-
Emerson CF2455ORB00 - page 1
READ AND SA VE THESE INSTRUCTIONS Part No. F40BP73370000 Form No. BP7337 U.L. Model No.: CF2455 Model No. CF2455BS00 CF2455ORB00 CF2455PW00 ODYSSEY ® Net W eight: 26.0 Lbs. 54” Ceiling Fan Owner's Manual ...
-
Emerson CF2455ORB00 - page 2
2 W ARNING ! WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference 2 . Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on a ...
-
Emerson CF2455ORB00 - page 3
7. Seven wire connectors 8. Three 8-32 x 3/8" phillips head screws 9. One hairpin clip 10. One clevis pin 11. Two knurled knob screws 1 2 . Twenty-one 10-32 x 3/8" pan head screws 13. One jumper assembly NOTE: Place the parts from the loose parts bags in small containers to keep them from being lost. If any parts are missing, contact your ...
-
Emerson CF2455ORB00 - page 4
1. Position the fan motor and housing assembly in the lower styrofoam packing so that the top for the motor is facing you. 2. Obtain the hanger ball/downrod assembly and remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the pin from the downrod, then remove the hanger ...
-
Emerson CF2455ORB00 - page 5
5 6. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 2). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curv ...
-
Emerson CF2455ORB00 - page 6
6 12. Position the center styrofoam section on the upper section, and then position the fan motor and housing on the center section so that the bottom of the motor is facing you (Figure 5). The styrofoam sections will hold the assembly while you perform the following steps. 13. Using the 3/16” setscrew wrench (supplied), loosen the setscrew in th ...
-
Emerson CF2455ORB00 - page 7
7 The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support”. W ARNING ! Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securel ...
-
Emerson CF2455ORB00 - page 8
OUTLET BOX BLACK SUPPL Y WIRE BLACK/WHITE RECEIVER WIRE BLACK F AN WIRE BLUE F AN WIRE BLUE RECEIVER WIRE YELLOW F AN WIRE YELLOW RECEIVER WIRE CEILING COVER WHITE RECEIVER WIRE WHITE F AN WIRE WIRE CONNECTOR RECEIVER WHITE SUPPL Y WIRE SUPPL Y GROUND WIRE (GREEN OR BARE) HANGER BALL GROUND WIRE (GREEN) HANGER BRACKET GROUND WIRE (GREEN) HANGER BRA ...
-
Emerson CF2455ORB00 - page 9
9 1-1/4" THREADED STUDS (2) HANGER BRACKET OUTLET BOX RECEIVER CEILING COVER Figure 16 BLUE RECEIVER WIRE YELLOW RECEIVER WIRE BLUE F AN WIRE DOWNROD BLACK F AN WIRE SW105 RECEIVER WHITE F AN WIRE WHITE RECEIVER WIRE BLACK RECEIVER WIRE YELLOW F AN WIRE BLACK/WHITE RECEIVER WIRE BLACK SUPPL Y WIRE WHITE SUPPL Y WIRE Check to see that all conne ...
-
Emerson CF2455ORB00 - page 10
5. Obtain the die cast glass holders and light kit glass from the protective bags. 6. Position the light kit glass carefully on a convenient surface with the open side face down. 7. Remove the protective cover from the adhesive backed material on the glass holders (Figure 18). 8. Firmly press the die cast glass holders into position on the light ki ...
-
Emerson CF2455ORB00 - page 11
The SW116 wall control transmits the command signals via radio waves to the SW105 receiver installed in the ceiling fan ceiling cover. The SW105 receiver is required for the SW116 wall control to function. Power for the SW116 wall control comes from the 12V battery, located in the wall control. Replacement 12V batteries recommended are Duracell MN2 ...
-
Emerson CF2455ORB00 - page 12
Operating Y our Ceiling Fan IMPORT ANT Fan installation must be completed, including the installation of the fan blades, before testing of the remote control. Your SW116 Fan/Light Wall Control (Figure 25) has full control of your fan, lights, and airflow direction. 1. To set the desired fan speed, push the HI, MED, or LOW buttons to operate your fa ...
-
Emerson CF2455ORB00 - page 13
13 T r ouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers. WARNING: Make sure main power is turned off. 2. Loose power line connections to the fan. 2. Check line wire connections to fan 3. Fan/Light Wall Control is OFF. 3. Turn ON ...
-
Emerson CF2455ORB00 - page 14
14 4 2 1 3 5 6 7 10 3 11 25 8 7 31 30 29 15 15 20 21 22 23 24 28 27 12 13 14 8 26 9 HI MED LOW FAN OFF REV EMERSON D/L U/L 17 16 18 17 19 Repair Par ts ...
-
Emerson CF2455ORB00 - page 15
15 Repair Par ts Listing Key Model No. N o . Description CF2455BS00 CF2455ORB00 CF2455PW00 1 Bracket Assembly, Hanger 760732 760732 760732 2 Hanger ball/downrod Assembly 761632-17 761632-37 761632-23 4 Cover, Ceiling 761795-3 761795-8 761795-6 9 Capacitor, Auxiliary 761453 761453 761453 10 Cover, Motor Coupling 761621-15 761621-25 761621-21 14 Moto ...
-
Emerson CF2455ORB00 - page 16
Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant ¥ St. Louis, MO 63136 Printed in China 11/06 Part No. F40BP73370000 Form No. BP7337 LIMITED W ARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson Electric Co. ceiling fan against all defects in workmanship ...
Emerson CF2455ORB00についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもEmerson CF2455ORB00の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがEmerson CF2455ORB00で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。