Toro 53770の取扱説明書

12ページ 0.48 mb
ダウンロード

ページに移動 of 12

Summary
  • Toro 53770 - page 1

    Introduction The T oro Wireless RainSensor connects to your irrigation system controller/timer to suspend automatic watering operation in the event of rain. Designed for ease of installation, your sensor-controlled irrigation system will be up and running in minutes. Before attempting the installation, please read through these instructions in thei ...

  • Toro 53770 - page 2

    Component Overview Receiver (Figure 1) 1 - Weather -resistant Cover: Slides upward to remove. Protects the Receiver module when located outdoors. Keep the cover installed at all times other than when manu- ally operating the Receiver . 2 - Antenna wire: Straighten the antenna wire verti- cally for the best reception. 3 - Sensor Status Indicator: St ...

  • Toro 53770 - page 3

    Quick Start Installation Instructions The following instructions are provided for the experienced installer . If you are installing a T oro Wireless Rainsensor for the first time, use the Detailed Installation Instructions starting on page 4. 1. Disconnect power to the irrigation system controller . 2. Always mount the Receiver FIRST , adjacent to ...

  • Toro 53770 - page 4

    Detailed Installation Instructions There are two main components of the Wireless RainSensor: the Receiver and the Sensor/T ransmitter . The Receiver is installed adjacent to the irrigation system controller . The Sensor/T ransmitter is installed outdoors where it is exposed to unobstructed rainfall. Mounting the Receiver 1. Mount the Receiver FIRST ...

  • Toro 53770 - page 5

    Remove the valve common wire from the valve common terminal (generally marked “ C ” , “ COM ” , or “ VC ” ). Join this wire to the White wire using a wire connector . Attach the Brown wire to the valve common terminal. Note: The yellow wire is not used in this application. Remove all common control wires from the valve common terminal(s ...

  • Toro 53770 - page 6

    P art 2 - Po wer Wire Connection Note: The Receiver requires 24 V ac to operate. It should only be connected to an irrigation controller that uses a 24 V ac UL listed Class 2 transformer to supply power . Caution: Do not connect the Receiver directly to 120/240 V ac po wer as this may result in irre versible dama ge . If you are in doubt, contact a ...

  • Toro 53770 - page 7

    Initial Receiver T esting Reconnect power to the controller and verify the Receiver ’ s Power Indicator is illumi- nated. Hold the Sensor/T ransmitter at close range to the Receiver , then lightly press and hold the T est Spindle. The Sensor Status Indicator should illuminate and remain on until the T est Spindle is released. The Signal Indicator ...

  • Toro 53770 - page 8

    Installation Procedure The Sensor/T ransmitter should be mounted vertically with the antenna wire extending straight down. Avoid installations wher e the antenna wire would contact any metal object. A rain gutter is an ideal location for the Sensor/T ransmitter . Simply position the bracket with the thumbscrew under the gutter lip and tighten to se ...

  • Toro 53770 - page 9

    RainSensor Operation Normal Operation When the RainSensor activates due to sufficient rainfall, the Sensor Status Indicator will remain illuminated on the Receiver and the sprinkler system will remain inactive until the moisture-absorbent discs inside the Sensor/T ransmitter have dried out. The rate at which the discs dry out will vary dependent on ...

  • Toro 53770 - page 10

    Sensor/T ransmitter Battery Replacement 1 . Remove the bottom housing cover of the Sensor/T ransmitter by gently pressing in and down on the lower opposing tabs using a small flat-blade screwdriver , then carefully slide the circuit board out. See Figure 9 . 2 . Remove the battery cover and batteries. Replace using two 3V CR2032 (or equivalent) bat ...

  • Toro 53770 - page 11

    The obstacles will all affect the transmitted signal and typically reduce the radiated power that will be read by the Receiver . D if ferent objects such as walls and floors affect the transmitted signal dif ferently depending on the material composition, geom- etry and thickness. T ypically , most residential and light commercial construction mate ...

  • Toro 53770 - page 12

    Specifications: Receiver Mounting Options: Stainless steel screws and/or double-sided foam tape. Sensor/T ransmitter Mounting Options: Quick-Clip TM rain gutter bracket and roof eaves/fascia mounting bracket with stainless steel screws. Sensor/T ransmitter Range: Up to 300' line-of-site. Sensor T ype: Industry-standard hygroscopic disc stack w ...

メーカー Toro カテゴリー Weather Radio

Toro 53770のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 53770の取扱説明書
- Toroの製品カード
- パンフレット
- またはToro 53770の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Toro 53770の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Toro 53770の取り付け説明書、サービスマニュアル、簡易説明書、またはToro 53770のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Toro 53770の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Toro 53770デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがToro 53770を使用するのを助ける技術的文書のことです。説明書は通常、全てのToro 53770ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Toroの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Toro 53770の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははToro 53770の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Toro 53770に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Toro 53770デバイスの基本機能を使うにあたってのヒント。 Toro 53770のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Toro 53770に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるToro 53770のメーカー/サービスへの連絡先に関する情報。

Toro 53770についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもToro 53770の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがToro 53770で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)