-
Winegard RM-DM46 - page 1
1 ® RV DIGITAL SATELLITE SYSTEM with Digital Elevation Sensor Model RM-DM46 may also be packaged as RM-DM00, RMDM04, RMFLDM4 U.S. Patent Number 5,532,710 Made in U.S.A. Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www. winegard.com Printed in U.S.A. © Winegard Company 2002, 2005 245106 ...
-
Winegard RM-DM46 - page 2
2 DIRECTIONAL HANDLE RED SCREW ELEVATIING CRANK DIRECTIONAL HANDLE POIINTER DIRECTIONAL DIAL ROTATION CLAMP FIGURE 1 STEP 1. The more accurately you determine North, the easier it is to locate the satellite. Step outside and away from your vehicle. (Standing to near your vehicle can give incorrect compass readings.) It is helpful if there is a land ...
-
Winegard RM-DM46 - page 3
3 Tuning Antenna STEP 1 . Your receiver should indicate it is receiving a signal. To tune your antenna for the best signal strength. SLOWLY move the antenna left, then right, until you have found the position that gives the highest signal strength. It is important to turn the antenna slowly. Because the signal is digital, the receiver takes a few s ...
-
Winegard RM-DM46 - page 4
4 Trouble Shooting 1. You may need to roatate the dish in small increments to find the signal. Rotate the dish 3° at a time to the left, stopping for a few seconds each time you move the dish. Try moving the dish up to 20° to the left. If no signal is found, return to the azimuth listed and and try rotating 20° to the right. This will help corre ...
-
Winegard RM-DM46 - page 5
5 As se mb ly & In st al la ti on T h i n g s y ou n ee d — Screwdrivers (Phillips and slot) 1-3/4” hole saw 7/16” wrenc h ABS glue Drill with 1/8” bit Tape measure Non-hardening sealant (Check manufacturer’s specifications for compat ibility with yo ur roo f mater ial.) W i n e g a rd ’ s D i g i t al E le v a t i on S e n s o r h ...
-
Winegard RM-DM46 - page 6
6 Measure 24” of coax at plastic fastener on left side of feed arm. (See Step 5.) No cable clamps on this part of cable. Rotate clockwise to stop. STEP 3. Attach dish to backup. Use bolts and nuts provided, Figure 4. FIGURE 4 STEP 4. Mount dish on roof in upright position. Rotate clockwise to stop, Figure 5. Dish will be toward back of vehicle wh ...
-
Winegard RM-DM46 - page 7
7 THREADED ROD, WASHER AND NUT FIGURE 8 INSIDE RV Special instructions: For roof thickness greater than 6-1/2”. Parts Needed: (not included) RP-4400 14” worm gear for roof 3200369 Directional handle extension 2162031 Long threaded rod Instructions: STEP 8. Place nut on threaded rod. See Figure 8. STEP 9. Measure and cut the threaded rod with a ...
-
Winegard RM-DM46 - page 8
8 STEP 15. The directional handle and threaded rod will fit roofs up to 5-1/4” thick. If you are using wedges to compensate for roof/cceiling slope, be sure to allow for this extra thickness. You may add an extension to the directional handle for thicker roofs. Each extension will increase the length of the directional handle by 2-1/4”. Figure ...
-
Winegard RM-DM46 - page 9
9 CAUTION! After INITIAL INSTALLATION , the antenna SHOULD ROTATE APPROXIMATELY 360° FROM TRAVEL POSITION. The pointer on the DIRECTIONAL HANDLE should point towards the RED SCREW ON THE ROTATION CLAMP when in the TRAVEL POSITION. FIGURE 14 FIGURE 15 FIGURE 16 POINT TO BACK OF RV Pointer must point to RED SCREW at CENTER OF ROTATION CLAMP when in ...
-
Winegard RM-DM46 - page 10
10 Digital Elevation Sensor Interior Wallplate FIGURE 17 Based on 5 minutes a day of usage, standard new alkaline batteries should last 88 days. STEP 19. See Figure 17. If using the SM-1000 surface mount box, feed cable through hole in box. STEP 20. Connect wires coming from sensor on roof to wall plate display in vehicle. It is important to proper ...
-
Winegard RM-DM46 - page 11
11 Parts List ...
-
Winegard RM-DM46 - page 12
12 Parts List ...
-
Winegard RM-DM46 - page 13
13 Rev/6/11/01 Parts Views ...
-
Winegard RM-DM46 - page 14
14 Notes ...
-
Winegard RM-DM46 - page 15
15 Notes ...
-
Winegard RM-DM46 - page 16
16 ANTENNA & MOUNT Height when raised 30" verticle max. Height in the travel position 8" max. Operating radius17 " (34" diameter circle) Roof space required 26" LNB Compatible with DIRECTV ® , DISH Network TM , and ExpressVu (northern U.S. and Canada) Weight 12 lbs. Color Cool gray Antenna height 20.9" Antenna wid ...
-
Winegard RM-DM46 - page 17
17 TEMPLA TE ON NEXT P AGE ...
-
Winegard RM-DM46 - page 18
18 ALIGN BASE P AREA M “FR O POINT T O OF VE H 1-3/4” DIA. DRILL COMPLETEL Y THROUGH CEILING T empRM ...
-
Winegard RM-DM46 - page 19
19 WITH P LA TE M ARKED O NT” O FRONT H ICLE Roof T emplate 1/8” DRILL BIT 8 HOLES. DO NOT DRILL THROUGH CEILING . ...
Winegard RM-DM46についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもWinegard RM-DM46の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがWinegard RM-DM46で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。