-
Soundstream Technologies RUB1.2500D - page 1
Owner’s Manual and Installation Guide RUB1.1000D RUB1.1600D RUB1.2500D T E C H N O L O G I E S ...
-
Soundstream Technologies RUB1.2500D - page 2
CONGR A TULA TIONS! Y ou now own a Limited Edition RUBICON Amplifier , the product of an uncompromising design and engineering philosophy . T o maximize the performance of your system, we recommend that you thoroughly acquaint yourself with its capabilities and features. Please retain this manual and you sales receipt for future reference. Soundstr ...
-
Soundstream Technologies RUB1.2500D - page 3
FEA TURES T otal Harmonic Distortion:0.5% Frequency Response: 15-150Hz Signal to Noise Ratio: 105dB Damping Factor: >250 Input Sensitivity 100mV - 8V 50-150Hz,12dB Low Pass Fiter 45Hz, 0-18dB Bass Boost 10-40Hz, 12dB Subsonic Filter 180° Phase Switch Midnight Blue Finish w/ Brushed Accents Remote Gain Control Master/Slave Operation Pre-amp Outp ...
-
Soundstream Technologies RUB1.2500D - page 4
SPECIFICA TIONS Frequency Response 15Hz-150Hz LPF Signal/Noise Ratio Input Voltage Range >105dB THD 50Hz -150Hz,12dB 11-16 Volts DC 30K Ohms High Impedance RCA/LINE Level Input Impedance POWER RA TINGS & FUSE MODEL 4 ohm 2 ohm 1 ohm FUSE RUB1.1000D RUB1.1600D RUB1.2500D 600W 700W 1000W 800W 1100W 1700W 1000W 1600W 2500W 35A X 3 40A X 4 250A ...
-
Soundstream Technologies RUB1.2500D - page 5
TOOLS/P ARTS FOR INST ALLA TION NOTE: TOOLS ARE NOT SUPPLIED Small flat blade screwdriver phillips screwdriver (#2 or medium sized), Wire cutters, Wire strippers, - #6 round head screws, and 1 - #8 sheet metal screw (or nut, bolt flat washer , start washer) (see detail) 2 Ring connectors (large enough to accommodate your method of grounding) In-lin ...
-
Soundstream Technologies RUB1.2500D - page 6
Electrical Wiring All RUBICON Amplifiers are equipped with easy top access screw terminals . These terminals are nickel-plated in order to ensure excellent electrical contact and to resist corrosion. When making electrical connections to the amplifier , please observe the following : Use at least 4 gauge or heavier wire for power and ground connect ...
-
Soundstream Technologies RUB1.2500D - page 7
PANEL LAYOUT RUB1.1000D RUB1.1600D L R R L Line Out Line Input Input Level Subsonic Filter Bass Boost PHASE 0 180 Low Pass Filter Input Sensitivity Bridged Mode DAT ALINK PROTECTION REMOTE CONTROL Master Slave .1V-2V 2V-8V Min Max 10Hz 40Hz 50Hz 150Hz 0 +18dB L R R L Line Out Line Input Input Level Subsonic Filter Bass Boost PHASE 0 180 Low Pass Fi ...
-
Soundstream Technologies RUB1.2500D - page 8
PANEL LAYOUT RUB1.2500D Class D Monoblock Amplifier Installation Wiring RUB1.1000D/RUB1.1600D/RUB1.2500D R min max Power L R R L Line Out Line Input Input Level Subsonic Filter Bass Boost PHASE 0 180 Low Pass Filter Input Sensitivity Bridged Mode DATALINK PROTECTION REMOTE CONTROL Master Slave .1V-2V 2V-8V Min Max 10Hz 40Hz 50Hz 150Hz 0 +18dB L R R ...
-
Soundstream Technologies RUB1.2500D - page 9
Class D Monoblock Amplifier Installation Wiring RUB1.1000D/RUB1.1600D RUB1.1600D has four fuses here RUB1.1600D has four fuses here FUSES POWER CONNECTIONS BATT+ REMOTE GND SPEAKER FUSES POWER CONNECTIONS BATT+ REMOTE GND SPEAKER 9 ...
-
Soundstream Technologies RUB1.2500D - page 10
POWER CONNECTIONS SPEAKER POWER CONNECTIONS SPEAKER Class D Monoblock Amplifier Installation Wiring RUB1.2500D 10 ...
-
Soundstream Technologies RUB1.2500D - page 11
L R R L Line Out Line Input Input Level Subsonic Filter Bass Boost PHASE 0 180 Low Pass Filter Input Sensitivity Bridged Mode DAT ALINK PROTECTION REMOTE CONTROL Master Slave .1V-2V 2V-8V Min Max 10Hz 40Hz 50Hz 150Hz 0 +18dB L R R L Line Out Line Input Input Level Subsonic Filter Bass Boost PHASE 0 180 Low Pass Filter Input Sensitivity Bridged Mode ...
-
Soundstream Technologies RUB1.2500D - page 12
FUSES SPEAKER FUSES SPEAKER POWER CONNECTIONS BATT+ REMOTE GND POWER CONNECTIONS BATT+ REMOTE GND Bridging T wo RUB1.1000D/RUB1.1600D Amplifiers RUB1.1600D has four fuses here 12 ...
-
Soundstream Technologies RUB1.2500D - page 13
POWER CONNECTIONS SPEAKER Bridging T wo RUB1.2500D Amplifiers POWER CONNECTIONS SPEAKER 13 ...
-
Soundstream Technologies RUB1.2500D - page 14
TROUBLE SHOOTING NO SOUND Is the LED lit? YES NO Check Power and Remote turn-on wire for voltage. Make sure Ground wire is secure. STILL NO SOUND See your Authorize Sound Stream Dealer. SOUND IN ONE CHANNEL ONL Y Reverse left and right speakers by unplugging the speaker connector . turning it over and plugging it back in. SOUND IS NOW IN SOUND IS N ...
-
Soundstream Technologies RUB1.2500D - page 15
Caution: Please do not plug in or unplug RCA Plugs to the amplifier inputs while the amplifier is turned on. Doing so is potentially harmful to the amplifier by allowing RF(radio frequencies) into the amplifier , causing instability , during the brief period while the RCA shield is not connected, and the hot is connected. Only plug in or unplug RCA ...
Soundstream Technologies RUB1.2500Dについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもSoundstream Technologies RUB1.2500Dの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがSoundstream Technologies RUB1.2500Dで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。