Sigma ML750の取扱説明書

22ページ 2.23 mb
ダウンロード

ページに移動 of 22

Summary
  • Sigma ML750 - page 1

    TM T M Illustrated Instruction Manual for ML750 Garage Door Operator Chamberlain Australia Pty Ltd PO Box 1446 Lane Cove NSW 1595 www .motorlift.com.au Chamberlain New Zealand Ltd P .O. Box 100-221 Auckland 1330 www .motorlift.co.nz N2966 ...

  • Sigma ML750 - page 2

    The Protector System must be installed when the force at the edge of the closing door force exceeds 400N (40kg). Excessive force will interfere with the proper operation of the Safety Reverse System or damage the garage door . Permanently fasten the caution label adjacent to the wall-mounted door control control button as a reminder of safe operati ...

  • Sigma ML750 - page 3

    Door T ypes 1 A. One-Piece Door with Horizontal T rack Only . B. One-Piece Door with Horizontal and V ertical T rack – Special door arm and the Protector System™ (30(8)) required. See your dealer . C. Sectional Door with Curved T rack – See 20B – connect door arm. The Protector System™ (30(8)) is required for doors that are over 2,5m in h ...

  • Sigma ML750 - page 4

    10 19 7 3 4 6 12 13 8 NOTICE 11 15 14 17 18 1 20 16 21 2 (4x) (2x) (3x) (4x) (2x) (2x) (4x) (2x) (2x) (1x) (1x) (1x) (1x) (1x) (4x) (7x) (7x) (3x) (1x) 9 (1x) 5( 2 x ) 1 2 3 12 4 5 9 7 10 11 13 14 6 8 15 10 (1) Hex Bolt (2) Clevis Pin (3) 8mm Carriage Bolt (4) Wood Screws (5) Flat head Screws (6) Clevis Pin (7) Rope (8) Handle (9) W all mount brack ...

  • Sigma ML750 - page 5

    Install the Belt Remove belt from carton and lay out on floor (do not allow bel t to tw is t). Hook the trolley connector (6) into the slot (7) on the trolley (8). 6 ASSEMBL Y 5 2 3 4 5 2 1 5 7 6 8 1 2 3 4 5 7 7 Insert Trolley & Idler Pulley Bracket into Rail Slide idler pulley bracket (1) and inner trolley (2) into back (opener) end of rail as ...

  • Sigma ML750 - page 6

    1 6 2 4 5 3 9 Fasten Rail to Opener and Install Belt Remove four washered bolts (1) from top of opener . Place rail (2) on opener , flush with stop (3) on top of opener . Wrap belt (4) over sprocket (5). Push idler pulley bracket assembly toward front of the rail to eliminate excess slack in belt. Align bolt holes on brackets (6) with bolt holes on ...

  • Sigma ML750 - page 7

    Wear protective goggles when working overhead to protect your eyes from injury . Disengage all existing garage door locks to avoid damage to the garage door . T o avoid serious personal injury from entanglement, remove all ropes connected to the garage door before installing the opener . Note: It is recommended that the opener be installed no less ...

  • Sigma ML750 - page 8

    1 2 2 1 1 2 14 Attach Rail to Header Bracket Position opener on garage floor below the header bracket. Use packing material to protect the cover . Raise rail until holes in the header sleeve and holes in the header bracket align. Join with clevis pin (1). Insert ring fastener (2) to secure. NOTE: T o enable the rail to clear sectional door springs, ...

  • Sigma ML750 - page 9

    1 15 Position the Opener NOTE: A 25mm (1") board (1) is convenient for setting an ideal door-to-rail distance (unless headroom is not sufficient). Raise the opener onto a stepladder . Open garage door . Place a 25mm (1") board (1) laid flat on the top section of door near the centerline as shown. Rest the rail on the board. If the raised ...

  • Sigma ML750 - page 10

    2 3 4 NO TI CE 2 1 17 2 1 24V/21W Ma x 18 Attach Emergency Release Rope & Handle Thread one end of rope (1) through hole in top of red handle so "NOTICE" reads right side up as shown (3). Secure with an overhand knot (2). Knot should be at least 25mm (1") from end of the rope to prevent slipping. Thread other end of rope through ...

  • Sigma ML750 - page 11

    20 7 6 2 9 1 8 4 5 3 A 4 3 5 B 7 6 6 1 2 6 4 5 7 3 11 Assemble Door Arm A. ONE-PIECE DOOR INST ALLA TION: Fasten the straight (1) and curved (2) door arm sections together to the longest possible length (with a 2 or 3 hole overlap) using hardware (3,4 and 5). With the door closed connect the straight door arm section (1) to the door bracket with cl ...

  • Sigma ML750 - page 12

    4 2 3 1 WHT -2 R E D -1 5 6 6mm 1 2 4 WHT RED 1 4 LOCK LIGHT 3 3 2 3 21 Multi-function Door Control: Press the white square to open or close the door . Press again to stop the door while it is moving. Light Feature: Press the Light button to turn the opener light on or off. If you turn it on and then activate the opener , the light will remain on f ...

  • Sigma ML750 - page 13

    1 3 2 4 6 5 7 L O C K L I G H T L O C K L I G H T 22 Program your Opener & Remote Activate the opener only when door is in full view , free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play near the door . ...

  • Sigma ML750 - page 14

    1 2 4 3 7 LO C K L I G H T 5 LO C K LIG H T 6 L OCK LIG H T 23 Program your Keyless Entry (optional) Activate the opener only when door is in full view , free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play ...

  • Sigma ML750 - page 15

    1 2 3 1 2 3 4 25 2 2 (2x) 3 4 26 1 27 T est the Safety Reverse System The safety reverse system test is important. Garage door must reverse on contact with a 40mm obstacle laid flat on the floor . Failure to properly adjust opener may result in serious personal injury from a closing garage door . Repeat test once a month and adjust as needed. Proce ...

  • Sigma ML750 - page 16

    4 3 28 A B 8 7 6 5 29 Special Features A. Door within a door connection Open light lens. Locate auxiliary quick connect terminals. Insert bell wire into quick connect terminals 8 and 7. B. Flashing light connection The flashing light can be installed anywhere. Connect light leads to quick connect terminals 6 and 5. T erminal 5 is ground. Install th ...

  • Sigma ML750 - page 17

    8 9 7 3 2 5 4 L O CK L I G H T 6 1 30 Accessories (1) Model 84330AML Single-Function Remote Control (2) Model 84335AML 3-Function Mini Remote Control (3) Model 84333AML 3-Function Remote control (4) Model 8747AML Wireless Keypad (5) Model 770AML The Protector System™ (6) Model 8454AML Multi-function Door Control Panel (7) Model 75AML Illuminated ...

  • Sigma ML750 - page 18

    NOTI C E 41A2828 12B374 178B34 178B35 178B69 41B4616 4A10 0 8 1/2” 10 9A46 1” 83A1 1 41A5643-3 12 V D C Pb Cd Hg 12B380 12C778 41A580 0 12C855 183D177 183D178 41A5887 0 0 1A50 60 -15 10 A 20 216A20 6 31D536 31D533 41A5843 41A5799 210C42 12C777 144C77 146A1 12 12C810 31 001A5060-15 Replacement Parts 18 ...

  • Sigma ML750 - page 19

    41A589-1 41A5735C 111 A 7 9 41C161 (ML750) 41D577 41D538 108C82 41A5908 158A49 32 204C0161-2 19 ...

  • Sigma ML750 - page 20

    TROUBLE SHOOTING 1. Opener doesn't operate from either door control or remote: • Does the opener have electric power? Plug lamp into outlet. If it doesn't light, check the fuse box or the circuit breaker . (Some outlets are controlled by a wall switch.) • Have you disengaged all door locks? Review installation instruction warnings on ...

  • Sigma ML750 - page 21

    Once a Y ear: • Apply grease to rail and trolley • Oil door rollers, bearings and hinges • DO NOT lubricate the opener itself • DO NOT APPL Y grease to the door tracks When properly installed, opener will provide high performance with a minimum of maintenance. The opener does not require additional lubrication. Limit and Force Settings: The ...

  • Sigma ML750 - page 22

    Liability – Australia only Under no circumstances shall the Seller be liable for consequential, incidental or special damages arising in connection with the use, or inability to use, the Unit. In no event shall the Seller's liability for damages or injury arising from breach of law or contract or for negligence, exceed the cost of repairing ...

メーカー Sigma カテゴリー Garage Door Opener

Sigma ML750のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- ML750の取扱説明書
- Sigmaの製品カード
- パンフレット
- またはSigma ML750の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Sigma ML750の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Sigma ML750の取り付け説明書、サービスマニュアル、簡易説明書、またはSigma ML750のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Sigma ML750の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Sigma ML750デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがSigma ML750を使用するのを助ける技術的文書のことです。説明書は通常、全てのSigma ML750ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Sigmaの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Sigma ML750の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははSigma ML750の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Sigma ML750に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Sigma ML750デバイスの基本機能を使うにあたってのヒント。 Sigma ML750のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Sigma ML750に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるSigma ML750のメーカー/サービスへの連絡先に関する情報。

Sigma ML750についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもSigma ML750の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがSigma ML750で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)