Invacare 65420の取扱説明書

12ページ 0.25 mb
ダウンロード

ページに移動 of 12

Summary
  • Invacare 65420 - page 1

    SAFETY SUMMARY (CONTINUED) INSTALLATION WARNINGS SPRINT (65400) and SPARTAN (65420) MODELS - The rollator height can ONLY be adjusted where the push handle is textured (FIGURE 4). After installation and BEFORE use, ensure that ALL attaching hardware is securely tightened. REPLACING SPRINT CANES AND BRAKES (FIGURE 1) 1 . Remove the EXISTING brake wi ...

  • Invacare 65420 - page 2

    2 B. Remove the phillips screw securing the EXIST- ING hand brake to the push handle. C. Pull the EXISTING hand brake off of the push handle. NOTE: Remove clamps/hardware located at the end of the NEW brake wire before performing the following steps. 4 . Perform one (1) of the following: INST ALLING CANE KIT - Install NEW push handle. A . T urn the ...

  • Invacare 65420 - page 3

    3 Cable Adjuster Unit Locknut Cable Adjuster Unit Brake Cable Brake Phillips Screw Brake Wire Clamp Spring ASSEMBLED DISASSEMBLED Cable Adjuster Unit Locknut Cable Adjuster Unit Brake Cable Brake Phillips Screw Brake Wire Clamp Spring Brake Wire Hole REMOVING/INSTALLING BRAKE WIRE - STEPS 1 AND 6 Push Handle Tie Wrap Side Frame Brake Cable REMOVING ...

  • Invacare 65420 - page 4

    4 REPLACING SPARTAN CANES AND BRAKES Preparing Spartan for Brake Replacement (FIGURE 2) 1 . Perform one (1) of the following: INST ALLING BRAKE KIT (BEFORE 3/7/00) - Re- move EXISTING hand brake. A . Remove the hex bolt, washer and locknut secur- ing the hand brake to the push handle. B. Remove the hand brake. INST ALLING BRAKE KIT (AFTER 3/8/00) - ...

  • Invacare 65420 - page 5

    5 Replacing Spartan Brakes (FIGURE 4) 1 . Remove the brake pad. Refer to REMOVING/IN- ST ALLING THE SP AR T AN BRAKE P AD S in this pro- cedure of the instruction sheet. 2 . Remove the plunger assembly . Perform the following: A . Pry the plunger assembly out of the rollator leg with a flat screwdriver . 3 . Remove the EXISTING brake wire stop. Per ...

  • Invacare 65420 - page 6

    6 DISASSEMBLING/ASSEMBLING THE PLUNGER ASSEMBLY - STEPS 4 AND 7 FIGURE 4 - REPLACING SPARTAN CANES AND BRAKES - REPLACING SPARTAN BRAKES Insert Plunger Spring Brake Wire Brake Wire Stop Slot Opening Brake Wire Stop Flat Screwdriver Plunger Insert Lip Slot Opening REMOVING/SECURING THE BRAKE WIRE STOP - STEPS 3 AND 8 Plunger Assembly Rear Frame Flat ...

  • Invacare 65420 - page 7

    7 B. Remove the hand brake. C. T urn the adjustment lever COUNTERCLOCK- WISE. D. Insert push handles into side frames with the hand grip facing the back of the rollator . 3. Perform one (1) of the following: INST ALLING BRAKE KIT (BEFORE 3/7/00) - Install NEW hand brake. A . Position the handbrake assembly under the push handle so the lock button i ...

  • Invacare 65420 - page 8

    8 FIGURE 6 - ADJUSTING CABLE BRAKE HANDLE Cable Brake Handle Locknut Screw Mechanism Cable ADJUSTING SPRINT AND SPARTAN PUSH HANDLES (FIGURE 6) NOTE: For the most comfortable position, make sure the adjustment is performed while wearing the most frequently worn shoes. NOTE: COUNTERCLOCKWISE/CLOCKWISE di- rections are determined by standing behind t ...

  • Invacare 65420 - page 9

    9 Cable Adjuster Unit Locknut Cable Adjuster Unit Brake Cable Brake Phillips Screw Brake Clamp FIGURE 8 - ADJUSTING CABLE ADJUSTER UNIT - WHEEL ASSEMBLY - SPRINT ONLY Adjusting Cable Adjuster Unit - Wheel Assembly - MODEL 65400 ONLY (FIGURE 8 ) NOTE: Adjusting the cable adjuster unit will increase/ decrease the cable brake pressure on the wheels. N ...

  • Invacare 65420 - page 10

    10 REPLACING STINGRAY AND STARGAZER BRAKES (FIGURE 10) NOTE: COUNTERCLOCKWISE/CLOCKWISE direc- tions are determined by standing beside the rollator . 1 . Remove the EXISTING brake wire. Perform the fol- lowing: A . Loosen the hex screw securing the EXISTING brake wire to the brake. B. Loosen the caster housing nut. C. Pull EXISTING brake cable up t ...

  • Invacare 65420 - page 11

    ADJUSTING STINGRAY AND STARGAZER HAND BRAKES (FIGURE 10) Adjusting Hand Brake NOTE: COUNTERCLOCKWISE/CLOCKWISE direc- tions are determined by standing behind the rollator (us- ers position). 1 . Loosen the hand brake adjustment nut by turning CLOCKWISE. 2 . Perform one (1) of the following: A. Loosen hand brake tension - turn hand brake nut COUNTER ...

  • Invacare 65420 - page 12

    Invacare Corporation ww w .in vacare.com U S A Canada One In vacare W ay 5970 Chedworth W a y In vacare ® and "Y es, y ou can" are trademarks of In vacare Elyria, Ohio USA Mississauga, Ontario Corporation. 44036-2125 L5R 3T9, Canada © 2001 Invacare Corporation 800-333-6900 905-890-8838 Form No. 98-146 Part No. 1076198 Rev C (1) 1/01 Rem ...

メーカー Invacare カテゴリー Mobility Aid

Invacare 65420のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 65420の取扱説明書
- Invacareの製品カード
- パンフレット
- またはInvacare 65420の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Invacare 65420の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Invacare 65420の取り付け説明書、サービスマニュアル、簡易説明書、またはInvacare 65420のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Invacare 65420の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Invacare 65420デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがInvacare 65420を使用するのを助ける技術的文書のことです。説明書は通常、全てのInvacare 65420ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Invacareの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Invacare 65420の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははInvacare 65420の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Invacare 65420に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Invacare 65420デバイスの基本機能を使うにあたってのヒント。 Invacare 65420のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Invacare 65420に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるInvacare 65420のメーカー/サービスへの連絡先に関する情報。

Invacare 65420についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもInvacare 65420の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがInvacare 65420で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)