-
Haier HDY-M40 - page 1
HDY -M60 Start HDY-M60 OFF 20 min 60 min 100 min 150 min 200 min OFF 60 min 30 min Cool Warm Please read this manual carefully before operating your dryer . Retain this for future reference. Record the model and serial number of the tumble dryer . Please have this information ready for any service related enquiries. HDY-M40 0180500410 ...
-
Haier HDY-M40 - page 2
4 9 RACK FITTING INSTRUCTION . . . . . . . . . . . . . . . . . . . . . . . . . 12 4 14 1 14 WIRING CIRCUIT. . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . .14 IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . 1 Date Purchased: Store Purchased from: Serial No.: ...
-
Haier HDY-M40 - page 3
1 Re ad al l in str uc tio ns b ef ore u si ng th is d rye r . 2 The interior of the dryer should be cleaned periodically by qualified ser vice personnel. An excessive amount of lint build up in the interior of the dryer could result in inef ficient dr ying and pose a possible fire hazard. 3 T h e a p p l i a n c e m u s t no t be i n s t a ll ed b ...
-
Haier HDY-M40 - page 4
2 15 Do n ot dry u nwas hed it ems in t he tu mble d ryer . 16 Fab ric so ften ers, or si mi lar pr odu cts , sh ould b e us ed a s sp ecif ie d by t he f abri c soft ene r inst ruc tion s. 17 To prev ent fir e, d o no t u se h eat to d ry i tems c on tai ning pl ast ic , f oam rub ber or simi lar ly tex ture d rubb er-l ike ma teri als , or it em ...
-
Haier HDY-M40 - page 5
Start HDY-M60 OFF 20 min 60 min 100 min 150 min 200 min OFF 60 min 30 min Cool Warm Read all instructions before using this dryer . This dryer has been designed for domestic use only . SA VE THESE INSTRUCTIONS. Control panel Adjustable outlet grill and lint filter Power supply cord Model number and Serial number Back plate Door Air intake grill 3 P ...
-
Haier HDY-M40 - page 6
Turning on power Before turning on the power of the dryer check whether the supply voltage is in accordance with the value indicated on the name plate. f Preparation of laundry load - The dryer can only dry laundry which has been spun dry. Do not put in laundry which is still dripping wet or has excess water. - Make sure all pockets are empty befor ...
-
Haier HDY-M40 - page 7
1. Power up Insert the power plug into an appropriate power outlet that is properly installed and grounded. Operating power supply: 220-240V~50Hz. 2. Laundry loading Open the door and load the laundry into the drum of the dryer . For a more energy efficient and better drying result, make sure the load has been spun dried. Loosen 3.Setting drying ti ...
-
Haier HDY-M40 - page 8
6 Dryer timer: The timer will let you set the time for up to 200 minutes to dry your clothes depending on the load of the clothes. This dryer has two program types. The light blue colour is the cool air cycle and the orange is the warm air cycle. During the cool air cycle the heater does not come on and the clothes are dried by cool air. During the ...
-
Haier HDY-M40 - page 9
Cleaning the surface Wipe off any dust or dirt. Cleaning the filter screen T o ensure good ventilation effect during drying, the filter screen must be cleaned before or after each use. 1. Remove the filter Gently push together the clip on the filter screen and then pull out towards yourself. 2. Cleaning the filter Remove the lint with a soft brush ...
-
Haier HDY-M40 - page 10
Remove the transport packaging (fig.1) and remove the dryer rack from the top packaging (fig.2). Remove the tape on the front (fig.3 and fig.4), the wall mounting kit attached to the drum with tape on the inside and the panel film, before starting the dryer . Packing accessories Check list of the accessories and materials provided with the machine: ...
-
Haier HDY-M40 - page 11
W ALL MOUNTING INSTRUCTIONS 1. Determine the location of the dryer on the wall and mark the bracket position. A minimum 50 mm is needed between the top of the dryer and the celling for ease of installation; If mounting above a washing machine, allow sufficient room to open the lid of the washer . 9 T ools required: For plaster/ Drill&3mm Bit 1 ...
-
Haier HDY-M40 - page 12
W ALL MOUNTING INSTRUCTIONS 3. I nstall the hooks to the dryer , in the inverted position, remove the 2 screws and 2 plastic plugs as indicated in Fig.1 . 4. Align the hooks as shown in Fig.2 and refit screws tightly. Install the spacers provided as Fig.2. 10 plastic plugs 2 hooks 3 screws 2 spacers ...
-
Haier HDY-M40 - page 13
W ALL MOUNTING INSTRUCTIONS 5. With assistance, mount dryer on wall brackets. See Fig. 3 6. A second control panel with inverted symbols is supplied. Peel the release paper from the back of inverted film then place new control panel film on the surface so that the writing is the correct way around. 1 1 Caution: Plug must be accessble after installa ...
-
Haier HDY-M40 - page 14
DRYING RACK FITTING INSTRUCTION DR YER FREE ST ANDING-UPRIGHT For ease of access, the rack is to be mounted near the dryer top. Firstly hold the rack horizontally with the two end projections pointing upwards and away from yourself. Position the rack near the top of the dryer and place the end of the right rack projection into the right cabinet mou ...
-
Haier HDY-M40 - page 15
RACK FITTING INSTRUCTION RACK STORAGE - DR YER INVERTED. T o hold the dryer rack out of the way when not in use, it will be necessary to attach the retaining clip to the base of your dryer . T o do this, firstly remove the screw located 4 cm from the right corner of the inverted dryer ( Fig.3). Then position the retaining clip over the hole so that ...
-
Haier HDY-M40 - page 16
14 The following must be confirmed before calling for service: Problem Possible Cause The dryer does not start The drying result is not good -Is the dryer plugged in? -Is the power on? -Is the door closed properly? -Has a drying program been set? -Was the correct drying program set? -Is the filter screen clean? -Did the amount of the loaded laundry ...
Haier HDY-M40についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもHaier HDY-M40の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがHaier HDY-M40で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。