P76 - page 34
VIII Congratulations! You have just purchased a TCO’99 approved and labelled product! Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and also to the further development of environmentally adapted electronics products. Why do we have environme ...
-
IBM P76 - page 35
Getting Started Appendix IX Labelled products must meet strict environmental demands, for example, in respect of the reduction of electric and magnetic fields, physical and visual ergonomics and good usability. Below you will find a brief summary of the environmental requirements met by this product. The complete environmental criteria document may ...
-
IBM P76 - page 36
X Service Information The following parts are for use by IBM service, or IBM authorized dealers, to support customer warranty. Parts are for service use only. Part No M/T-Model Description 21L4572 6556-03N Monitor UVNH (Pearl White), NA/EMEA 21L4573 6556-43N Monitor UVNH (Stealth Gray), NA/EMEA 61H0213 6556-03N Monitor UVSH (Pearl White) 61H0214 65 ...
-
IBM P76 - page 37
Getting Started Getting Started XI ...
-
IBM P76 - page 38
Printed in Japan P202 User Guide P ar t Number 61H0239 EC D03285 *61H0239* ...
IBM P76についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもIBM P76の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがIBM P76で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。