Smeg CIR34AX3の取扱説明書

24ページ 1.75 mb
ダウンロード

ページに移動 of 24

Summary
  • Smeg CIR34AX3 - page 1

    Contents 3 1 INSTRUCTIONS FOR SAFE AND PROPER USE _____________________ 4 2 POSITIONING OF THE HOB _____________________________________ 6 3 GAS CONNE CTION ___________________________________________ 11 4 ELECTRICAL CONNECTION ____________________________________ 12 5 ADAPTATION TO DIFFERENT TYPES OF GAS _____________________ 13 6 FINAL OPERATIONS ...

  • Smeg CIR34AX3 - page 2

    Introduction 4 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WH OLE WORKING LIFE OF THE COOKING HOB. WE ADVISE R EADING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEF ORE USING THE COOKING HOB. ALSO KEEP THE SERIES OF NOZZLES SU ...

  • Smeg CIR34AX3 - page 3

    Introduction 5 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING MUST NOT BE REMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT HAS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDER THE CASING. DO NOT PUT PANS WITHOUT PERFECTLY SMO ...

  • Smeg CIR34AX3 - page 4

    Instructions for the installer 6 2 POSITIONING OF THE HOB It is the law that all gas a ppliances are installed by authorised persons . Clearance aro und the appliance must comply with the requirem ents of AS5601. The following operati on requires build ing and/or carpentry work so m ust be carried out by a competent tradesman. Installation can be c ...

  • Smeg CIR34AX3 - page 5

    Instructions for the installer 7 Bracket ‘ A ’ in the 1st slot Bracket ‘ A ’ in the 2nd slot Bracket ‘ B ’ Short sides Long sides 2.2 Fixing 90 cm hobs on 60 cm base unit If a 90 cm hob is to be bracketed to a 60 cm base unit, the 2 central brackets “ A ” have to be used in ad dition to the side brackets “ B ” as shown in the dr ...

  • Smeg CIR34AX3 - page 6

    Instructions for the installer 8 Overall dimensions: location of gas and electrical connection points (all measures in mm). 60 cm 90 cm hob hob A 35 105 B 65 50 C 30 50 D 85 75 2.3 Clearance above and around domestic appliances Extract from AS5601 ...

  • Smeg CIR34AX3 - page 7

    Instructions for the installer 9 REQUIREMENTS 1 Overhead clearances – (Measurement A ) Range hoods and exha ust fans shall be installed in accordance with the manufacturer’s instructions. However, in no case shall the clearance between the highest part of the hob of the cooking appliance and a range hood be less than 600 mm or, for an overhead ...

  • Smeg CIR34AX3 - page 8

    Instructions for the installer 10 3 For definition of hob, see Claus e 1.4.64. 4 For definition of triv et, see Clause 1.4.109. 5 Consideration is to be given to windo w treatments when located near cooking appli ances. See Clause 5.3.4. 2.4 Room ventilation Caution – This hob may only be installed and operated in rooms permanently ventilated in ...

  • Smeg CIR34AX3 - page 9

    Instructions for the installer 11 3 GAS CONNECTION This appliance is suitable for installation with Natur al Gas or ULPG (propane). Refer to page 12 for the relevant burner pressure an d appropriate injector sizes. When the appliance is to be connected to Natural Gas then the pressure regulator su pplied must be fitted to the gas inlet. A test poin ...

  • Smeg CIR34AX3 - page 10

    Instructions for the installer 12 4 ELECTRICAL CONNECTION Make sure that the voltage and cap acity of the power line conform to the data shown on the plate l ocated under the casing. Do not remove this plate for any reason. The plug o n the end of the supply cable and the wall soc ket must be the same type and conform to the curr ent electrical sys ...

  • Smeg CIR34AX3 - page 11

    Instructions for the installer 13 5 ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The hob has been adjusted for natural gas at a pressure of 1.0 kPa. For functioning with other types of gas the nozzles must be replaced and the primary air adjusted. To replac ...

  • Smeg CIR34AX3 - page 12

    Instructions for the installer 14 5.2 Removing the hob (models wi th built-in control panel) 1. Remove the knobs, the gri ddles, the burner caps, the flam e caps and the two rear plugs; 2. Remove the screws “A” which fix the burner supports; 3. Raise the hob, sliding it off the ignition plugs and/or the thermocouples and the gas tap rods; 5.3 A ...

  • Smeg CIR34AX3 - page 13

    Instructions for the installer 15 5.4 Adjustment for natural gas The hob has been adjusted for natural gas at a pressure of 1.0kPa. To allow the unit to work back with this type of gas, after it has been adjusted for ULPG, perform the same operations described in paragraph “5.3 Adjustment for ULPG”, but r efer to the following table for the pro ...

  • Smeg CIR34AX3 - page 14

    Instructions for the installer 16 6 FINAL OPERATIONS Having carried out the above adjustments, reassemble the ap pliance following, backwards, the instructions i n paragraph “ 5.1 Removing the control panel / 5.2 Removing the ho b”. 6.1 Adjustment of minimum for natural gas Light the burner and take it to the minimum . Remove the gas tap knob a ...

  • Smeg CIR34AX3 - page 15

    Instructions for the installer 17 6.2 Arrangement of burners on the hob (hobs with separable control panel). 60 cm hobs BURNERS 1. Auxiliary 2. Semirapid r 3. Semirapid l 4. Rapid large 5. Wok 90 cm hobs BURNERS 1. Auxiliary 2. Semirapid 3. Rapid 4. Fish burner 5. Wok ...

  • Smeg CIR34AX3 - page 16

    Instructions for the installer 18 6.3 Arrangement of burners on the hob (hobs with b uilt- in control panel). 60 cm hobs BURNERS 1. Auxiliary 2. Semirapid r 3. Semirapid l 4. Rapid 5. Wok 6.4 Lubrication of gas taps With time it may happen that the gas taps get blocked and h ard to turn. Clean them inside and r e-grease them. This operation must be ...

  • Smeg CIR34AX3 - page 17

    Instructions for the user 19 7 USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted cor rectly. In the wok burner, notch A must be aligned with pin B . Grid C provided is intended for use with wok s (Chinese pans). Adapter D comes only with o pen grids models and is intended for us e with sma ...

  • Smeg CIR34AX3 - page 18

    Instructions for the user 20 7.3 Diameter of containers Burners Ø min. and max . (en cm.) Auxiliary 12-14 Semirapid 16-20 Rapid 22-26 Rapid large 22-26 Wok 22-34 Fish burner Special oval-shaped vessels 7.4 Electric elements 7.4.1 Turning on electric elements Hobs may be fitted with an electric element of various diameter. The electric elem ent is ...

  • Smeg CIR34AX3 - page 19

    Instructions for the user 21 WARNING When switching on the electric element for the first time, or if the electric element has not been used for a long time, to remove any humi dity from the insulating material it should be dr ied out by placing the electric ele ment on position 1 for 30 minutes. To use correctly remember to: • Switch the electri ...

  • Smeg CIR34AX3 - page 20

    Instructions for the user 22 8 CLEANING AND MAINTENANCE Before any intervention, disc onnect the power supply of the device. 8.1 Cleaning Clean the cooking top regul arly every time you use it, obviously after it has cooled. 8.1.1 Regular daily cleaning of the hob In order to clean an d preserve the surface, a lways use specific products only, whic ...

  • Smeg CIR34AX3 - page 21

    Instructions for the user 23 8.2.2 The electric element After use, to make sure that the surf aces are clean and lon g lasting, the electric element must be treated w ith specific cleaning pro ducts which are available on the market. This necessary operation pr events oxidisation (rust formation). 8.2.3 The cover Clean the glass or steel cover, whe ...

  • Smeg CIR34AX3 - page 22

    Instructions for the user 24 9 PROBLEMS AND CAUSES Each of the following cases is caused by an abnormal operation of the appliance and shoul d be dealt with by a authorised pers ons: please contact your local dealer or Service Center in case yo u detect any of these malfunctioning. PROBLEM CAUSE WHAT TO DO The flame is very lo ng with bright yellow ...

  • Smeg CIR34AX3 - page 23

    ...

  • Smeg CIR34AX3 - page 24

    914773237/ B ...

メーカー Smeg カテゴリー Cooktop

Smeg CIR34AX3のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- CIR34AX3の取扱説明書
- Smegの製品カード
- パンフレット
- またはSmeg CIR34AX3の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Smeg CIR34AX3の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Smeg CIR34AX3の取り付け説明書、サービスマニュアル、簡易説明書、またはSmeg CIR34AX3のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Smeg CIR34AX3の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Smeg CIR34AX3デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがSmeg CIR34AX3を使用するのを助ける技術的文書のことです。説明書は通常、全てのSmeg CIR34AX3ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Smegの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Smeg CIR34AX3の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははSmeg CIR34AX3の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Smeg CIR34AX3に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Smeg CIR34AX3デバイスの基本機能を使うにあたってのヒント。 Smeg CIR34AX3のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Smeg CIR34AX3に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるSmeg CIR34AX3のメーカー/サービスへの連絡先に関する情報。

Smeg CIR34AX3についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもSmeg CIR34AX3の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがSmeg CIR34AX3で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)