-
Gastroback Design Mincer - page 1
Bedienungsanleitung DESIGN FLEISCHWOLF Art.-Nr . 41400 Bewahren Sie diese Anleitung zur weiteren V er wendung gut auf. Save the instructions for fur ther reference. GASTROBACK ® Bedienungsanleitung vor Gebrauch unbedingt lesen! Modell- und Zubehöränderungen vorbehalten! Read all provided instructions before first usage! Model and attachments are ...
-
Gastroback Design Mincer - page 2
19 19 Directions for Use Designation of the par ts a) O / I = ON/OFF switch b) Reverse c) Opening for the drive shaft d) Feedstick e) Feed pan f) W orm housing g) W orm h) Crossed-blade knife i) Mincer plate – 3 mm j) Mincer plate – 5 mm k) Mincer plate – 7 mm l) Chopper attachment A m) Chopper attachment B n) Closing ring o) Motor housing p) ...
-
Gastroback Design Mincer - page 3
Congratulations on the purchase of your new Gastroback Mincer and hope that it will soon convince you of its many advantages. Y ou will soon find that the Gastroback Mincer is an exceptionally efficient and robust appliance for processing meat and vegetables. Safety and Operating Instructions Gastr oback recommends safety first W e at Gastroback ar ...
-
Gastroback Design Mincer - page 4
• Never tr y to take the appliance to pieces or open it. • Never leave children unsupervised when the appliance or units of the appliance are in reach. • Never let children play with the appliance or units of the appliance. Children and invalid people have to be super vised using the appliance. • Never leave the mincer unattended, when conn ...
-
Gastroback Design Mincer - page 5
• Only install the appliance in proper for m secure grounding receptacle with adequate electric power supply (alter nating current; 230/240 V , 50 Hz) and ground fault circuit interrupter . The maximum power consumption of the appliance i s 800 Watt. Y ou should also install a fuse with a release current of maximum 30mA. If necessar y ask your el ...
-
Gastroback Design Mincer - page 6
• Never push the food into the feeding funnel with your fingers. Always use the feedstick for this purpose! The mincer can not mince hard or stingily ingredients (for example: bones, nuts, ginger). If you use hard ingredients like onions or carrots, you have to steam them before adding them to the meet other wise they can block the motor . If the ...
-
Gastroback Design Mincer - page 7
2. Loosen the screw plug on the left side of the mincer tur ning it anticlockwise. Firmly secure the worm housing in the opening for the drive shaft. The opening of the wor m housing should be upright. Hold the worm housing with one hand and inser t the screw plug into the side hole of the motor block. T urn the screw clockwise (see. fig. 1) for ti ...
-
Gastroback Design Mincer - page 8
Operating - Mincing meat The mincer operates absolutely dependently and clean. If any problems should occur while operating act upon instructions ´T rouble shooting`. W ARNING: For the case that liquid runs over the mincer while operating tur n the mincer OFF immediately and pull the plug. Clean and dr y the appliance according to the instructions ...
-
Gastroback Design Mincer - page 9
out the w o rm housing eventhough there is still meat in the feed funnel tur n the mincer OFF and work according to the instructions ´T rouble shooting guide`. 6. As soon as the last bit is minced tur n the appliance OFF and pull the plug. 7 . Clean and disassemble the appliance right after use and make sure that no leftover food desiccate on the ...
-
Gastroback Design Mincer - page 10
crossed-blade knife with the mincer plate a. Assemble the wor m housing in the opening of the drive shaft. Place the worm inside the wor m housing (operate according t o t h e instructions ´Assembling` the appliance. see fig. 1 and 2). b. Place the chopper attachment A on the axis of the wor m. The slim end has to face the front (see fig. 7). T ur ...
-
Gastroback Design Mincer - page 11
Disassembling W ARNING: T o avoid injur y and damages of the appliance turn the appliance O F F and then wait for appr ox. 6 seconds to be cer tain that the motor is no longer running. Always pull the plug before you star t disassembling or cleaning the appliance. 1. Switch off the mincer and disconnect the power supply cable from the mains. Check ...
-
Gastroback Design Mincer - page 12
ating t u r n OFF the appliance immediately , pull the plug and dr y the appliance with a clean cloth. 8. The motor block must only be wiped clean with a moist cloth. Do not clean the motor block under flowing water, nor should it be immersed in water! Do not use alcohol, benzine, etc.! 9. Grease the mincer plate and knife with salad oil to prevent ...
-
Gastroback Design Mincer - page 13
The mincer blocks up permanently while operating. The worm housing moves or loosened while operating. The mince leaks out at the side of the closing ring. Clear a blocking If the worm housing is blocked no mince comes out of the mincer while operating or the motor stops moving automatically because of the overload protection. A TTENTION: If a block ...
-
Gastroback Design Mincer - page 14
W aste disposal The appliance has to be deposed by the definition of the regional waste disposal of electricalscrap. If necessar y get infor mation of the regional waste management enterprise. W arranty W e guarantee that all our products are free of defects at the time of purchase. Any demonstrable manufacturing or material defects will be t o the ...
-
Gastroback Design Mincer - page 15
GASTROBACK GmbH Gewerbestraße 20 • D-21279 Hollenstedt/Germany T elefon: +49 (0)4165/2225-0 • Fax: +49 (0)4165/2225-29 www .gastroback.de • info@gastroback.de 41400_Manual_Fleischwolf_Juli2009.qxp 19.11.2009 09:24 Seite 32 ...
Gastroback Design Mincerについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもGastroback Design Mincerの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがGastroback Design Mincerで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。