-
DeWalt 50-665 - page 1
INSTRUCTION MANUAL 1 1 / 2 H . P . Dust Collector (Model 50-665) D ATED 8-8-99 P A R T NO. 1342493 'Delt a International Machinery Corp. 1999 Shown with Accessory Dust Collector Drum ...
-
DeWalt 50-665 - page 2
2 T ABLE OF CONTENTS SAFETY RULES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 IMPORT A N T SAFETY RULES F O R DUST COLLECT O R S . . . . . ...
-
DeWalt 50-665 - page 3
3 IMPORT ANT SAFETY RULES W oodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery , there are cert ai n hazards involved with the operation of the product. Using the machine with respect and caution will considerably lessen the pos si - bility of personal injury . However , i f normal safety pre ...
-
DeWalt 50-665 - page 4
4 IMPORT A N T SAFETY RULES F O R DUST COLLECT O R S INTRODUCTION Dust Collectors work by moving large volumes of air at lower suction pressures than vacuum cleaners. Delt a dust collectors are not designed to be used as high-suction cleaners; however , they are designed to help maint ain clean, safe conditions around dust-creating machines in work ...
-
DeWalt 50-665 - page 5
5 1 . Blower and Motor Assembly 2 . Vacuum Hose 3 . Cylinder 4 . Dust Bag Elbow 5 . Hose Clamp s ( 2 ) 6 . Dust Bag 7 . Dust Bag Clamp 8 . Hardware for Mounting Inlet Elbows, Includes: 3/8-16 x 1-1/4 H e x Head Screws (2), Flat W ashers (4), Lockwashers (2), and Locknut s 9 . Pan Head Screws 1 0 . Hardware for Mounting Cylinder to Cover , Includes: ...
-
DeWalt 50-665 - page 6
6 ASSEMBL Y 1 . Place gasket (A) Fig. 3, on bottom of motor and blower assembly (B). Align four holes in gasket with holes in motor and blower assembly and assemble cover ( C ) Fig. 3, to gasket and motor and blower assembly with four hex head screws, flat washers, lockwashers, and locknut s (D). 3 . Peel the adhesive p aper (E) Fig. 5, from the ba ...
-
DeWalt 50-665 - page 7
7 Fig. 7 Fig. 8 Fig. 9 Fig. 1 1 Fig. 10 5 . Position the remaining inlet elbow (K) Fig. 8, at the underside of dust collector lid (C) a s shown. A l i g n t h e mounting holes in inlet elbows (K) Fig. 8, with screws (J) assembled to upper inlet elbow (H) shown in Fig. 7, STEP 4 , and fasten the upper and lower inlet elbows to the cover with remaini ...
-
DeWalt 50-665 - page 8
8 CAUTION: Never remove safety grid for any reason except to perform maintenance procedures. There is a high speed blower wheel inside the blower housing that can amput ate fingers, grab loose clothing or neckties. Make cert ain the dust collector is discon - nected from the power source before performing any maintenance procedures . 8 . Place the ...
-
DeWalt 50-665 - page 9
9 Fig. 17 1 0 . Insert the bag clamp (Z) Fig. 16, through the loop s o f the dust bag (A). 11 . Clamp dust bag (A) Fig. 17, to bag elbow (V) a s shown by fastening bag clamp (Z). Fig. 16 Z A A Z V Fig. 18 Fig. 19 1 2 . Assemble reducer (B) Fig. 18, over the end of inlet elbow (H). 1 3 . Assemble hose clamp (C) Fig. 19, over one end of hose (D). Ass ...
-
DeWalt 50-665 - page 10
10 ON/OFF SWITCH The ON/OFF switch is conveniently located on the side of the motor . T o turn the dust collector ON push the switch (A) Fig. 22, upward to the ON position. T o turn the dust collector OFF , push the switch down to the OFF position. CONNECTING DUST COLLECT O R T O POWER SOURCE Before connecting your dust collector to an electrical p ...
-
DeWalt 50-665 - page 11
11 LOCKING SWITCH I N T H E O F F POSITION W e suggest when the dust collector is not in use that the ON/OFF switch be locked in the OFF position. This can be done by grasping the switch toggle (B) Fig. 23, and pulling it out of the switch (A) as shown. W ith the switch toggle (B) removed, the switch will not operate. However , should the switch to ...
-
DeWalt 50-665 - page 12
Delt a Building T rades and Home Shop Machinery T w o Y ear Limited W arranty Delt a will rep air or replace, at it s expense and at it s option, any Delt a machine, machine p a r t , or machine accessory which in normal use has proven to be defective in workmanship or material, provided that the customer returns the product prep aid to a Delt a fa ...
DeWalt 50-665についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもDeWalt 50-665の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがDeWalt 50-665で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。