A.O. Smith 750 SERIESの取扱説明書

24ページ 0.32 mb
ダウンロード

ページに移動 of 24

Summary
  • A.O. Smith 750 SERIES - page 1

    1 A DIVISION OF A. O. SMITH CORPORA TION MC BEE, SC., RENTON, WA., STRA TFORD-ONT ARIO, VELDHOVEN-THE NETHERLANDS w w w .hotwater .com GAS-FIRED COMMERCIAL COPPER BOILERS FOR HYDRONIC HEA TING AND HOT W A TER SUPPL Y USER'S INFORMA TION MANUAL GB/GW-300, 400, 500, 650, 750 SERIES 400, 401, 402, 403, 404, 405, 2-ST AGE UNITS W ARNING Should ove ...

  • A.O. Smith 750 SERIES - page 2

    2 Lighting Instructions for the G(B/W) 300 through 750 models THE UNIT SHOULD NOT BE INST ALLED DIRECTLY ON A CARPETED FLOOR. A FIRE HAZARD MA Y RESUL T . Instead, the boiler must be installed on the A. O. Smith Combustible Floor Kit Base or concrete blocks extending beyond the full width and depth of the boiler by at least 3 (76.2mm) inches. If th ...

  • A.O. Smith 750 SERIES - page 3

    3 LIGHTING INSTRUCTIONS These models have an automatic hot surface ignition system mounted on the combustion chamber panel inside the front jacket. This hot surface igniter ignites the main burner gas whenever the system control calls for heat. Before proceeding with operation of the unit, make sure the boiler and system are filled with water and a ...

  • A.O. Smith 750 SERIES - page 4

    4 the surrounding air pressure. Inspection of the boiler and vent system is necessary to insure that flue gas leakage to the surrounding area does not occur . Inspect the external surfaces of the vent system every 3 months for corrosion and leakage. Inspect the vent terminations for corrosion and foreign matter which may be blocking the exhausting ...

  • A.O. Smith 750 SERIES - page 5

    5 Figure 1A. CCB (Drawing #211758) ...

  • A.O. Smith 750 SERIES - page 6

    6 Figure 1B. FCB (Drawing #211759) ...

  • A.O. Smith 750 SERIES - page 7

    7 Figure 1C. PDB (Drawing #211760) ...

  • A.O. Smith 750 SERIES - page 8

    8 closed and everything else is in the proper state, a "call for heat" condition will be initiated. These leads should be shorted together, when a thermostat is not being used. If it is desired that the thermostat control the temperature of the boiler , the operating setpoint of the system should be set higher than the temperature that th ...

  • A.O. Smith 750 SERIES - page 9

    9 CCB - Three position Dipswitch (Flame Control Section): This dipswitch is similar to the FCB dipswitches described below , but with only three switches being used: the number of blower speeds (switch #3), Hi Gas option (switch #2) and a spare (switch #1). Only the blower speed selection and Hi Gas are required because FCB1 always has a blower , i ...

  • A.O. Smith 750 SERIES - page 10

    10 • S tored values are recalled from memory . • Configuration dipswitches are read. • Pending faults are recalled • Micros on all boards start running (indicated by a flashing Y ellow LED near each micro) • Input sensors are read • Communications between micros and boards is established • FCB's are configurated with the number o ...

  • A.O. Smith 750 SERIES - page 11

    11 The operation of these parts is described below: UIM Screens: On all screens a double vertical bar appears on the right side of the display each time a key is touched to indicate that a key has been activated. On several screens an indicator ">" appears on the left side of the display to indicate the active line. The "Up/ Down& ...

  • A.O. Smith 750 SERIES - page 12

    12 except the fault states. If enabled the powered vent and the IRI gas valve are turned on. A command is sent to all active stages to cold purge the system. Cold purging clears out any combustion gas that may be in the combustion chamber . When purging is complete the system moves to the Heat S tate. • Heat St ages 1-4: The system will command t ...

  • A.O. Smith 750 SERIES - page 13

    13 • User Settings Screen: Each setpoint or user setting has either a limited selection of values, or a limited range of values. The Up/Down keys are used to change values. After changing an item, the Select key is pressed to accept the change, or the Menu key is pressed to reject the change and restore the item to its original value. The followi ...

  • A.O. Smith 750 SERIES - page 14

    14 CONNECTION DIAGRAM (Drawing #21 1769) FIGURE 4. ...

  • A.O. Smith 750 SERIES - page 15

    15 ...

  • A.O. Smith 750 SERIES - page 16

    16 Number of cycles for each stage (Number of times stage has been in heat mode). Kbtu rating of the boiler (0 to 5750Kbtu in 10Kbtu increments) The software revision level of the CCB, and FCB micro- controllers. Current Error Screen: • Displays the last error that the system has detected plus a timestamp of when the error occurred. (The timestam ...

  • A.O. Smith 750 SERIES - page 17

    17 TROUBLESHOOTING IGNITION SYSTEM Fault Messages and Lockout S tatus (* = stage number: 1 or 2) Fault Displayed Description Red LED Lockout “Display Fail” Communications with UIM interrupted Continuous Auto Reset • Check communication cable to UIM. T ry moving to other Internal Communications connector on CCB. Also check the connectors where ...

  • A.O. Smith 750 SERIES - page 18

    “Blocked Flue” Flue is Blocked Continuous SOFT • Caused by the blocked flue switch contacts being open when they should have been closed. Check for flue blockage, switch contacts, wiring. “High Limit” Outlet temp. exceeded high limit setpoint Continuous Auto Reset • Caused when the temperature of the outlet probe exceeds the high limit ...

  • A.O. Smith 750 SERIES - page 19

    Other troubleshooting hints: 1. Input switches can be easily checked by observing their activation on the UIM System S tatus screen. Force the boiler to remain in the S t andby mode by opening the Thermost at input or by setting the operating setpoint to the minimum so that the system does not request heat. Then short out the contacts on the switch ...

  • A.O. Smith 750 SERIES - page 20

    20 NOTES ...

  • A.O. Smith 750 SERIES - page 21

    21 NOTES ...

  • A.O. Smith 750 SERIES - page 22

    22 NOTES ...

  • A.O. Smith 750 SERIES - page 23

    23 NEW BOILER LIMITED W ARRANTY A. O. Smith Corporation, the warrantor , extends the following LIMITED W ARRANTY to the owner of this hydronic boiler: 1. If within TEN years after initial installation of the boiler , the heat exchanger shall prove upon examination by the warrantor to be defective in material or workmanship, the warrantor , at his o ...

  • A.O. Smith 750 SERIES - page 24

    24 A DIVISION OF A. O. SMITH CORPORA TION MC BEE, SC., RENTON, WA., STRA TFORD-ONT ARIO, VELDHOVEN-THE NETHERLANDS w w w .hotwater .com ...

メーカー A.O. Smith カテゴリー Water Heater

A.O. Smith 750 SERIESのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 750 SERIESの取扱説明書
- A.O. Smithの製品カード
- パンフレット
- またはA.O. Smith 750 SERIESの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、A.O. Smith 750 SERIESの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、A.O. Smith 750 SERIESの取り付け説明書、サービスマニュアル、簡易説明書、またはA.O. Smith 750 SERIESのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、A.O. Smith 750 SERIESの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

A.O. Smith 750 SERIESデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがA.O. Smith 750 SERIESを使用するのを助ける技術的文書のことです。説明書は通常、全てのA.O. Smith 750 SERIESユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

A.O. Smithの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. A.O. Smith 750 SERIESの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははA.O. Smith 750 SERIESの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。A.O. Smith 750 SERIESに関してこのドキュメントで見つけることができる全てのヒントの目次
3. A.O. Smith 750 SERIESデバイスの基本機能を使うにあたってのヒント。 A.O. Smith 750 SERIESのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。A.O. Smith 750 SERIESに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるA.O. Smith 750 SERIESのメーカー/サービスへの連絡先に関する情報。

A.O. Smith 750 SERIESについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもA.O. Smith 750 SERIESの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがA.O. Smith 750 SERIESで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)