La Crosse Technology WS-7208Uの取扱説明書

22ページ 0.24 mb
ダウンロード

ページに移動 of 22

Summary
  • La Crosse Technology WS-7208U - page 1

    WS-7208U Wireless 433 MHz Weather Station Instruction Manual  ...

  • La Crosse Technology WS-7208U - page 2

    2 TABLE OF CONTENTS Topic Page Quick Setup 3-5 Inventory of Contents 6-7 Detailed Setup Guide Battery Installation 8 Setting the Time 9 Features Minimum and Maximum Temperatures 10 Resetting Minimum and Maximum Temperatures 11 Adding additional remote temperature sensors (optional) 12-13 Weather Forecast 14 Weather Icons 15-16 Tendency Arrow 17 Mou ...

  • La Crosse Technology WS-7208U - page 3

    3 QUICK SETUP Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor tem perature station and remote tem perature sensor 3 to 5 feet apart. 2. Batteries shoul d be out of both units for 10 minutes. 3. Place the batteries into the remote temperature sensor first then into the indoor tem perature station. (All ...

  • La Crosse Technology WS-7208U - page 4

    4 display will show both the indoor temperature and an outdoor temperature. If the indoor tem perature station does not display bot h temperat ures after the 10 minutes please retry the set up as stated above. After both i ndoor and outdoor tem peratures are displaye d for 10 minutes you can place your rem ote temperature sensor out doors and set y ...

  • La Crosse Technology WS-7208U - page 5

    5 NOTE: Fog and mist will not harm your remote t emperature sensor but direct rain must be avoided. To complet e the set up of your indoor temperature station after the 10 minutes have passed please follow the steps in the detailed set up guide on page 8-9. INVENTORY OF CONTENTS 1. The indoor weather station (Figure 1) 2. The remote temperature sen ...

  • La Crosse Technology WS-7208U - page 6

    6 ADDITIONAL EQUIPMENT (not included) 1. 1 Philips screwdriver. 2. 2 Fresh AA Alkaline batteries. 3. 2 Fresh AA Alkaline batteries DETAILED SETUP GUIDE Battery Installation Figure 2 Holder Figure 1  ...

  • La Crosse Technology WS-7208U - page 7

    7 1. Install 2 AA batteries in the remote temperature sensor. Make sure they do not spring free, or start-up problems may occur. 2. Install 2 AA batteries in the indoor weather station. Do not press any buttons for at least ten minutes. Setting the time 1. Press and hold the “SET” key for 4 seconds. 2. The hour will flash. 3. Press and release ...

  • La Crosse Technology WS-7208U - page 8

    8 6. Press and release the “+” key to advance the minutes. 7. Press and release the “SET” key to exit programming. FEATURES Minimum and Maximum Temperatures 1. Press and release the “ MIN/MAX” button, “MAX” appears between the indoor and remote temperatures. 2. The recorded maximum indoor and remote temperature is displayed. 3. Pres ...

  • La Crosse Technology WS-7208U - page 9

    9 while viewing the minimum or maximum tempera t ure s. Resetting Min and Max Te mpe r atur e s To reset both t he mi ni mum a n d ma xi mum temperatures—press and hold the “MIN/MAX” button for 5 seconds. Adding Additional Remote Temperature Sensors (optional) The WS-7208U is able to receive signals from 3 different remote temperature sensors ...

  • La Crosse Technology WS-7208U - page 10

    10 on its LCD, and the TX3UP will monitor the temperature of water or soil via a probe. When setting up multiple remote temperature sensors, it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temperature sensors. Second insta ll batteries into the indoor weather station a ...

  • La Crosse Technology WS-7208U - page 11

    11 over time. The WS-7208UF averages pas t air-pressure readings to provide an accurate forecast, creating a necessity to disregard all weather forecasting for 12-24 hours after the unit has been set-up, reset, or moved from one altitude to another (i.e. from one floor of a building to another floor). In areas where the weather is not affected by t ...

  • La Crosse Technology WS-7208U - page 12

    12 Sunny —indicates that the weather is expected to improve (not that the weather will be sunny). Sun with Clouds — indicates that the weather is expected to be fair (not that the weather will be sunny with clouds). Clouds with Rain — indicates that the weather is expected to get worse (not that the weather will be rainy). The weather icons c ...

  • La Crosse Technology WS-7208U - page 13

    13 occur quickly. If the symbols do not change then the weather has not changed, or the change has been slow and gradual. Weather Tendency Arrows Other possible displays in the FORECAST LCD are 2 weather tendency arrows, one that points up (on the left side of the LCD) and one that points down (on the right side of the LCD). These arrows reflect cu ...

  • La Crosse Technology WS-7208U - page 14

    14 The sending range is 80ft; obstacles such as walls, concrete, and large metal objects will reduce the range. Place both units in their desired location before permanently mounting. Remote Temperature Sensor Remove the mounting bracket from the remote temperature sensor. Mount the bracket in the desired location with either screws or adhesive tap ...

  • La Crosse Technology WS-7208U - page 15

    15 Using the integrated hanging hole on the back of the unit, slip indoor weather station over the screw and pull down to secure. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www.lacrossetechnology.com Problem: The LCD is faint Solution: Replace batteries Problem: No o ...

  • La Crosse Technology WS-7208U - page 16

    16 straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to each other. Solution: Each temperature sensor is manufactured to be accurate to within 1 degree plus or minus and under normal conditions, so two sensors could be as much as 2 degrees different. However, the di ...

  • La Crosse Technology WS-7208U - page 17

    17 is difficult to compensate for the above factors and obtain an accurate comparison. MAINTENANCE AND CARE INSTRUCTIONS • Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. • Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings ...

  • La Crosse Technology WS-7208U - page 18

    18 SPECIFICATIONS Transmitting Frequency 433MHz Measuring Temperatures Indoor Weather Station 32 ° F to 156.2 ° F with 0.2 ° F resolution (0 ° C to 69.0 ° C with 0.1 ° C resolution) Remote Temperature Sensor -21.8 ° F to 156.2 ° F with 0.2 ° F resolution (-29.9 ° C to 69.0 ° C with 0.1 ° C resolution) Temp accuracy +/- 1 ° F (+/- .5 ° ...

  • La Crosse Technology WS-7208U - page 19

    19 Indoor Weather Station 2 x AA, 1.5V Dimensions: (L x W x H) Indoor Weather Station 2.90 x 1.05 x 6.20 in. Remote Temperature Sensor 1.57 x 0.85 x 5.00 in. Battery life Approximately 1 year WARRANTY INFORMATION La Crosse Technology provides a 1-year warr anty on this indoor weather station. Contact La Crosse Technology im mediately upon discovery ...

  • La Crosse Technology WS-7208U - page 20

    20 batteries, or the indoor weather stations inability to receive a signal due to any source of interference. LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS INDOOR WEATHER STATION. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSE ...

  • La Crosse Technology WS-7208U - page 21

    21 e-mail: support@lacrossetechnology.com (warranty work) sales@lacrossetechnology.com (information on other products) web: www.lacross ete chnology.com FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harm ful interference, and (2) th is device mu ...

  • La Crosse Technology WS-7208U - page 22

    22 FCC ID: OMO-01RX (Receiver), OMO-01TX (transmitter) THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. ...

メーカー La Crosse Technology カテゴリー Portable Radio

La Crosse Technology WS-7208Uのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- WS-7208Uの取扱説明書
- La Crosse Technologyの製品カード
- パンフレット
- またはLa Crosse Technology WS-7208Uの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、La Crosse Technology WS-7208Uの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、La Crosse Technology WS-7208Uの取り付け説明書、サービスマニュアル、簡易説明書、またはLa Crosse Technology WS-7208Uのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、La Crosse Technology WS-7208Uの製品を使用するにあたって最も人気のある説明書を閲覧できます。

La Crosse Technology WS-7208Uデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがLa Crosse Technology WS-7208Uを使用するのを助ける技術的文書のことです。説明書は通常、全てのLa Crosse Technology WS-7208Uユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

La Crosse Technologyの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. La Crosse Technology WS-7208Uの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははLa Crosse Technology WS-7208Uの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。La Crosse Technology WS-7208Uに関してこのドキュメントで見つけることができる全てのヒントの目次
3. La Crosse Technology WS-7208Uデバイスの基本機能を使うにあたってのヒント。 La Crosse Technology WS-7208Uのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。La Crosse Technology WS-7208Uに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるLa Crosse Technology WS-7208Uのメーカー/サービスへの連絡先に関する情報。

La Crosse Technology WS-7208Uについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもLa Crosse Technology WS-7208Uの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがLa Crosse Technology WS-7208Uで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)