Philips FR970の取扱説明書

24ページ 5 mb
ダウンロード

ページに移動 of 24

Summary
  • Philips FR970 - page 1

    Digital surr ound sound r eceiver FR960 FR970 ...

  • Philips FR970 - page 2

    2 DICHIARAZIONE DI CONFORMIT A ’ Si dichiara che gli apparecchi FR 960 e FR 970 Philips rispondono alle prescrizioni dell’art. 2 comma 1 del D. M. 28 Agosto 1995 n. 548. Fatto a Eindhoven, il 01/06/1999 Philips Consumer Electronics Philips, Glaslaan 2 5616 JB Eindhoven, The Netherlands Italia T ypeskilt finnes på apparatens bakside. Observer: ...

  • Philips FR970 - page 3

    3 English ....................................................4 Français.................................................24 Español .................................................44 Deutsch .................................................64 Nederlands ...........................................84 English Français Español Deutsch Nederlands I ...

  • Philips FR970 - page 4

    GENERAL INFORMA TION 4 This receiver is supplied including: – an universal remote control – 2 batteries for the remote control, size AA – a system bus cable for the CINEMA LINK connection – a loop antenna – a wire antenna – this instruction booklet Clean the receiver with a soft, slightly dampened, lint-free cloth. Do not use any cleani ...

  • Philips FR970 - page 5

    CONTROLS 5 1 POWER / ST ANDBY .......Switches the receiver on and off. 2 CINEMA LINK ................Switches the system control bus between the receiver and the TV on and off. 3 ..........................................Sensor for the infrared remote control. 4 3D SURROUND ..............Control light for virtual 3D surround. 5 HALL ............... ...

  • Philips FR970 - page 6

    REMOTE CONTROL 6 Open the battery compartment of the remote control and insert 2 alkaline batteries, type AA (R06, UM-3). Remove batteries if they are flat or the remote control is not going to be used for a long time. Batteries contain chemical substances, so they should be disposed of properly . The buttons on the remote control work the same way ...

  • Philips FR970 - page 7

    REMOTE CONTROL 7 H MUTE .....................Mutes the sound of the receiver . 2 ................................Switches the receiver to standby . PHONO, TUNER, CD, CDR/T APE, TV , VCR, SA T , DVD ..............Switches the remote control to the commands of the different products. Selects the sources if pressed longer than 2 seconds. SA T only wor ...

  • Philips FR970 - page 8

    REMOTE CONTROL 8 Y ou can identify the universal remote control by the inscription Multibrand/Universal . The universal remote control must be programmed to use the codes for your appliances of different brands. This is done by keying in a 4-digit code or by scanning the codes until the correct one is found. We recommend to using the 4-digit code. ...

  • Philips FR970 - page 9

    CONNECTORS 9 Connectors Connectors name Connect to: 6.3 mm headphone socket 1 PHONES A headphone with a 6.3 mm plug. at the front Audio and video inputs 2 FRONT A V / GAME Audio and video out sockets of appliances such as video cameras at the front (FR 970 only) and game consoles. FRONT SPEAKERS 3 R, L Right and left front speaker . 4 CENTER Center ...

  • Philips FR970 - page 10

    CONNECTIONS 10 English Digital audio connections Audio connections ANTENNA CINEMA LINK VIDEO IN/OUT AM LOOP DVD MON VCR SAT DIGITAL AUDIO IN/OUT OPTICAL IN COAX 1 IN COAX 2 IN COAX OUT SUBWOOFER PRE-OUT IN OUT OUT REC IN IN PLAY PHONO VCR TV SAT CD CDR/TAPE AUDIO IN/OUT L R IN IN IN PLAY OUT REC IN IN IN PLAY OUT REC PRE-OUT CENTER R L EACH SPEAKER ...

  • Philips FR970 - page 11

    CONNECTIONS 11 English System control bus, CINEMA LINK Video connections If the receiver and your Philips TV (or even better in addition a Philips VCR or DVD player) are connected with the CINEMA LINK system bus control, some extra system benefits are offered: – Upon starting a source the system will automatically switch to that input. – Y ou m ...

  • Philips FR970 - page 12

    CONNECTIONS 12 The type plate is located on the rear of the receiver . 1 Check whether the mains voltage as shown on the type plate corresponds to your local mains voltage. If it does not, consult your dealer or service organization. 2 Connect the mains cable to the wall socket. T o disconnect the set from the mains completely , remove the mains pl ...

  • Philips FR970 - page 13

    SYSTEM SETUP 13 General hints for positioning Avoid positioning the speakers in a corner or on the floor as this will boost the bass tones too much. Placing the speakers behind curtains, furniture, etc. will reduce the treble response. The listener should always be able to ” see ” the speakers. Each room has different acoustic characteristics a ...

  • Philips FR970 - page 14

    DISPLA Y 14 The display of the receiver is divided into 4 sections, which are to be used for the following: Speaker diagram A rectangle with a letter in it shows that a speaker has been selected in the setup menu. However , the subwoofer indicator will only light when a subwoofer signal is available. If only a letter is shown, this speaker is not u ...

  • Philips FR970 - page 15

    MENUS 15 The receiver is equipped with a menu system. The menu is used for the setup of the receiver . The different menu options are related to each other in a logical way . Let ’ s assume you have no center speaker connected, and therefore switched CENTER SPEAKR to NO . If you try to use VOL CENTER , a message will be scrolled that this is not ...

  • Philips FR970 - page 16

    MENUS 16 If the receiver is connected to a Philips CINEMA LINK TV via the CINEMA LINK system control bus sockets (see “ CONNECTIONS ” ), you may use the TV to set up the system. An option called RECEIVER will be added to the TV menu. If CINEMA LINK is on, adjustments on the receiver will be shown on the TV screen for a few seconds. Consult the ...

  • Philips FR970 - page 17

    SOURCE SELECTION 17 When selecting a source by turning SOURCE SELECTOR, the audio and video inputs with the corresponding name are activated. The incoming signal is reproduced by all audio and – if the source includes a video signal – video outputs of the receiver . It is possible to reassign a source selection to other than these standard inpu ...

  • Philips FR970 - page 18

    PLA YBACK, RECORDING 18 1 Press POWER / ST ANDBY to switch on the receiver . 2 T urn SOURCE SELECTOR to select a source. y The name of the source is displayed. • Y ou can select the FRONT A V / GAME input by pressing FRONT A V (FR 970 only). 3 Start playback of the source as usual. • T urn VOLUME to adjust the volume. y VOLUME and the volume le ...

  • Philips FR970 - page 19

    SURROUND SOUND 19 Surround sound gives you a complete new listening sensation. Y ou will have the feeling of being in the middle of the action, because sound is coming from everywhere around you. Look out for TV broadcasts, audio and video tapes and discs with the 31 or marks which are encoded for multichannel surround sound. Y ou should prefer Dol ...

  • Philips FR970 - page 20

    TUNER 20 Y ou can search for radio stations by scanning the frequency band. Y ou can also key in the frequency of a known radio station. If an FM station is being broadcast and received in stereo, STEREO is shown. Searching for radio stations 1 T urn SOURCE SELECTOR to select the tuner . y TUNER is displayed. 2 Select a waveband by pressing TUNER A ...

  • Philips FR970 - page 21

    TUNER 21 1 T urn SOURCE SELECTOR to TUNER to select the tuner . y TUNER is displayed. 2 T urn TUNER PRESET X to select a preset radio station. y PRESET , the preset number and station are displayed. After programming radio stations, you might want to change their sequence. RESHUFFLE allows you to exchange the positions of presets. 1 Choose * TUNER ...

  • Philips FR970 - page 22

    TUNER TECHNICAL DA T A 22 R adio D ata S ystem is a service that allows FM stations to send additional information. If you are receiving an RDS station, R and the station name are displayed. Switching through different RDS information • Press RADIO TEXT on the receiver repeatedly to switch through the following information (if available): – Rad ...

  • Philips FR970 - page 23

    23 English TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION No sound VOLUME is not correctly adjusted. Adjust the VOLUME. Headphones are connected. Disconnect headphones. The wrong source is selected. T urn SOURCE SELECTOR to select the correct source. No sound on the One speaker is wrongly connected. Connect the speaker properly . left or right sid ...

  • Philips FR970 - page 24

    3104 215 3604.3 FR960 FR970 VieUrs9942 English Fran ç ais Espa ñ ol Deutsch Nederlands Italiano Meet Philips at the Internet http://www . philips.com W ...

メーカー Philips カテゴリー Music Mixer

Philips FR970のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- FR970の取扱説明書
- Philipsの製品カード
- パンフレット
- またはPhilips FR970の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Philips FR970の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Philips FR970の取り付け説明書、サービスマニュアル、簡易説明書、またはPhilips FR970のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Philips FR970の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Philips FR970デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがPhilips FR970を使用するのを助ける技術的文書のことです。説明書は通常、全てのPhilips FR970ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Philipsの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Philips FR970の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははPhilips FR970の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Philips FR970に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Philips FR970デバイスの基本機能を使うにあたってのヒント。 Philips FR970のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Philips FR970に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるPhilips FR970のメーカー/サービスへの連絡先に関する情報。

Philips FR970についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもPhilips FR970の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがPhilips FR970で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)