Pelco EH3512の取扱説明書

20ページ 0.61 mb
ダウンロード

ページに移動 of 20

Summary
  • Pelco EH3512 - page 1

    ® INST ALLA TION EH3508/EH3512/EH3515 Series Environmental Enclosure C478M-M (1/06) ...

  • Pelco EH3512 - page 2

    ...

  • Pelco EH3512 - page 3

    C478M-M (1/06) 3 Important Safety Instructions Prior to installation and use of this product, the following W ARNINGS should be observed. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Only use attachments/accessories specifi ed by the manufacturer. 6. Use only with the cart, stand, tri ...

  • Pelco EH3512 - page 4

    4 C478M-M (1/06) Description The EH3508/EH3512/EH3515 Series are indoor/outdoor light-duty camera enclosures designed for use with various cameras on the market and accommodate fi xed focal length or motorized zoom lenses, with or without auto-iris operation. The lid of the enclosure is hinged in the front providing easy access during installation ...

  • Pelco EH3512 - page 5

    C478M-M (1/06) 5 Installation The following items are supplied to mount the enclosure: 2 1/4-20 x 0.500-inch hex head screws 2 Flat washers 2 Split washers The following items are supplied to mount the camera: 2 1/4-20 x 0.375-inch Phillips screws Figure 1. Package Contents HEX HEAD SCREWS FLAT WASHERS SPLIT WASHERS PHILLIPS SCREWS NUTS AND GLANDS ...

  • Pelco EH3512 - page 6

    6 C478M-M (1/06) Figure 2. Exploded View of EH3500 Series Assembly FLAT WASHER SPLIT WASHER HEX HEAD SCREW EM1450 WALL MOUNT (NOT SUPPLIED) GLANDS PHILLIPS SCREWS CAMERA SLED SLED MOUNTING SCREWS ...

  • Pelco EH3512 - page 7

    C478M-M (1/06) 7 Perform the following steps to install the enclosure, camera, and lens: 1. Unlatch and open the lid. 2. Remove the camera sled from the rail of the enclosure. a. Loosen the screws that hold the camera sled in place. b. Slide the sled forward so it can be lifted out over the screws. c. Remove the sled. d. Remove the parts bag tied t ...

  • Pelco EH3512 - page 8

    8 C478M-M (1/06) 9. If the enclosure has accessories that require power, you will need to access the PC board. T o remove the cover, insert a screwdriver into the slot on top of the cover and lift the cover off. Connect the power for the accessories to pins 1 and 2 on the PC board (refer to Figures 4, 5, and 6 for information about accessory wiring ...

  • Pelco EH3512 - page 9

    C478M-M (1/06) 9 Figure 4. EH3508-1/-2/-3 Wiring Diagram 1 2 3 4 5 6 7 8 9 10 HEA TER DEFROSTER INPUT , AC HIGH INPUT , AC LOW (NEUTRAL) 24/120/230 V AC MODELS ...

  • Pelco EH3512 - page 10

    10 C478M-M (1/06) Figure 5. EH3512 Series Wiring Diagram NOTE: Blower applies to -1/-2/-3 models only. 1 2 3 4 5 6 7 8 9 10 HEA TER DIODE BRIDGE INPUT , AC HIGH INPUT , AC LOW (NEUTRAL) 24 V AC MODEL DEFROSTER BLOWER RED BLK RED BLK CAP 1 2 3 4 5 6 7 8 9 10 INPUT , AC HIGH INPUT , AC LOW (NEUTRAL) 230 V AC MODEL DEFROSTER HEA TER 120 V AC BLOWER RE ...

  • Pelco EH3512 - page 11

    C478M-M (1/06) 11 Figure 6. EH3515 Series Wiring Diagram NOTE: Blower applies to -1/-2/-3 models only. 1 2 3 4 5 6 7 8 9 10 INPUT , AC HIGH INPUT , AC LOW (NEUTRAL) 120 V AC MODEL DEFROSTER BLOWER REAR HEA TER FRONT HEA TER 1 2 3 4 5 6 7 8 9 10 DIODE BRIDGE INPUT , AC HIGH INPUT , AC LOW (NEUTRAL) 24 V AC MODEL DEFROSTER BLOWER RED BLK RED BLK CAP ...

  • Pelco EH3512 - page 12

    12 C478M-M (1/06) T able A. Enclosure Accessory Wiring Distances The following cable sizs are the minimum recommended for sue with the heater and defroster combination in enclosures in the EH3508 Series, and the heater, defroster , and blower combination in enclosures in the EH3512 Series and Eh3515 Series only . WARNING: When using a single power ...

  • Pelco EH3512 - page 13

    C478M-M (1/06) 13 T able A. Enclosure Accessory Wiring Distances (Continued) Model Number Input V oltage Accessories Max. Power Consumption Cable Size Cable Distance EH3515-3 230 VAC at 50 Hz Heater Defroster Blower* 43 watts 20 AWG 18 AWG 16 AWG 14 AWG 6,473 ft (1,973 m) 10,291 ft (2,137 m) 16,365 ft (4,988 m) 26,019 ft (7,931 m) EH3515-1HD 120 VA ...

  • Pelco EH3512 - page 14

    14 C478M-M (1/06) Example: An enclosure that requires 30 VA and is installed 94 feet (28 m) from the transformer would require a minimum wire gauge of 20 A WG. NOTE: Distances are calculated in feet; values in parentheses are meters . *Minimum Cable Requirements 75 Ohms Impendance All-copper center conductor All-copper braided shield with 95% braid ...

  • Pelco EH3512 - page 15

    C478M-M (1/06) 15 Operation If your enclosure has a thermostatically controlled heater, the thermostat is set to turn on at 50°F (10°C) and to turn off at 80°F (27°C). If your enclosure has a blower and/or defroster, they operate continuously. MAINTENANCE Regularly scheduled maintenance prolongs the operational life and appearance of the equipm ...

  • Pelco EH3512 - page 16

    16 C478M-M (1/06) Specifications Camera Mounting Multiple holes on adjustable camera sled; camera sled mounts in threaded strip for easier removal and can be inverted for additional camera elevation Camera and Lens Size Accommodates camera and lens combinations (including BNC connector) up to 2.87” W x 3.00” H (7.28 x 7.62 cm) and the followin ...

  • Pelco EH3512 - page 17

    C478M-M (1/06) 17 Figure 7. EH3508, EH3512, EH3515 Dimension Drawing 5.14 (13.05) 3.88 (9.86) 2.00 (5.08) A B C EH3512 EH3515 A 14.75 (37.47) 17.75 (45.09) B 12.75 (32.38) 15.75 (40.00) C 1 1.25 (28.57) 14.25 (36.20) EH3508 10.75 (27.30) 8.75 (22.22) 7.32 (18.59) NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES. This equipment con ...

  • Pelco EH3512 - page 18

    18 C478M-M (1/06) REVISION HISTORY Manual # Date Comments C478M-J 6/99 Moved the EH3508 Series enclosures from manual C1435M-A. Updated the description, installation instructions, and specifications. Updated wiring diagrams and dimension drawing. Modified per ECO 99-4749, which changed heater and defroster design. C478M-K 7/99 Incorporated addend ...

  • Pelco EH3512 - page 19

    PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. • Three years on Genex ® Series p ...

  • Pelco EH3512 - page 20

    ® Worldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & Canada T el: 800/289-9100 Fax: 800/289-9150 International T el: 1-559/292-1981 Fax: 1-559/348-1120 www.pelco.com ISO 9001 United States | Canada | United Kingdom | The Netherlands | Singapore | Spain | Scandinavia | France | Middle East ...

メーカー Pelco カテゴリー Home Security System

Pelco EH3512のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- EH3512の取扱説明書
- Pelcoの製品カード
- パンフレット
- またはPelco EH3512の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Pelco EH3512の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Pelco EH3512の取り付け説明書、サービスマニュアル、簡易説明書、またはPelco EH3512のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Pelco EH3512の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Pelco EH3512デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがPelco EH3512を使用するのを助ける技術的文書のことです。説明書は通常、全てのPelco EH3512ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Pelcoの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Pelco EH3512の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははPelco EH3512の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Pelco EH3512に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Pelco EH3512デバイスの基本機能を使うにあたってのヒント。 Pelco EH3512のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Pelco EH3512に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるPelco EH3512のメーカー/サービスへの連絡先に関する情報。

Pelco EH3512についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもPelco EH3512の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがPelco EH3512で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)