Extron electronic SI 3の取扱説明書

16ページ 1.38 mb
ダウンロード

ページに移動 of 16

Summary
  • Extron electronic SI 3 - page 1

    User’s Guide Compact Full Range Surface Mount Speakers 68-1261-01 Rev . A 11 07 SI 3 System INTEGRA TOR ™ ...

  • Extron electronic SI 3 - page 2

    SI 3 Speakers • Packaging Packaging Information Figure 1 — SI 3 speaker packaging details P a r t N o . X X X -X X X - 01 Install 206W Ce i li n g Spe aker 3 3 -X X X X - 0 1 R E V . Thick Single W all P acking Bottom F oam Speakers (each plastic wrapped) He x T ool (plastic wrapped) T op F oam Product Label W all Mount Assemblies Speaker Rear ...

  • Extron electronic SI 3 - page 3

    Intr oduction SI 3 Speakers • Introduction 1 About the SI 3 Speakers The Extron System INTEGRA TOR ™ SI 3 full range, compact, surface mount speaker is ideally suited for classrooms, conference r ooms, and boardr ooms. W ith a weather resistant construction, it is also suitable for outdoor environments, and has the following features (see below ...

  • Extron electronic SI 3 - page 4

    SI 3 Speakers • Features 2 Featur es Dimensions : 8.75" H x 5.75" W x 5.61" D (22.2 cm H x 14.6 cm W x 14.24 cm D) a Bass reflex port b Front locking access (allows for speaker position adjustment) c 3" full range driver with paper cone d Grill and enclosure may be painted to match envir onment e W eather resistant constructi ...

  • Extron electronic SI 3 - page 5

    Installation 3 SI 3 Speakers • Installation Installing the SI 3 Speakers The Extron SI 3 speakers can be mounted on a surface, such as a wall or post, or mounted in a bookcase, or on a shelf, and can be used with any Extron pr oduct supporting audio. N If the speakers are to be placed on a horizontal surface such as a desk or shelf, attach the ba ...

  • Extron electronic SI 3 - page 6

    4 SI 3 Speakers • Installation Installation, cont’d W all mounting applications Installing the wall mount assembly N Before starting installation, ensur e that the wall and wall material are capable of supporting the combined weight of the speakers and the wall mount assemblies. 1 . If mounting to drywall, use a stud locator to locate the studs ...

  • Extron electronic SI 3 - page 7

    4. Mark the wall where the wir e will pass through the plate, and cut a small access hole large enough for the wir e to pass through without interfer ence. Where the stud is wider than the plate's access hole, cut the hole in the wall to the left or right and directly alongside the stud (see figure 7). N Before cutting the hole in the wall, m ...

  • Extron electronic SI 3 - page 8

    Installation, cont’d 6 SI 3 Speakers • Installation 6 . Pull sufficient wir e up through the holes in the r ear plate (see figure 8) to allow ease of connection to the speaker after installation. N Do not strip and connect the wire at this time. P ass the wires through the plate access hole. Line of Stud Figure 8 — Passing the wir e through t ...

  • Extron electronic SI 3 - page 9

    Installation, cont’d 6 SI 3 Speakers • Installation 6 . Pull sufficient wir e up through the holes in the r ear plate (see figure 8) to allow ease of connection to the speaker after installation. N Do not strip and connect the wire at this time. P ass the wires through the plate access hole. Line of Stud Figure 8 — Passing the wir e through t ...

  • Extron electronic SI 3 - page 10

    8 SI 3 Speakers • Installation Installation, cont’d Wiring the speakers 1. When both speakers are in place, carefully pull enough speaker wir e to reach to the terminals at the back of the each speaker and strip the ends of the wire appr oximately 5/8" (15 mm). T wist the bare strands so that they ar e held firmly in the connectors. 2 . P ...

  • Extron electronic SI 3 - page 11

    5 . Insert the hex tool into the locking access, and slightly loosen the hex cap screw . Adjust the speaker to the desired angle (see figure 13), and tor que the hex cap screw down clockwise until snug, about 6 to 8 turns. The speaker remains secur ely in the desired position. T ur n cloc kwise to tighten. Figure 13 — Adjusting speaker and locki ...

  • Extron electronic SI 3 - page 12

    10 SI 3 Speakers • T roubleshooting Tips T r oubleshooting Tips T o refit the grill : 1 . Carefully pr ess the grill back into place. 2 . Insert and tighten down the screws. 3 . Replace the logo. Securing the grill (optional) N If the speaker makes the grill vibrate and creates unwanted noise when in use, it can be secured to the speaker enclosu ...

  • Extron electronic SI 3 - page 13

    Observed Problem Possible Cause(s) Remedial Action 1 Speaker easily lifted from mount assembly Locking hex cap screw not tightened enough Following the steps on page 9, tighten the hex cap screw until it is not possible to remove the speaker . 2 No sound heard from speakers Speaker cables not connected or damaged Output device (e.g., amplifier) Re ...

  • Extron electronic SI 3 - page 14

    12 SI 3 Speakers • Specifications Audio/acoustic and electrical Speaker type ................................... Indoor/outdoor surface mount speaker Frequency range ............................ 75 Hz to 18 kHz, -10 dB, half space Power capacity .............................. 16 W continuous pink noise 32 W continuous program Nominal sensitivity ...

  • Extron electronic SI 3 - page 15

    Extron’ s W arranty Extron Electr onics warrants this product against defects in materials and workmanship for a period of five years from the date of pur chase. In the event of malfunction during the warranty period attributable directly to faulty workmanship and/or materials, Extr on Electronics will, at its option, r epair or replace said prod ...

  • Extron electronic SI 3 - page 16

    © 2007 Extron Electronics. All rights reserved. Extron Electronics, USA 1230 South Lewis Street Anaheim, CA 92805 800.633.9876 714.491.1500 FAX 714.491.1517 Extron Electronics, Europe Beeldschermweg 6C 3821 AH Amersfoort, The Netherlands +800.3987.6673 +31.33.453.4040 FAX +31.33.453.4050 Extron Electronics, Asia 135 Joo Seng Rd. #04-01 PM Industri ...

メーカー Extron electronic カテゴリー Portable Speaker

Extron electronic SI 3のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- SI 3の取扱説明書
- Extron electronicの製品カード
- パンフレット
- またはExtron electronic SI 3の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Extron electronic SI 3の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Extron electronic SI 3の取り付け説明書、サービスマニュアル、簡易説明書、またはExtron electronic SI 3のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Extron electronic SI 3の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Extron electronic SI 3デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがExtron electronic SI 3を使用するのを助ける技術的文書のことです。説明書は通常、全てのExtron electronic SI 3ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Extron electronicの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Extron electronic SI 3の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははExtron electronic SI 3の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Extron electronic SI 3に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Extron electronic SI 3デバイスの基本機能を使うにあたってのヒント。 Extron electronic SI 3のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Extron electronic SI 3に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるExtron electronic SI 3のメーカー/サービスへの連絡先に関する情報。

Extron electronic SI 3についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもExtron electronic SI 3の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがExtron electronic SI 3で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)