GE ZET1の取扱説明書

16ページ 0.66 mb
ダウンロード

ページに移動 of 16

Summary
  • GE ZET1 - page 1

    1 30 ” Built-In W all Oven Installation Instructions ZET1, ZET2 If you have questions, call 1.800.GE.CARES or visit our website at: ge.com Before Y ou Begin Read these instructions carefully and completely . • IMPORT ANT —Save these instructions for local inspector ’ s use. • IMPORT ANT —Observe all governing codes and ordinances. • N ...

  • GE ZET1 - page 2

    2 IMPORT ANT SAFETY INSTRUCTIONS Installation Instructions For Y our Safety • Be sure your oven is installed properly by a qualified installer or service technician. • Be sure the oven is securely installed in a cabinet that is firmly attached to the house structure. Weight on the oven door could cause the oven to tip and result in injury . Nev ...

  • GE ZET1 - page 3

    3 Open oven door and remove literature pack, broiler pan and grid, oven racks, rack supports and a bag with 9 hex nuts. Read Installation Instructions carefully before you begin. Be sure to place all literature, Owner ’s Manual, Installations, etc. in a safe place for future reference. Remove packaging materials. Check behind hinges and under fal ...

  • GE ZET1 - page 4

    4 Place the oven on a table or platform even with the cutout opening. (Platform must support 175 lbs. [79 kg] single, 350 lbs. [159 kg] double.) Installation Instructions Pre-Installation Checklist cont. Remove the bottom trim from the top of the oven. It will be installed at the end of the installation process. The trim is wrapped separately and t ...

  • GE ZET1 - page 5

    5 Cabinet Width 30 ” (76.2 cm) Recommended Minimum Cutout Location from Floor 32 1/2 ” (82.6 cm) Cutout Depth 23 1/2 ” (59.7 cm) Min. Cutout Width 28 1/2 ” (72.4 cm) Min. 28 5/8 ” (72.7 cm) Max. Cutout Height 27 1/4 ” (69.2 cm) Min. 27 5/16 ” (69.2 cm) Max. If the cabinet does not have a solid bottom, two braces or runners must be ins ...

  • GE ZET1 - page 6

    6 Installation Instructions Cabinet Width 30 ” (76.2 cm) Recommended Minimum Cutout Location from Floor 12 ” (30.5 cm) Cutout Depth 23 1/2 ” (59.7 cm) Min. Cutout Width 28 1/2 ” (72.4 cm) Min. 28 5/8 ” (72.7 cm) Max. Cutout Height 51 13/16 ” (131.6 cm) Min. 51 15/16 ” (131.8 cm) Max. If the cabinet does not have a solid bottom, two br ...

  • GE ZET1 - page 7

    7 Installation Instructions Cutout for Single Built-In Oven Under Counter A3 25" Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for cutout size. See label on top of oven for approved cooktop models. Gas and electrical connections for 30" gas cooktop must be located in an adjacent accessible ...

  • GE ZET1 - page 8

    8 Cabinetry NOTE: Additional clearances between cutouts may be required. Check to be sure the oven supports above the W arming Drawer location do not obstruct the required interior 23 1/2 ” (59.7 cm) depth and 9 1/4 ” (23.5 cm) height. • These Monogram Ovens require 3/4 ” (1.9 cm) overlap on both sides. Allow 1 ” (2.5 cm) Min. for top ove ...

  • GE ZET1 - page 9

    9 NOTE: The middle rail separating the two openings may need to be larger than the 2 ” (5.1 cm) minimum shown. Always refer to the individual installation instructions packed with each product for specific requirements. Combined Advantium and W all Oven Installation: When installed in combination with a Monogram single wall oven, use separate ele ...

  • GE ZET1 - page 10

    10 (Continued on following page) Installation Instructions Electrical Connections ATTENTION INST ALLER All electric wall ovens must be hard wired (direct wired) into an approved junction box. A plug and receptacle is NOT permitted on these products. DO NOT shorten the flexible conduit. The conduit strain relief clamp must be securely attached to th ...

  • GE ZET1 - page 11

    11 Installation Instructions Electrical Connections cont. B6 Three-Conductor Branch Circuit Connection When connecting to a three-conductor branch circuit, if local codes permit: a. Connect the bare oven ground conductor with the crimped neutral (white) lead to the branch circuit neutral (white or gray in color), using a wire nut. b. Connect the ov ...

  • GE ZET1 - page 12

    12 (Continued on following page) W ARNING: Mounting screws must be used. Failure to do so could result in the oven falling out of the cabinet causing serious injury . Installation Instructions Securing the Oven in the Opening Drilling the Pilot Holes and Mounting the Oven a. Drill through the mounting holes (top and bottom) of the side trim, for th ...

  • GE ZET1 - page 13

    13 Installation Instructions Installing the Metal Bottom T rim IMPORT ANT : If this unit is ever removed from the cabinet or the oven is ever pulled out for service, the trim must be removed first or damage to the trim will occur . C4 a. Place the bottom trim between the side trim and against the bottom of the cutout. b. Using two trim screws provi ...

  • GE ZET1 - page 14

    14 Lift the oven door by placing one hand on each side. The door is heavy , so you may need help. Do not lift the door by the handle. With the door at the same angle as the removal position, seat the notch of the hinge arm into the bottom edge of the hinge slot. The notch of the hinge arm must be fully seated into the bottom of the slot. Open the o ...

  • GE ZET1 - page 15

    15 Installation Instructions Remove all protective film, if present, and any stickers. Check to be sure that all wiring is secure and not pinched or in contact with moving parts. NOTE T O ELECTRICIAN: Y ou must unplug the green wire (near where the long flexible conduit exits the unit) when conducting high-potential testing. Please replug prior to ...

  • GE ZET1 - page 16

    16 Printed in U.S.A. ...

メーカー GE カテゴリー Computer Drive

GE ZET1のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- ZET1の取扱説明書
- GEの製品カード
- パンフレット
- またはGE ZET1の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、GE ZET1の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、GE ZET1の取り付け説明書、サービスマニュアル、簡易説明書、またはGE ZET1のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、GE ZET1の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

GE ZET1デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがGE ZET1を使用するのを助ける技術的文書のことです。説明書は通常、全てのGE ZET1ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

GEの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. GE ZET1の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははGE ZET1の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。GE ZET1に関してこのドキュメントで見つけることができる全てのヒントの目次
3. GE ZET1デバイスの基本機能を使うにあたってのヒント。 GE ZET1のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。GE ZET1に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるGE ZET1のメーカー/サービスへの連絡先に関する情報。

GE ZET1についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもGE ZET1の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがGE ZET1で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)